Inhaltszusammenfassung zur Seite Nr. 1
LT-32/26A61BJ/SJ / LCT1999-001A-U / All Cover
LT-32&26A61BJSJ_Eng.book Page 1 Friday, October 14, 2005 1:40 PM
LT-32A61BJ
LT-32A61SJ
LT-26A61BJ
LT-26A61SJ
INSTRUCTIONS
WIDE LCD PANEL TV
Cover01
Inhaltszusammenfassung zur Seite Nr. 2
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 2 Friday, October 14, 2005 1:40 PM Warning DO NOT cut off the mains plug from this As these colours may not correspond with the equipment. If the plug fitted is not suitable coloured marking identifying the terminals in for the power points in your home or the cable your plug proceed as follows: is too short to reach a power point, then obtain The wire which is coloured blue must be an appropriate safety approved e
Inhaltszusammenfassung zur Seite Nr. 3
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 1 Friday, October 14, 2005 1:40 PM Thank you for buying this JVC LCD flat television. To make sure you understand how to use your new TV, please read this manual thoroughly before you begin. (“LCD” stands for Liquid Crystal Display.) WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING • The TV may fall causing injuries. Hold the bottom of the stand with your hand and ti
Inhaltszusammenfassung zur Seite Nr. 4
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 2 Friday, October 14, 2005 1:40 PM Failure to take the following precautions may cause damage to the television or remote control. DO NOT block the TV’s ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.) DO NOT place anything on top of the TV. (such as cosmetics or medicines, flower vases, potted plants, cups, etc.) DO N
Inhaltszusammenfassung zur Seite Nr. 5
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 3 Friday, October 14, 2005 1:40 PM CONTENTS Setting up your TV ...................................4 PICTURE menu ...................................... 25 Installation.................................................. 4 PICTURE MODE...................................... 25 Using the stand.......................................... 4 BRIGHT-1 ................................................ 25 Removing the terminal cover
Inhaltszusammenfassung zur Seite Nr. 6
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 4 Friday, October 14, 2005 1:40 PM Setting up your TV • When you install the TV on the wall, only use a JVC wall mounting unit (optional) which is designed for this TV. • Make sure that the TV is installed on the wall by a skilled installer. Installation Cautions for installation • Install the TV in a corner on a wall or on the floor so as to keep cords out of the way. • The TV will generate a slight amount of heat dur
Inhaltszusammenfassung zur Seite Nr. 7
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 5 Friday, October 14, 2005 1:40 PM Setting up your TV Removing the terminal cover There are connection terminals behind the cover on the rear of the TV. Remove the cover before connecting an antenna or VCR. Remove the cover by removing the hooks. When replacing the cover, place the side of the cover against the TV and insert the hooks. • Leave the cover off if they do not fit properly. Do not force to replace the cove
Inhaltszusammenfassung zur Seite Nr. 8
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 6 Friday, October 14, 2005 1:40 PM Setting up your TV Connecting the aerial and video cassette recorder (VCR) • The connecting cables are not provided. • For further details, refer to the manuals provided with the devices to be connected. Caution • Turn off all the equipment including the TV before connecting anything. If you are connecting a VCR, without terminal covers follow A → B → C in the diagram Aerial opposit
Inhaltszusammenfassung zur Seite Nr. 9
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 7 Friday, October 14, 2005 1:40 PM Setting up your TV Connecting the power cord to Initial settings the AC outlet When the TV is first turned on, it goes into the initial settings mode, and you will see the Insert the AC plug on the power cord from JVC logo. Follow the instructions on the the TV into an AC outlet. screen display to make the initial settings. Caution • Operate only from the power source # button spe
Inhaltszusammenfassung zur Seite Nr. 10
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 8 Friday, October 14, 2005 1:40 PM Setting up your TV • If the JVC logo does not appear this is 5 Press the 5 and 6 buttons to because your TV has already been choose the country where you are turned on for the first time: use the “LANGUAGE” and “AUTO 6 Press the blue button to start the PROGRAM” functions to make the AUTO PROGRAM function initial settings. For details, see “SET The AUTO PROGRAM menu appears UP
Inhaltszusammenfassung zur Seite Nr. 11
