Bedienungsanleitung TANDBERG D5018501

Inhaltszusammenfassung zur Seite Nr. 1

Installation of X-Port 10 with Director


This document explains how to connect the X-Port 10 to the Director system. This feature allows easy
connections for an external portable computer and automatic switching between the internal and external
computer with the Director system.


Supplied Components:

• 1 Connector Box
• 1 RS232 Blanking Plate
• 1 Pair of export 10 Mounting Bracket (Left and Right)
• 2 T201-0036 Cables, 1 T201-0072 Cable, 1 T237-0072 Cable, 2 T112-0036 Cab

Inhaltszusammenfassung zur Seite Nr. 2

X-Port 10 Installation: • Remove the existing brackets from the X-Port 10 unit and replace them with the supplied left and right brackets. Use the same screws for mounting the new brackets. • Insert the four 10-32 panel nut retainers on the rear left rack mount rail of the 3000i projector. Insert 1 panel nut retainer at the lowest hole, skip 1 hole insert another, skip 6 holes insert another, skip 1 hole insert another. • Install the X-Port 10 unit to the exterior of

Inhaltszusammenfassung zur Seite Nr. 3

System Connections: Connect the cables as shown in the diagram below and by matching the cable labeled ends to the corresponding equipment. DIRECTOR APPLICATIONS MODULE LAN PC VGA IN AUX CTRL 1 AUX CTRL 3 DIAGNOSTICS DISPLAY VGA OUT AUX CTRL 2 PROGRAM TOUCHSCREEN TOUCHPANEL MOUSE CRESNET SMART X-Port 10 T112-0036 T112-0036 PROJECTOR COMPUTER 1 RGB OUT VIDEO VIDEO SERIAL AUD OUT COMPUTER 1 SERIAL PEN T201-0036 T201-0036 TRAY COMPUTER 1 DATA AUDIO INTERNAL T308-0036 T324-0036 COMPUTER 1 SPE