Bedienungsanleitung Havis-Shields Heavy Duty Trak Mount 2006-2009 Chevrolet Impala C-TM-IMP-1

Inhaltszusammenfassung zur Seite Nr. 1

INSTALL INSTRUCTIONS C-TM-IMP-1
HEAVY DUTY TRAK MOUNT
2006-2009 CHEVROLET IMPALA

TOOLS REQUIRED:
Ratcheting wrench Open-end wrench set
Standard Socket set Screwdriver Set

HARDWARE:
QTY DESCRIPTION PART #
1 18” Length Extrusion CM93055-2
1 12” Length Extrusion CM93055-1
1 Transmission Hump Bracket (no holes drilled) C-B43
1 Rear Extrusion Bracket CM001380
C-B42
1 Extrusion Adapter Bracket CM001379
12 ¼” Serrated Nut GSM30023
12 ¼ x ¾” Hex Head Bolt GSM33001
6 ¼” x ¾” Ph

Inhaltszusammenfassung zur Seite Nr. 2

SUB ASSEMBLY: 1. Confirm receipt of all hardware and components. 2. Remove partial OEM cup-holder/console located on the transmission hump. Note: Do not remove metal housing attached to this partial console. This piece is meant to strengthen the vehicles crumple zone and must not be removed. INSTALLATION: Sub-assemble C-B43 (only the View of partial OEM piece shown), 18” portion of console removed Attach rear extrusion bracket trak, extrusion adapter bracket, (CM001380) to ve

Inhaltszusammenfassung zur Seite Nr. 3

Cut floor mat, next to the seat Slide under seat support Slide guide brackets into seat rail rail to allow Under seat brackets into position as and loosely attach #10 x ¾” Phillips support bracket to slide under shown pan head machine screws seat rail 1. Position sub-assembled transmission hump bracket, 18” portion of trak, extrusion adapter bracket, rear extension bracket and 12” portion of trak to the under seat & guide brackets. 2. Loosely attach assembly using ¼-20 x ¾” Ph

Inhaltszusammenfassung zur Seite Nr. 4

C-TM-IMP-1 installed C-TM-IMP-1 installed w/ console, computer mounts and accessories. (Sold separately) C-TM-IMP-1_INST_11-08 4