Inhaltszusammenfassung zur Seite Nr. 1
Owner’s Manual
MEDIAMASTER
9860 S
GB 1
Inhaltszusammenfassung zur Seite Nr. 2
GB 2
Inhaltszusammenfassung zur Seite Nr. 3
MEDIAMASTER 9860 S Contents VIEWING MODE 19 GENERAL OPERATION OF THE General Information 19 MEDIAMASTER 4 Programme Information 19 FOR YOUR SAFETY 4 The “i” (Information) Button 20 REMOTE CONTROL 5 Guide 20 Rear and Front Panel 6 List of TV or Radio Channels 21 ABOUT THE SMARTCARD AND CA MODULE7 Options (Green Button) 21 Pay TV Services with a Smartcard (Viaccess) 7 TV Release (0) 22 Pay TV Services with a CA Module 7 Video Recording 22 PIN Code 7 The TEXT Button (Teletext) 22 INSTALLATION OF T
Inhaltszusammenfassung zur Seite Nr. 4
GENERAL OPERATION OF THE MEDIAMASTER Throughout this manual you will notice that the everyday opera- tion of your Mediamaster is based on a series of user friendly on- screen displays and menus. These menus will help you get the most from your Mediamaster, guiding you through installation, channel selection, viewing and many other functions. All functions can be carried out using the buttons on the remote control, and some of the functions can also be carried out using the buttons on the front p
Inhaltszusammenfassung zur Seite Nr. 5
REMOTE CONTROL This section describes how to operate the Mediamaster using the buttons on the remote control. Some of the functions can also be carried out using the buttons on the front panel. To switch the Mediamaster in and out of standby mode. EXIT TV To return to the viewing mode from a menu without stor- ing settings (in menu mode). To switch between TV or Radio (in viewing mode). To turn the sound off/on (mute). - + To adjust the volume of digital programmes. The Mediamaster’s maximum
Inhaltszusammenfassung zur Seite Nr. 6
Rear Panel Mains lead DIGITAL AUDIO AUX SCART TV/VCR ANTENNA * 95-250 V AC phono connector for connection to a VCR, for an RF- Satellite dish 50-60 Hz S/PDIF output for or an analogue satellite cable to the input (F-connec- connection to receiver aerial input tor) a HiFi system of the TV or VCR AUDIO L R TV SCART SERIAL PORT TV AERIAL phono connectors for connec- to read and load for a terrestrial Stereo outputs for tion to the data information (conventional) connection to a HiFi TV TV aerial
Inhaltszusammenfassung zur Seite Nr. 7
ABOUT THE SMARTCARD AND CA MODULE To be able to receive scrambled digital satellite channels you will need a Smartcard and/or a Common Interface CA (Conditional Ac- cess) module from the Service Provider of your choice. The Service Provider is the programme distributor. If you are subscribing to services from more than one Service Provider, you might have to change between different Smart- cards and/or CA modules. Smartcard Please note that a Smartcard and CA module may only be valid for a singl
Inhaltszusammenfassung zur Seite Nr. 8
INSTALLATION OF THE MEDIAMASTER The box for your Mediamaster should contain the following items: • the Mediamaster • a remote control with 2 AAA batteries • a SCART lead (fully featured 1,0 metre) • an aerial/RF lead (double screened 1,5 metres) SCART lead RF lead • an Owner’s Manual (this document) • a Software License agreement License Owner’s manual agrement About the SCART sockets • The rear panel of the Mediamaster is equipped with 2 SCART sockets (see diagram). When you connect other produ
Inhaltszusammenfassung zur Seite Nr. 9
Connecting the Mediamaster There are many different types of TV/VCR and other equipment that you can connect to the Mediamaster. In this manual you will see some of the most common ways to connect your equipment. If you use RF leads you will have to tune your TV and VCR to the Mediamaster output channel (see page 11). If you have problems with your connections and need help, con- tact your dealer or Service Provider. Connecting the Mediamaster to the TV TV • Connect the SCART lead between the ma
Inhaltszusammenfassung zur Seite Nr. 10
Connecting an Analogue Satellite Receiver and VCR • Connect a SCART lead between the main SCART socket on With Nokia Smart Priority Switch the TV and the TV SCART socket on the Mediamaster. • Connect a SCART lead between the VCR and the AUX SCART socket on the Mediamaster. VCR • Connect an RF lead from the RF output on the VCR to the TV aerial input on the TV. SCART RF • Connect an RF lead from the RF output on the Analogue receiver to the RF input socket on the VCR. Mediamaster • Connect the TV
Inhaltszusammenfassung zur Seite Nr. 11
Tuning Procedure when RF Connections are Used This procedure is necessary only if your Mediamaster is con- nected to the TV with an RF lead and no SCART leads are used. To tune your TV to the RF signal you might also need your TV manual in addition to this manual. The steps below explain what to do if you have been unable to use SCART leads in your con- nection. • Plug in your Mediamaster. Tuning your TV to the Mediamaster • Select a channel number on the TV that is not currently used for other
