Inhaltszusammenfassung zur Seite Nr. 1
37 LCD TV
User Guide
MUTE POWER
TV/CATV PICTURE SWAP SOUND
TV VIDEO COMP. PC
WIDE PIP POP DIGEST
- + ZOOM WINDOW
DISP V-CHIP C.C. MTS
ATSC SET UP EPG C.C.
FAV- FAV+ FAV EDIT STILL
AUDIO
FOR ATSC DTV
MENU AUTO
CH+
VOL- ENTER VOL+
CH-
SLEEP SKIP
1 2 3
4 5 6
7 8 9
00 0 CH RTN
Introducing the LCD TV
Installing the LCD TV
Using the LCD TV
Inhaltszusammenfassung zur Seite Nr. 2
ENGLISH Federal Communications Commission Statement This equipment has been tested and found to comply with the limits of a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication
Inhaltszusammenfassung zur Seite Nr. 3
Warnings and Precautions To prevent any injuries, the following safety precautions should be observed in the installation, use, servicing and maintenance of this equipment. Before operating this equipment, please read this manual completely, and keep it nearby for future reference. This symbol is intended to alert the user to avoid the risk of electric shock. This equipment must not be disassembled by anyone except qualified service WARNING personnel. This symbol is intended to alert the user
Inhaltszusammenfassung zur Seite Nr. 4
ENGLISH ▪ Remove the plug from the wall outlet, if the equipment will not be used for a long period of time. ▪ Do not place, use or handle this equipment near water. ▪ Never expose the equipment to liquid, rain, or moisture. Seek for service if any of the above is spilled into the equipment. ▪ Do not expose the equipment to extreme temperature or to direct sunlight, as the equipment may heat up and suffer damage. ▪ Do not install the equipment near any heat sources such as radiators, heat r
Inhaltszusammenfassung zur Seite Nr. 5
Outdoor Antenna Safety Instructions If an outdoor antenna is connected, follow the precautions below: ▪ An outdoor antenna should not be located in any area where it could come in contact with overhead power lines, or any other electric light or power circuits. ▪ When installing an outdoor antenna system, extreme caution should be taken to prevent contact with power lines. Direct contact with power lines may be fatal and should be avoided at all costs. Section 810 of National Electrical Cod
Inhaltszusammenfassung zur Seite Nr. 6
ENGLISH CONTENTS Federal Communications Commission Statement Warnings and Precautions Important Safety Instructions ......................................................................................... 2 Antenna Safety Instructions ........................................................................................... 4 Chapter 1 Introducing the LCD TV Key Features ................................................................................................................. 7 Pa
Inhaltszusammenfassung zur Seite Nr. 7
6 Chapter 1 Introducing the LCD TV
Inhaltszusammenfassung zur Seite Nr. 8
ENGLISH Chapter 1 Introducing the LCD TV Key Features Various Audio/Video terminals for external equipment connection ▪ 2 composite A/V input terminal ▪ 1 set of composite A/V output terminals ▪ 2 S-VIDEO terminal ▪ 2 set of component Video input terminals ▪ 1 VGA/AUDIO input terminal ▪ 1 HDMI/AUDIO input terminal ▪ 4 sets of Audio input terminals High Definition Multimedia Interface (HDMI) ▪ High Definition Multimedia Interface (HDMI) is a small, user-friendly interconnect that can carry up to
Inhaltszusammenfassung zur Seite Nr. 9
Package Contents Make sure all of the following contents are included. If you are missing any items, please return this product to the original place of purchase. Warranty Card LCD TV Remote Control/AAA Batteries x 2 User Guide MUTE POWER TV/CATV PICTURE SWAP SOUND TV VIDEO COMP. PC WIDE PIP POP DIGEST - + ZOOM WINDOW DISP V-CHIP C.C. MTS ATSC SET UP EPG C.C. FAV- FAV+ FAV EDIT STILL AUDIO FOR ATSC DTV MENU AUTO CH+ VOL- ENTER VOL+ CH- SLEEP SKIP 1 2 3 4 5 6 7 8 9 00 0 CH RTN Power Cor
Inhaltszusammenfassung zur Seite Nr. 10
ENGLISH Setting Your LCD TV Use a supplied antenna cable to connect the VHF/UHF signal to the LCD TV’s ANT. terminal (refer to page14-17). Connect the AC power cord at the back of the TV and connect t the power cord to wall outlet. Insert the 2 batteries supplied in remote control. Step1 Slide the back cover up to open the battery compartment of the remote control. Step2 Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends of the batteries with the (+) and (
Inhaltszusammenfassung zur Seite Nr. 11
Your LCD TV Front/Side View and Controls LED The LED light indicates when the LCD TV is activated. IR Infrared Receiver MENU Press once to display the OSD (on screen display), press again to turn the OSD off. VOLUME▲▼ Adjusts the volume up and down. Selects the main-menu item and change values for items when in the OSD mode. SELECT▲▼ Scans up and down through channels. Selects sub- menu item when in the OSD mode. SOURCE Chooses from different input signal sources. Turns the LCD TV on and i
