Inhaltszusammenfassung zur Seite Nr. 1
DVDRX160
USER MANUAL
Inhaltszusammenfassung zur Seite Nr. 2
Safety y Instructions DANGER SYMBOL WARNING SYMBOL Th e lightning fl ash with arrowhead symbol Th e exclamation point within an equilateral within an equilateral triangle is intended triangle is intended to alert the user to to alert the user to the presence of the presence of important operation and dangerous voltage in the unit. maintenance (servicing) instructions in the manual accompanying the unit. Th is symbol indicates there is a dangerous voltage within the HDD+DVD RECORDER, which may
Inhaltszusammenfassung zur Seite Nr. 3
1. READ THIS MANUAL 5. HEAT After unpacking this product read the Position the unit away from heat sources manual carefully and follow all the such as radiators, heat registers, stoves, or operating instructions. other products (including amplifi ers) that produce heat. 2. POWER SOURCES 6. WATER AND MOISTURE Th is product should be operated only from the type of power source indicated Do not use this product near water such on the unit. If you are not sure of the type as near a bathtub, was
Inhaltszusammenfassung zur Seite Nr. 4
11. OBJECTS AND LIQUIDS 18. SERVICING Never push objects into this product as Do not attempt to service this product that could result in a fi re or electric shock. yourself as this may expose you to Never spill liquids on the product. dangerous voltage or other hazards. Refer all servicing to qualifi ed service personnel. 12 .ATTACHMENTS 19. REPLACEMENT PARTS Do not use attachments not recommended by the product Be sure the service technician has manufacturer as they may cause hazards. used au
Inhaltszusammenfassung zur Seite Nr. 5
CONTENTS SAFETY INSTRUCTIONS 1 BASIC INFORMATION 6 FEATURES OF THE RECORDER 6 TERMS 6 IDENTIFICATION OF CONTROLS 8 REMOTE CONTROL 9 REMOTE CONTROL INSTRUCTIONS 10 SYSTEM CONNECTION 11 CONNECTING THE VIDEO OUTPUT TO YOUR TV 11 COMPOSITE VIDEO TYPICAL CONNECTION 11 SVIDEO CONNECTION 12 COMPONENT VIDEO CONNECTION 12 AUDIO OUTPUT CONNECTIONS 13 ANTENNA & TV CONNECTIONS 13 SYSTEM CONNECTION FOR RECORDING EXTERNAL SIGNALS REAR PANEL SIGNAL INPUT 14 FRONT AV INPUTS VIDEO IN, SVIDEO IN 14 SYSTEM
Inhaltszusammenfassung zur Seite Nr. 6
DVD PLAY MODE 25 ENTER THE PLAY MODE 25 MENU DESCRIPTION 25 DISPLAY OSD 26 USB PLAYBACK 28 HDD PLAY MODE 28 HDD PLAYBACK 28 TIME SHIFT 29 SYSTEM SET UP 32 OPERATION INTERFACE AND GENERAL STEPS 32 AUTO CHAPTER MARKER 32 RECORD QUALITY 33 APS AUTO PROGRAM SCAN 33 MODIFY CHANNEL 33 PROGRAM TABLE 34 SET UP MENU VIDEO 35 TV TYPE 35 SET UP MENU AUDIO 36 SET UP MENU LANGUAGE 37 SETUP MENU DATE/TIME 38 SETUP MENU PREFERENCES 39 BASIC INFORMATION 41 SETUP MENU TIME SHIFT 41 APPENDIX (TROU
Inhaltszusammenfassung zur Seite Nr. 7
Basic Information Features of the Recorder Th e machine is capable of processing and recording various video signals into high quality DVD disc and HDD, such as the input signals of TV, ordinary disc player and DV. In addition, the machine can be used as a DVD player of excellent performance. It has all the functions of an ordinary DVD player. MULTIPLE SIGNAL INPUT MULTIPLE SIGNAL OUTPUT 1. Composite Video Input 1. Composite Video Output 2. S-Video Input 2. S-Video Output 3. Analog Audio Input
Inhaltszusammenfassung zur Seite Nr. 8
RECORDING QUALITY For DVD R/RW disc with the capacity of 4.7GB and HDD disc with capacity of 160GB, there are 6 diff erent recording qualities available to the user with lower qualities allowing for longer recording times. Th e recording modes available are: 4.7GB DVD 160GB HDD QUALITY SLP (Super Long Play): 6HRS 180HRS LOW EP (Extended Play): 4HRS 120HRS MODERATE LP (Long Play): 3HRS 90HRS NORMAL SP+ (Standard Play Plus): 2½HRS 75HRS GOOD SP (Standard Play): 2HRS 60HRS VERY GOOD HQ (High Qualit
Inhaltszusammenfassung zur Seite Nr. 9
Identifi cation of Controls Front Panel 1 2 3 4 5 6 7 8 9 10 11 12 12 13 14 15 1. STANDBY 9. DV IN 1394 MINI FIREWIRE 2. DISC TRAY 10. SVIDEO INPUT 3. OPEN/ CLOSE 11. COMPOSITE VIDEO INPUT 4. PLAY/ PAUSE 12. STEREO AUDIO INPUTS 5. DVD 13. USB INPUT 6. HDD/DUB 14. DISPLAY 7. REC 15. IR RECEIVER 8. SOURCE 1 1 1 3 335 5 57 7 7 Rear Panel 2 2 2 4 446 6 6 7 77 8 88 9 99 1 1. . RF RF I IN N 7 7. . 5 5.1 .1C CH A H AU UDIO OUTP DIO OUTPUT UT 2 2. . R RF F O OUT UT FL FL, FR , FR, SL , SL, SR , S
Inhaltszusammenfassung zur Seite Nr. 10
Remote Control 1. STANDBY - Turn the unit on or set the unit to Standby mode. 2. DVD - Press to view or play optical disc content. While in DVD playback, pressing DVD will bring up the DVD menu. 3. HDD/DUB - Press to view HDD title list or the dubbing menu. 4. FILE/USB - Press to enter File Manager 1 1 21 21 5. DV-Press to select DV IN as input source. 2 2 22 22 6. TIMER - Access the timer menu for scheduled recording setup. 3 3 23 23 7. FUNCTION 24 24 4 4 8 / 9. FWD/REV - Scan in fast reverse
Inhaltszusammenfassung zur Seite Nr. 11
