Inhaltszusammenfassung zur Seite Nr. 1
Rearview Mirror with 4" Color LCD Monitor
and Camera Package
Model: RVMPKG4 (V2.0)
Installation Manual
Features:
• Rearview Mirror with 4" LCD Monitor
• Built-In Speaker
• Rearview Camera Input
• Auxiliary Video Input
• Automatically Displays Backup Camera Image
• Camera
Inhaltszusammenfassung zur Seite Nr. 2
Warnings The product is intended to assist in safe driving and to allow the driver to have a broader rearview while in reverse. You as the driver, are solely responsible for the safe operation of your vehicle and the safety of your passengers according to the country and their local traffic regulations. Do not use any features of this system to the extent it distracts you from safe driving. Your first priority while driving should always be the safe operation of your vehicle. Audiovox
Inhaltszusammenfassung zur Seite Nr. 3
TABLE OF CONTENTS Warnings 1 Product description 3 Packing list 3 Installation Instructions 4 1. Signal Input 5 2. Control and Indicator 6 3. Auxiliary Input Switch 7 Specifications 7 Maintenance 8 Troubleshooting 9 Illustration of connections
Inhaltszusammenfassung zur Seite Nr. 4
Product Description There is a blind spot that exists at the back of a vehicle while the vehicle is in reverse. Equipped with a camera, this electronic rearview mirror provides the driver with a clear and wide image of the area behind the vehicle whenever the vehicle is shifted into reverse. Backing up vehicle Do not back up vehicle while watching the mirror/monitor screen. Always look in the direction of vehicle motion. Use the mirror/monitor as an aid in safety confirmation. The ac
Inhaltszusammenfassung zur Seite Nr. 5
Rear View CMOS1 Camera 5 Parts list included with camera installation manual 6 Camera Cable 1. Installation Instructions (1) Mount the mirror/monitor a). Take the two belts and slide them into the slots on the top rear of the mirror with the grooved side of the belt facing down. Figure 1 b). Take the buckles and slide them into the lower slots on the rear of the mirror with the buckle facing down toward the strap. NOTE: The large open rectangle on the buc
Inhaltszusammenfassung zur Seite Nr. 6
d). Trim off excess length of the straps. e). Place (hide) the monitor cable behind the windshield trim piece down under the dash area. (2) Wiring the Monitor a) RED FUSED WIRE: 12VDC ACCESSORY SOURCE Connect this wire to a source that has 12 volts when the Ignition key switch is turned on, and 0 volts when the Ignition key switch is turned off. b) BLACK WIRE: CHASSIS GROUND Connect this wire to a solid, metal part of the vehicle’s chassis. c) PINK WIRE: GROUND WHEN PARKING BRA
Inhaltszusammenfassung zur Seite Nr. 7
Figure 4 3. Controls and Indicators Figure 5 Figure 5 illustrates the controls and indicators of the RVMPKG4(V2.0) rear view mirror: A: Rearview mirror B: 4" LCD panel C: Brightness control knob D: Power indication (Red when ignition is on) 6
Inhaltszusammenfassung zur Seite Nr. 8
E: Speaker volume control F: Auxiliary input switch (see below) G: Speaker in rear of mirror Auxiliary Input Switch: nd Auxiliary input switch: To access the 2 A/V input press the switch. Note: nd The parking brake must be engaged in order to view the 2 input. Specification General Power Supply DC 12V Power Consumption 10W Current Draw 500mA Video Input/Output 1Vp-p/75 Impedance Audio Input <=500mV Audi
Inhaltszusammenfassung zur Seite Nr. 9
Maintenance Though your Rearview mirror requires little care, you can still maintain its condition and performance following the procedures below. • Keep your system away from excessive moisture, extreme heat or cold and magnetic fields. • Keep liquids away from the display mirror. • To avoid damage, do not place auxiliary devices or other objects on the top of the mirror. • Occasionally clean the surface of the mirror with soft cloth moistened with water or window cleane
Inhaltszusammenfassung zur Seite Nr. 10
Troubleshooting Symptoms Solutions 1. Check the installation-wiring diagram. The ON/OFF signal light 2. Ensure that the parallel red and black line is not on after the car is from the control box is connected started? properly. 1. Check the LCD Contrast (Brightness) control knob whether the contrast knob is set too low No video signal appears 2. Check the rearview Camera lens. 3. Check the rearview Camera wiring and while reversing the car? connection. 4. Check the ca
Inhaltszusammenfassung zur Seite Nr. 11
Illustration of Connections Refer to CMOS1 camera installation manual Parts list included with camera 10
Inhaltszusammenfassung zur Seite Nr. 12
© 2007 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 11
