Inhaltszusammenfassung zur Seite Nr. 1
DVD-22/ DVD-22T
Single-DIN A/V Multimedia Source
Touch Sensor
DVD/CD/MP3/MP4
AM/FM Radio
Built-in TV tuner
Owner’s Manual
Take the time to read through this owner’s manual.
Familiarity with installation and operation procedures will help you obtain the best
Performance from your new DVD-receiver.
Inhaltszusammenfassung zur Seite Nr. 2
Table of Contents Table of Contents.......................................................................................................................1 Important Safeguards.................................................................................................................2 Accessories .......................................................................................................................3 Installation/Un-Installation .....................................
Inhaltszusammenfassung zur Seite Nr. 3
Important Safeguards Using the device at temperature below -10 ℃ may cause the breakage of the device. BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE! Read carefully through this manual to familiarize yourself with this high-quality sound system. Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher a
Inhaltszusammenfassung zur Seite Nr. 4
Accessories Package contains the following accessories for installation and operation of the unit. (1) Washer, Spring 1 each Washer, M5 Nut (2) Mounting Strap 1 (3) Screw 1 (4) Bolt 4 (5) Mounting Collar 1 (6) Release Key 2 (7) Rubber Cushion 1 Owner’s Manual Remote Controller Panel Carrying Case AUX IN Cable Page- 3
Inhaltszusammenfassung zur Seite Nr. 5
Installation/Un-Installation First complete the electrical connections, and then check them for correctness. Installation This unit can be installed in any dashboard having an opening as shown on the picture. The dashboard should be 4.75 – 5.56 mm thick in order to be able to support the unit. 1. Insert mounting collar into the dashboard, and bend the mounting tabs out with a screwdriver. Make sure that lock lever （ ※ ）is flush with the mounting collar (not projecting outward).
Inhaltszusammenfassung zur Seite Nr. 6
Wiring Connections Make sure you have good chassis ground. A good ground connection will eliminate most electrical noise problems. A good chassis ground requires a tight connection to the vehicle’s metal chassis. The area around the ground connection should be clean, bare metal without rust, paint, plastic, dust, or dirt for a good electrical connection. Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For
Inhaltszusammenfassung zur Seite Nr. 7
Caution: Do not interchange the connection of the wiring!!! For some car models you may need to modify wiring of the supplied power cord. Contact your authorized car dealer before installing this unit. Remark: When you back a car, screen display switch to Rear Camera automatically Detachable Control Panel Detaching the control panel Turn the Power off. Press OPEN button release the panel. Pull the panel out. Attaching the control panel Insert the left side of the control
Inhaltszusammenfassung zur Seite Nr. 8
Panel Controls 1. Power/Mute 14. PRESET 1/play pause 2. BAND 15. PRESET 2./RPT 3. PREVIOUS 16. PRESET 3./INT 4. VOL + 17. PRESET 4/RDM 5. NEXT 18. PRESET 5/STOP 6. DISP 19. PRESET 6/MENU 7. AS/PS 20.AUX IN JACK 8. LCD 21.USB SLOT 9. IR sensor 22.SD SLOT 10. OPEN 23.EJECT 11.MODE. 24.DISC SLOT 12.OK 25.RESET 13.VOL- Page- 7
Inhaltszusammenfassung zur Seite Nr. 9
IR Remote Control 1. MODE 2. POWER 3. BND/RDM 4. ENTER 5. Cursor / / / 6. STEREO/MONO 7. LOC/ PROG 8. P.SCN/RPT 9. SEEK-/ 10. LOUD 11. OSD 12. STOP/ PBC 13. Digit 0-9 14. 15. MUTE 16. MENU 17. SUB-T 18. SETUP 19. ANGLE 20. INT 21. VOL+ 22. A-B/ZOOM 23. SEL 24. SEEK+/ 25. VOL- REPLACING THE BATTERY 26. AUDIO/ GOTO Remote Control comes with a CR-2025 Lithium Battery included. 1. Remove the Battery Hold
Inhaltszusammenfassung zur Seite Nr. 10
General Operations Reset the Unit In case the unit is malfunctioned or need to reset to factory default setting, press RESET button in inner panel then the unit will be reset. Power on/off Press POWER key button to turn on the unit. Long press POWER key on front panel or press POWER button on RC to power off the unit. Under Power on mode, short press comes in mute. Mode Setting Press MODE button on front panel or remote control to change mode in a sequence of: Tuner =>DVD =>
Inhaltszusammenfassung zur Seite Nr. 11
Digital Tuner Band selection Press MODE button to select the RADIO mode. Press the BAND button to select the desired band: FM1=> FM2 => FM3 => AM1=>AM2 STEREO/MONO In FM mode, press SETREO/MONO button on remote control to select stereo or mono sound reception. Manual/ automatic tuning Manual tuning: press the / butt ons on remote control(or on the front panel ) and hold for 2 seconds to enter the manual tuning mode. Press the / buttons on the panel or on the Remote re