Remote Control Instructions Notes: ■ Do not drop the remote controller or leave it in places of high humidity. ■ Do not leave the Infrared receiver exposed to direct sun light or bright light. ■ Do not use new and old batteries together. Try not to use rechargeable batteries. 30º 30º REMOTE CONTROL Your remote control will operate from a 30º angle. However you will always get the best result when you direct the remote to the IR sensor located on the unit. 10
Inhaltszusammenfassung zur Seite Nr. 12
Sy ystem Connection Connecting the video output to your TV In order to use the DVD Recorder, you’ll need to make a video connection to your TV. Th e capabilities of your TV and the cables you have on hand will determine the connections you can use. Th ere are 3 possible connection types: - Composite Video: Th e most widely used connection. Th is unit includes an A/V cable for Composite Video. - S-Video: A higher quality connection that requires a special S-Video cable and an S-Video capable TV
Inhaltszusammenfassung zur Seite Nr. 13
S-Video Connection Th is is a higher quality connection than standard composite video, and requires a special S-Video cable (not included). Th e S-Video connector is distinguishable by its 4 pins, as shown below. If your TV has an S-Video input jack, it’s recommended that you use this type of connection for better picture quality. SVIDEO CONNECTION 1. Use a S-Video Cable, connecting the TELEVISION S-Video output from your DVDRX160 to the corresponding input on your TV 2. Turn on the unit and s
Inhaltszusammenfassung zur Seite Nr. 14
Audio Output Connections Th is unit features a variety of audio outputs for connection to a receiver or other audio equipment. - Use the included A/V cable to connect the stereo audio outputs for connection to a TV or stereo receiver. - Optical and Coaxial digital audio outputs send an encoded digital bitstream, suitable for receivers with Dolby decoding capability. Th ese outputs require special cables not included. TELEVISION AV RECEIVER WITH DIGITAL AUDIO INPUT DVDRX160 Antenna & TV Connect
Inhaltszusammenfassung zur Seite Nr. 15
System Connection for recording external signals (Rear Panel Signal Input) Audio/ Video inputs are provided on the front and back side of your DVDRX160 for connection of outside audio/ video sources such as VCRs, Camcorders, DVD Players etc. External sources must support Composite Video and S-Video or stereo audio to be suitable for recording. COMPOSITE VIDEO INPUT CONNECTION DVD PLAYER, VCR, STB ETC. DVDRX160 FRONT AV Inputs (Video In, S-Video In) DVDRX160 S-VIDEO or COMPOSITE DVD PLAYER, VCR
Inhaltszusammenfassung zur Seite Nr. 16
System Connection for recording external digital signals (Front Panel) When connecting external signals, be sure to switch off the power source of the unit and other devices DVDRX160 DV AND USB INPUTS Refer to the manual of your mini fi rewire or usb device for further instructions on how to connect USB FLASH DRIVE DV IN/OUT CAMCORDER WITH IEEE1394 OUTPUT Recording g Mode Introduction Th ere are various external signal inputs in the unit, including ■ S-Video ■ Composite Video ■ TV tuning ■ DV in
Inhaltszusammenfassung zur Seite Nr. 17
Selecting Tuner Channel In Tuner Mode: ■ Press the button CH+/- on remote control to select the channel ■ Press the number keys and then press SELECT button to select the channel Recording to DVD or HDD ■ Select recording target drive (DVD or HDD) ■ Press Source button once to switch to manual recording mode, and press DVD or HDD/DUB button to switch between DVD or HDD Record. ■ If you have a recordable media in the tray, you can press REC and start recording (OTR) to DVD. Press Stop to fi nish r
Inhaltszusammenfassung zur Seite Nr. 18
DV (Digital Video) Recording 1. Th is unit can perform real-time monitoring and recording for a DV through the IEEE 1394 serial port (DV). ■ Connect the DV to the unit (for details, see System Connection: System Connection for Recording). ■ Switch on the power of the unit. ■ Press the Source button until DV Input is selected. ■ Switch on the Power button of the DV, set it to CAMERA mode, and start monitoring. ■ Press the REC button to start recording. (Other operations is the same as in the R
Inhaltszusammenfassung zur Seite Nr. 19
Timer Recording You can set up your DVDRX160 to schedule recordings to begin and end at specifi c times. To do this: 1. Press the TIMER button to enter the timer recording menu, Timer Recording as shown. You can set up to 8 diff erent scheduled recordings at once. No. Source Quality Date Start End Record 2. In the timer recording menu, use the UP or DOWN buttons 1 to select a record, then press the SELECT button. 2 3. Set up the input source In the Timer Recording Setup box, select “SOURCE” from
Inhaltszusammenfassung zur Seite Nr. 20
8. Set up the start time of the recording: In the timer recording set up box, use the arrow buttons and then press the SELECT button to highlight the Start option. Enter a time between 0:00 and 23:59 with the number buttons and press SELECT to confi rm. Timer Recording Setup Set up the end time of the recording: Source CH029 Set the recording end time following the instructions above Record to HDD after having highlighted the End option. 9. Set up the record title: Quality SP Use ▲ or ▼ to cha
