Inhaltszusammenfassung zur Seite Nr. 1
LCD DISPLAY MONITOR
INSTRUCTIONS
GM-H40L1G
LCT1942-001A
G GM-H40L1G_cover-f.indd 3 M-H40L1G_cover-f.indd 3 0 05.10.6 1:12:40 PM 5.10.6 1:12:40 PM
Inhaltszusammenfassung zur Seite Nr. 2
Safety Precautions FCC NOTICE CAUTION: Changes or modifi cations not approved by JVC could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
Inhaltszusammenfassung zur Seite Nr. 3
Unplug this product from the wall outlet and refer service to qualifi ed service personnel under the following conditions: a) When the power supply cord or plug is damaged. b) If liquid has been spilled, or objects have fallen on the product. c) If the product has been exposed to rain or water. d) If the product operated normally by following the operating instructions. Adjust only those controls that are covered by the Operation Manual, as an improper adjustment of controls may result in damag
Inhaltszusammenfassung zur Seite Nr. 4
Safety Precautions (cont.) 13 • Power-supply cords should be routed so that they are The product should be placed more than 30 cm (11 /16 not likely to be walked on or pinched by items placed inches) away from heat sources such as radiators, heat upon or against them. Pay particular attention to cords registers, stoves, and other products (including amplifi ers) at doors, plugs, receptacles, and the point where they that produce heat. exit from the product. • For added protection of this produ
Inhaltszusammenfassung zur Seite Nr. 5
Table of Contents Menu Operations .............................................. 17 Safety Precautions .............................................. 2 IMPORTANT SAFEGUARDS ........................................2 Menu Confi guration—MAIN MENU ................ 18 Parts Identifi cation ............................................. 6 Menu Confi guration—SET-UP MENU .............. 24 Front panel ......................................................................6 Setting the Power-on Lock ........
Inhaltszusammenfassung zur Seite Nr. 6
Parts Identifi cation Front panel Remote sensor: Point the front end of the remote control toward here. Eco sensor: Detects brightness of the room (see page 23). Self-diagnostic lamps: These lamps light/fl ash if something abnormal occurs with the monitor (see page 36). Power lamp: When the monitor is turned off : Unlit. When the monitor is turned on: Lights in green. When the monitor is in sleep mode: Flashes in orange. When the monitor is in standby mode: Lights in orange. Rear panel Input card
Inhaltszusammenfassung zur Seite Nr. 7
1 (Power) button: Turns the monitor on/off (see page 14). 2 INPUT button: Changes inputs (see page 14). 3 MENU button: Displays the main menu (see page 17). 4 5/∞ buttons: Selects an item on the menu (see page 17). 5 +/– buttons: Adjusts the volume level (see page 14). • When the menu is displayed, adjusts the value (see page 17). 6 SET-UP button: Displays the set-up menu (see page 17). AC IN terminal: Connect the supplied power cord (see page 13). POWER switch: I : Turns on the main power. (T
Inhaltszusammenfassung zur Seite Nr. 8
Parts Identifi cation (cont.) Remote control POWER OFF button POWER ON button Turns off the monitor (see page 14). Turns on the monitor (see page 14). ASPECT button SET-UP button Changes the aspect ratio (see page Displays the set-up menu (see page 15). 17). DISPLAY button MENU/EXIT button Displays the information of the Displays the main menu (see page current input (see page 15). 17). 5∞ 2 3 buttons Operates the menu (see page 17). PICTURE MODE buttons OK button Changes the picture mode (se
Inhaltszusammenfassung zur Seite Nr. 9
Installation Precautions • When installing the monitor, be sure to use a dedicated stand unit or wall mounting unit, depending on your particular case. Ask your dealer to install. • When installing the monitor in a special way (for example, installing it diagonally), consult your dealer. • Route the power cord and connection cables along the wall or fl oor corners to avoid walking on them. • For good heat dissipation, try to leave the following distance of space (minimum) around the monitor (see
Inhaltszusammenfassung zur Seite Nr. 10
Installation (cont.) Connecting external speakers You can connect commercial speakers of the following specifi cations to the EXT. SPEAKER terminal: • Impedance: Between 6 Ω and 8 Ω • Power handling capacity: More than 3 W Speakers Speakers (commercially available) (commercially available) Ferrite core (supplied) To reduce interference from the monitor on external equipment, attach the supplied ferrite cores near to the EXT. SPEAKER terminals on the rear panel of the monitor. CAUTION • Do not
Inhaltszusammenfassung zur Seite Nr. 11
Connections Available signals The following signals can be input to this monitor. Video signals Terminal Available signals VIDEO IN A terminals NTSC, PAL, SECAM, PAL60, NTSC4.43, PAL-M, PAL-N, BW (50 Hz/60 Hz) VIDEO IN B (RGB/ Component signals 480/60i, 576/50i, 480/60p, 576/50p, 720/60p, 720/50p, 1080/60i COMPO.) terminal (1035/60i)*, 1080/50i, 1080/24psF RGB signals 15 kHz/50 Hz, 15 kHz/60 Hz * Select an appropriate setting for High-Defi nition signal (see “1080/1035“ on page 23). Computer sig
