Bedienungsanleitung Acura Music Link bii32726-34939

Inhaltszusammenfassung zur Seite Nr. 1

Accessory Application Publications No.
BII 32726-34939
INSTALLATION
ACURA MUSIC LINK
2007 MDX Issue Date
®
(FOR iPod )
INSTRUCTIONS
MARCH 2007
PARTS LIST Acura Music Link Kit (sold separately)
P/N 08A28-1H2-101
Attachment Kit (sold separately)
P/N 08A28-1H1-800
Acura Music Link unit
4 Cushion tapes
Bus cable
Holder cushion
Grommet
Music Link harness
8 Wire ties
CD-ROM
(for home computer use only)
2 Long wire ties
Quick reference guide
Y-Harness Adapter (sold separately)
P/N 08A31-0F1-000
Y-harne

Inhaltszusammenfassung zur Seite Nr. 2

3. Remove the passenger's side under cover (five TOOL AND SUPPLIES REQUIRED clips, and release the two pins and two vehicle #2 Phillips screwdriver connectors). Flat-tip screwdriver Ratchet VEHICLE 10 mm Socket CONNECTORS (2) 10 mm Combination wrench Tape measure Felt-tip pen Isopropyl alcohol Shop towel CLIPS (5) Masking tape Illustration of the Acura Music Link Installed on the Vehicle ACURA MUSIC BUS LINK UNIT CABLE MUSIC LINK HARNESS PASSENGER'S SIDE UNDER 5N14011S PINS (2) COVER 4. Open the

Inhaltszusammenfassung zur Seite Nr. 3

5. Remove the right side dashboard cover (four 7. Using a flat-tip screwdriver and a shop towel, retaining tabs). remove the driver's side center trim (five clips and three retaining tabs). RETAINING TABS (2) SHOP FLAT-TIP TOWEL SCREWDRIVER CLIPS (5) DRIVER'S RETAINING SIDE CENTER TABS (2) TRIM RIGHT SIDE 5N14051S 5N14030S DASHBOARD RETAINING COVER TABS (3) 6. Remove the right dashboard trim (one self-tapping 8. Remove the center panel lower trim (two clips). screw, ten clips, and three retainin

Inhaltszusammenfassung zur Seite Nr. 4

9. Attach four pieces of masking tape to protect the 12. Insert the Acura Music Link unit into the holder center console in the area shown. cushion. VEHICLE ACURA CONNECTORS (9) MUSIC LINK UNIT BOLTS (4) HOLDER CUSHION AUDIO UNIT 6905090B Align ends. 5N14071S CENTER MASKING TAPE CONSOLE 13. Plug the bus cable DIN connector (black) and the Music Link harness DIN connector (white) into the 10. Remove the audio unit (four bolts). Pull the audio Music Link unit. unit out and unplug the nine vehicle

Inhaltszusammenfassung zur Seite Nr. 5

14. Secure the Acura Music Link unit to the steering 17. Using isopropyl alcohol on a shop towel, clean the hanger beam with two long wire ties as shown. area where the cushion tape will attach. ACURA VEHICLE MUSIC LINK AUDIO UNIT LONG WIRE MUSIC LINK HARNESS WIRE TIE HARNESS UNIT Align the mark OPENING TIES WIRE TIE made in step 11 with the wire tie. BUS CUSHION CABLE TAPE LONG FRONT WIRE TIE STEERING HANGER BEAM VEHICLE BRACKET (Clean with ACURA MUSIC LINK UNIT 6411010S 5N15051S isopropyl alco

Inhaltszusammenfassung zur Seite Nr. 6

20. Bundle up the excess Music Link harness, and 22. Make the length of the Y-harness adapter 14-pin secure it to the vehicle harness with one wire tie. connector the same length as the vehicle connectors. Bundle up the excess length of bus cable, and secure it to the vehicle harness with VEHICLE WIRE TIE three wire ties. HARNESS VEHICLE HARNESS BUS CABLE WIRE TIE WIRE (Bundle up.) TIES MUSIC LINK HARNESS 6411020S (Bundle up.) Y-HARNESS (Align.) ADAPTER 14-PIN VEHICLE 21. Get the Y-harness adapt

Inhaltszusammenfassung zur Seite Nr. 7

24. Reinstall the damper rod and cover. Be careful not to pinch the Music Link harness when closing the glove box. DAMPER ROD COVER 6411060S MUSIC LINK GLOVE BOX HARNESS 25. Check that all wire harnesses are routed properly and all connectors are plugged in. 26. Reinstall all removed parts. Check that all clips and other fasteners are installed securely. 27. Reconnect the negative cable to the battery. 28. Enter the client's audio and navigation system (if equipped) anti-theft code. Then reset t