Inhaltszusammenfassung zur Seite Nr. 12
ENGLISH Rear View and Jacks ANT. NTSC Connects RF input from VHF/UHF antenna or cable. ANT. ATSC Connects RF input from VHF/UHF antenna or cable to receive high definition digital television. AV2/S-VIDEO2 IN Connects to the composite Video/S-VIDEO and Audio output jacks on external video equipment. AV Output Connects to the composite A/V intput jacks on external video equipment. AV1/S-VIDEO1 IN Connects to the composite Video/S-VIDEO and Audio output jacks on external video equipment. COMPONENT
Inhaltszusammenfassung zur Seite Nr. 13
Your Remote Control PICTURE SWAP Cycles through picture quality modes: Swaps between main and sub STANDARD, BRIGHT, SOFT, MOVE screens in PIP/POP/DIGEST mode. STANDARD, MOVE BRILLIANT MUTE MUTE POWER Mutes and restores your LCD TV sound. Turns the LCD TV on and off. TV/CATV SOUND Cycles through the TV receiving signal: TV/CATV PICTURE SWAP SOUND Cycles through the audio modes: TV(antenna), CATV(cable) STANDARD, MOVIE, SOFT WIDE TV/VIDEO/COMP./PC TV VIDEO COMP. PC Cycles through the picture
Inhaltszusammenfassung zur Seite Nr. 14
ENGLISH ATSC DTV FUNCTION MUTE POWER TV/CATV PICTURE SWAP SOUND TV VIDEO COMP. PC WIDE PIP POP DIGEST SETUP EPG In ATSC TV mode, pressing SETUP In ATSC TV mode, pressing displays the menu on the screen. - + EPG displays the EPG ZOOM WINDOW (Electronic Program Guide) on the screen. DISP V-CHIP C.C. MTS ATSC Select the ATSC TV receiving the C.C. signal inputs of your LCDTV. In ATSC TV mode, cycles ATSC SET UP EPG C.C. through the digital Closed Caption. FAV- FAV+ FAV EDIT STILL STILL
Inhaltszusammenfassung zur Seite Nr. 15
Chapter 2 Installing the LCD TV Refer to the owner’s manual of any external equipment to be connected. When connecting any external equipment, do not connect any AC power cords to wall outlets until all other connections are completed. Connecting a TV Cable or Antenna Antenna Connection The antenna requirements for good color TV reception are more important than those for a black & white TV reception. For this reason, a good quality outdoor antenna is strongly recommended. The following is a
Inhaltszusammenfassung zur Seite Nr. 16
ENGLISH A. Combination VHF/UHF antenna VHF/UHF Antenna 300/75-ohm adapter (not included) VHF/UHF Antenna 300-ohm twin- lead cable 75-ohm coaxial cable ANT. UHF B. Separate VHF and/or UHF antennas Antenna VHF Antenna Combiner 300-ohm twin- (not included) lead cable OUT IN 75-ohm coaxial cable 300-ohm twin- lead cable ANT. Chapter 2 Installing the LCD TV 15
Inhaltszusammenfassung zur Seite Nr. 17
Cable TV (CATV) Connection This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electrical Code (NEC) that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building accurately, or as close to the point of cable entry as possible. Use of this TV for other than private viewing of programs broadcasted on UHF, VHF or transmitted by cable companies for
Inhaltszusammenfassung zur Seite Nr. 18
ENGLISH Use a supplied antenna cable to connect the ANT.NTSC or ANT.ATSC signal to the LCD TV’s ANT. terminal. NTSC ATSC Connect the AC power cord at the back of the TV and connect the power cord to wall outlet. Press the button on the remote to turn on the LCD TV. Always disconnect the LCD TV from the main voltage when the LCD TV will not be used for a long period of time. The POWER button on the front panel is only used for switching the LCD TV into standby, it does not disco
Inhaltszusammenfassung zur Seite Nr. 19
Connecting a VCR AV2 S-VIDEO2 Pb Pr VIDEO Pb Pr S-VIDEO1 AV1 HDMI VGA NTSC ATSC A B METHOD A: Use an S-Video cable to connect the VCR’s S-video output jack to the LCD TV’s S- VIDEO1 or S-VIDEO2 input jack. Use an audio cable to connect the VCR’s audio output jacks to the LCD TV’s audio inputs. METHOD B: Use a composite cable to connect the VCR’s composite video/audio jacks to the LCD TV’s composite video/audio AV1 or AV2 jacks. Connect all AC power sources, before turning on the po
Inhaltszusammenfassung zur Seite Nr. 20
ENGLISH Connecting a DVD Player AV2 S-VIDEO2 Pb Pr VIDEO Pb Pr S-VIDEO1 AV1 HDMI VGA NTSC ATSC /Pb /Pr A B C D /Pb /Pr DVD PLAYER METHOD A: Use a HDMI cable to connect the DVD’s HDMI jack to the LCD TV’s HDMI jack. METHOD B: Use a component cable to connect the DVD player’s component output jacks to the LCD TV’s component (YPbPr1 or YPbPr2) input jacks. Use an audio cable to connect the DVD player’s component audio jacks to the LCD TV’s audio input jacks. METHOD C: Use an audio cable