Inhaltszusammenfassung zur Seite Nr. 12
Connections (cont.) CAUTION • Before making any connections, turn off all the equipment. • DO NOT connect the power cord until all connections are completed. • Use a cord whose plugs correctly match the terminals on this monitor and the equipment. • Plugs should be fi rmly inserted; poor connections could cause noise. • When unplugging a cord, be sure to grasp it’s plug and pull it out. • Refer also to the user manual of each piece of equipment. To external speakers (See page 10.) RL To stereo au
Inhaltszusammenfassung zur Seite Nr. 13
Connect the VIDEO IN A OUT terminal to the video input terminal of another monitor, etc. CAUTION • Since the IN terminal and OUT terminal are loop-through terminals, the devices connected to the OUT terminal should be correctly terminated. Otherwise, pictures become abnormally bright or the display screen gets aff ected abnormally. or RL To stereo audio To video output To S-video To audio To component To RGB output To digital output terminals terminal (BNC) output terminal output video output t
Inhaltszusammenfassung zur Seite Nr. 14
Daily Operations Turning on the main power I : Main power on ‡ : Main power off On the rear panel Turning on the monitor From the remote control: To turn off the monitor, press POWER OFF. On the main unit: Each time you press the button, the power turns on and off . Selecting an input From the remote control: On the main unit: Each time you press the button, the input changes. NOTE • When “QUICK CHANGE” is set to “INPUT A&B,” you can change Inputs A and B quickly (see “INPUT CONFIGURATION”
Inhaltszusammenfassung zur Seite Nr. 15
Changing the aspect ratio Each time you press the button, the aspect ratio changes as follows: REGULAR Displays at conventional 4:3 aspect ratio. FULL Enlarges the picture of 4:3 aspect ratio horizontally. • For the picture of 16:9 aspect ratio, the aspect ratio is not changed. ZOOM Enlarges the picture of 4:3 aspect ratio vertically and horizontally at the same ratio. PANORAMIC Enlarges the picture of 4:3 aspect ratio horizontally to the extent that the picture does not look abnormal.
Inhaltszusammenfassung zur Seite Nr. 16
Daily Operations (cont.) Selecting the picture mode DYNAMIC: Suitable for displaying documents for presentation. NORMAL: Displays the original picture. USER: You can adjust picture quality as you like (see “PICTURE SETTING” on page 19). NOTE • You can adjust the picture quality, such as brightness, for each picture mode. The setting you have made is stored (see “PICTURE SETTING” on page 19). Selecting the audio mode To listen to stereo sounds To listen to monaural sounds • The stereo soun
Inhaltszusammenfassung zur Seite Nr. 17
Menu Operations On the main menu and set-up menu, you can make various adjustments, such as picture quality, or initial settings of the monitor. • For the confi guration of the main menu and a detailed description of each item, see pages 18 to 23. • For the confi guration of the set-up menu and a detailed description of each item, see pages 24 to 30. From the remote control 1 Display the menu. SET-UP To display the main menu To display the set-up menu 2 Press 5 ∞ to select an item, then press
Inhaltszusammenfassung zur Seite Nr. 18
Menu Confi guration—MAIN MENU On the main menu, you can make various adjustments and settings for picture, screen, and audio. MENU MENU MAIN MENU PICTURE SETTING 1/2 :NORMAL PICTURE MODE PICTURE SETTING PICTURE MODE : NORMAL CONTRAST SIZE SETTING : +01 BRIGHT AUDIO SETTING : 00 CONTRAST :+01 CHROMA INPUT CONFIGURATION : –02 PHASE FUNCTION SETTING : 00 SHARPNESS LANGUAGE :ENGLISH : 00 BRIGHT :+01 BACK LIGHT : +10 COLOR TEMP. : HIGH :+01 sub menu CHROMA PHASE :+01 Select the menu language: English,
Inhaltszusammenfassung zur Seite Nr. 19
PICTURE SETTING Item To do Setting value PICTURE MODE Selects a picture mode you want (see “Selecting the picture mode” DYNAMIC, NORMAL, USER on page 16). CONTRAST Adjusts contrast of the picture. –20 += 00 += +20 BRIGHT Adjusts the brightness of the picture. –20 += 00 += +20 CHROMA Adjusts the color density of the picture (except for RGB and BW –20 += 00 += +20 (50 Hz/60 Hz) signals). PHASE Adjusts the color phase. –20 += 00 += +20 SHARPNESS Adjusts the outlines of the picture. –20 += 00 += +20
Inhaltszusammenfassung zur Seite Nr. 20
Menu Confi guration—MAIN MENU (cont.) MENU MENU *1 MAIN MENU AUDIO SETTING reset PICTURE SETTING SPEAKER SELECT : INT. SIZE SETTING MUTING : OFF Are you sure? AUDIO SETTING AUDIO : STEREO "YES" then key. INPUT CONFIGURATION reset "NO" then MENU key. FUNCTION SETTING LANGUAGE :ENGLISH *2 AUDIO SETTING LEVEL METER SETTING SPEAKER SELECT : INT. LEVEL METER ch :OFF MUTING : OFF BAR TYPE :3COLORS Select the menu language: AUDIO L ch. : 1ch BAR BRIGHTNESS :HIGH English, German, French, or AUDIO R ch.