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 9 Friday, October 14, 2005 1:40 PM Setting up your TV 7 Press the a button to display the T-V LINK menu For users in the UK: If you have any problems setting up your T-V LINK new TV, please call the DOWNLOAD TV RECORDING DEVICE Helpline on 0870 330 5000. For users in the Republic of Ireland: If you have any problems setting up your EXIT new TV, please call the OK Helpline on 1890-582500. D0005-EN If you do n
Inhaltszusammenfassung zur Seite Nr. 12
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 10 Friday, October 14, 2005 1:40 PM Setting up your TV Downloading the data to VCR If “FEATURE NOT AVAILABLE” appears at the T-V LINK menu: You can transmit to the latest Programme Check the following three items. Then numbers (PR) data to a VCR with the T-V press the 2 button to retry data LINK function. transmission. Caution • Has a T-V LINK compatible VCR • This only works when a T-V LINK been connected to th
Inhaltszusammenfassung zur Seite Nr. 13
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 11 Friday, October 14, 2005 1:40 PM Setting up your TV Pre-set download You cannot carry out Direct Rec using your TV’s control. The VCR will automatically download the Generally, the VCR cannot record a TV registered data on the TV channels from the channel that it cannot receive properly on its TV. This means you do not need to set up the own tuner, even if you can view that TV program channels on your VCR man
Inhaltszusammenfassung zur Seite Nr. 14
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 12 Friday, October 14, 2005 1:40 PM TV buttons and functions Turn the TV on from standby mode Press the A button or the P p buttons to turn the TV on from standby mode. When the TV is turned on, the power lamp lights blue. To turn the TV off: Press the A button again. The power lamp goes off. Caution •The A button on the TV does not fully isolate the TV from the AC supply. If you are not going to use the TV for a
Inhaltszusammenfassung zur Seite Nr. 15
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 13 Friday, October 14, 2005 1:40 PM TV buttons and functions Adjust the volume Press the r (Volume) q buttons The volume level indicator appears. Using the Menu Use the MENU/OK button Refer to “Using the TV’s menu” (see page 24) for details of using the menu. 13
Inhaltszusammenfassung zur Seite Nr. 16
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 14 Friday, October 14, 2005 1:40 PM Remote control buttons and functions 1 Muting button 2 Number buttons 3 Information button 4c button 1 ~ 5i button 6b button ! 77 buttons 8g (Text) button 2 9p p buttons 0 VCR/DVD/Teletext control buttons -p buttons =d (Favourite) button ~# (Standby) button 3 @ ! VCR/TV/DVD switch # @G button 4 # Colour buttons 5 $H button %a button $ 6 ^b button % &r (Volume) q buttons 7 Turn the TV
Inhaltszusammenfassung zur Seite Nr. 17
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 15 Friday, October 14, 2005 1:40 PM Remote control buttons and functions • Since this TV is designed to make full use Choose a TV channel and of the resolution of the original video source, the motion may appear unnatural watch images from external when the video source is input with devices progressive-scanning component signals. If this happens, change the output setting Use the number buttons: of the connecte
Inhaltszusammenfassung zur Seite Nr. 18
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 16 Friday, October 14, 2005 1:40 PM Remote control buttons and functions Time display: Adjust the volume The current time of the teletext data is displayed. Press the r q buttons to adjust If the TV has not received a TV channel that the volume. has teletext programmes since it was turned The volume level indicator appears and the on, the time display is blank. To view the volume changes as you press the r q curr
Inhaltszusammenfassung zur Seite Nr. 19
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 17 Friday, October 14, 2005 1:40 PM Remote control buttons and functions 16:9 ZOOM: ZOOM function This zooms up the wide picture (16:9 aspect ratio) to the full screen. You can change the screen size according to the picture aspect ratio. Choose the optimum one from the following ZOOM modes. • The ZOOM mode is fixed at FULL when 16:9 ZOOM SUBTITLE: you are using the TV as a PC screen. This zooms up the wide picture
Inhaltszusammenfassung zur Seite Nr. 20
LT-32/26A61BJ/SJ / LCT1999-001A-U / English LT-32&26A61BJSJ_Eng.book Page 18 Friday, October 14, 2005 1:40 PM Remote control buttons and functions Adjusting the visible area of the MONO: Select the MONO mode, when you listen to picture the mono sound. If subtitles or the top (or bottom) of the You can enjoy the sound for a wider picture are cut off, you can adjust the visible audience similar to stereo sound. area of the picture manually. OFF: 1 Press the c button The 3D SOUND function s