Inhaltszusammenfassung zur Seite Nr. 12
FIRST TIME INSTALLATION General Information Once you have correctly connected the Mediamaster, you also have to perform a “First Time Installation.” During this procedure, helpful information is displayed at the bot- tom of the menus. Please note! The OK button always confirms a selection within these menus, and pressing it will take you to the next step in the installation process. However, and this is important, often more than one value has to be entered in a menu. First, perform all necessar
Inhaltszusammenfassung zur Seite Nr. 13
FIRST TIME INSTALLATION RF Modulator Type If the Mediamaster is connected to the TV with a RF cable, you must select the right RF modulator alternative, which is depend- ent on the country where the Mediamaster is being used. Select “Normal (PAL B/G)” for all other countries than the United Kingdom. Select “UK (PAL I)” for UK. If you get picture but no sound, the RF modulator selection might be wrong. Antenna/Satellite Selection Select one of the alternatives from line 1 to 5 if you have a sin-
Inhaltszusammenfassung zur Seite Nr. 14
FIRST TIME INSTALLATION Antenna Adjustment and Signal Check Pressing OK from the selected alternative in the previous menu will display the Antenna Adjustment menu (shown to the right) on the screen. For each satellite, (e.g. NILESAT, HOTBIRD, ASIASAT, ARABSAT or PANAMSAT), up to 4 different channels are preprogrammed and shown in the menu. When you adjust the antenna, your Mediamaster will use the marked channel to find signals from a satellite. (You can select another channel with the button
Inhaltszusammenfassung zur Seite Nr. 15
FIRST TIME INSTALLATION Line Through on the Antenna 1 5 Satellite Selection Menu Select one of the alternatives NILESAT, HOTBIRD, ASIASAT, ARABSAT or PANAMSAT when you have a single LNB pointed towards any of these satellites. Then follow the “Antenna Adjustment and Signal Check” in- structions on the previous page. Line on the Antenna Satellite Selection 6 Menu Select this alternative when you have a single antenna equipped with 2 LNBs, or two antennas with one LNB on each
Inhaltszusammenfassung zur Seite Nr. 16
FIRST TIME INSTALLATION Line on the Antenna Satellite Selection 7 Menu This selection is necessary only if your satellite choice differs from the preprogrammed satellite alternatives in the following ways; if you do not use a universal LNB or when you have more than two LNB’s. OK One Antenna/One LNB Configuration Select this alternative if you have one LNB mounted on the an- tenna and you want to select another, not preprogrammed, sat- ellite. OK LNB Type Select the local oscillator (L. O
Inhaltszusammenfassung zur Seite Nr. 17
FIRST TIME INSTALLATION Multisatellite/DiSEqC Switch Configuration Select this alternative if your antenna system has more than one LNB. You can connect up to 4 LNBs. The selection of the different LNBs must be controlled by an external switch. Refer to page 15, “Con- nection of a DiSEqC switch.” For each LNB and switch port, you will have to specify the following: OK Switch type and port With more than one LNB you must use an external “DiSEqC” or a “Mini DiSEqC” switch. Select from the preprogr
Inhaltszusammenfassung zur Seite Nr. 18
FIRST TIME INSTALLATION Channel Search Progress This menu will be shown as long as the Mediamaster is search- ing for channels to download All channels found will be listed in two columns on the screen; with TV channels in one column and Radio channels in the other. Please note that the search procedure may take a few minutes. When the search procedure has ended, the screen will show how many TV and Radio channels have been found. • Press OK to go to the Time Adjustment menu. Time Adjustment The
Inhaltszusammenfassung zur Seite Nr. 19
VIEWING MODE General Information The following describes the basic functions of your Mediamaster while watching satellite TV or listening to satellite radio. Some of the functions described here are dependent on the Service Provider and can only be used if they are included in the transmitted programme information. Please note, that during the Channel Search procedure, the Mediamaster may download a large number of channels. This may include channels from various Service Providers, also those to
Inhaltszusammenfassung zur Seite Nr. 20
VIEWING MODE The “i” (Information) Button The Mediamaster has the ability to display information about pro- grammes currently being broadcast as well as those being broad- cast next. This procedure is the same for both TV and Radio mode. • By pressing the “i” button while watching TV you will get a special Programme Information Banner. Select channel with or the numeric buttons. The “i” symbol is coloured blue when displaying information about the current channel, and red when information for