Inhaltszusammenfassung zur Seite Nr. 12
SD/MMC Cards & USB Operations USB Flash Memory To play MP3/ MP4/ WMA files from a USB flash memory, insert a USB flash memory into the USB port on the right side of the unit. The unit will start playing MP3/MP4/ WMA files on the USB flash memory automatically. Or press the MODE button to select USB after pressing POWER button to turn on the unit. SD/MMC Card To play MP3/ MP4/ WMA files on a SD/MMC card, insert the card into the card slot (you should press the OPEN button on the pa
Inhaltszusammenfassung zur Seite Nr. 13
Repeat Press the RPT button on remote control or the panel for RPT1 (repeat the current playing file) => RPT ALL (repeat all folders) => RPT folder (repeat current folder) => RPT OFF. Repeat A-B Function 1. Press A-B button on the remote at the starting point of the section you want to repeat (point A). 2. Press A-B button again at the ending point of the section you want to repeat (point B). Section A-B repeating starts. 3. Press A-B button again to cancel the A-B repeat function
Inhaltszusammenfassung zur Seite Nr. 14
Discs operations Glossary PBC (Play Back Control) Play Back Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. Title The title is the important part of DVD disc. The memory volume of the disc is rather big, that makes possible to record several films on one disc. For example, if a disc
Inhaltszusammenfassung zur Seite Nr. 15
Playing/pausing To ensure good system performance, wait until the unit finishes reading the disc information before proceeding. Press the PLAY/ PAUSE button to start/ pause the playback. In pause mode press it again to resume the playback. Stop During playback press the STOP button on the RC or on the panel. Playback will be stopped. Press the PLAY/ PAUSE button again to start playback from the position at which it was stopped. If the disc is removed, the resume function is cancelled
Inhaltszusammenfassung zur Seite Nr. 16
PBC (Playback Control) function (for VCD only) If you insert a VCD with PBC, playback starts from the beginning of the 1st track automatically. 1. Long press PBC/STOP button to activate interactive menu on screen during playback. 2. If the menu consists of titles, you can select a desired one using the digit 0-9 buttons. 3. The VCD starts playing the selected title automatically or press ENTER button to confirm the selected track for playback. MENU function (for DVD only) 1. Press MEN
Inhaltszusammenfassung zur Seite Nr. 17
MP3 overview Notes on MP3: MP3 is short for MPEG Audio Layer 3 and refers to an audio compression technology standard. This product allows playback of MP3 files on CD-ROM, CD-R or CD-RW discs. The unit can read MP3 files written in the format compliant with ISO 9660. However it does not support the MP3 data written by the method of packet write. The unit can not read an MP3 file that has a file extension other than “.mp3”. If you play a non- MP3 file that has the “.mp3” extension
Inhaltszusammenfassung zur Seite Nr. 18
Setup Menu • Press SETUP button to enter the system settings main menu; • Press cursor / buttons to move along icons on the top navigation bar on settings main menu. Select one of the setup pages: General, Speaker, Downmix, Audio; • Press cursor / buttons to choose a setting or return to the Setup Page; • Press cursor button to enter the highlighted setting; • Press ENTER button on remote contro confirm your setting. General settings Menu Function entry Here you can adjust
Inhaltszusammenfassung zur Seite Nr. 19
Dolby settings Menu entry With this menu item you can select the type of Left and Right channel audio output. Stereo is normal Stereo, Mono L is all Dual sound on the Left Audio mono output, Mono R is all sound on the Right channel. The “Mix Mono” function only works when a DVD is being played in DTS 5.1 mode. Video settings Menu entry This serves to set the sharpness of the Sharpness image (high / medium / low). This serves to set Brightness the brig
Inhaltszusammenfassung zur Seite Nr. 20
Preference settings Menu entry Function This setting enables the selection of the appropriate TV standard. PAL is the customary standard in Europe. NTSC is the customary standard in the US and Japan. Only select the MULTI option if your TV can play back both formats. Here the TV Type output signal is automatically adjusted to the standard of the inserted DVD. If the “MULTI” setting is selected, “AUTO” will be displayed to the left of the selection menu. This enables the selection
