Bedienungsanleitung Grizzly T10252

Inhaltszusammenfassung zur Seite Nr. 1

MODEL T10252
DUST PORT
FOR G1183/G1276
INSTRUCTIONS
Introduction Dust Collection
t he Model t 10252 d ust port helps capture t he included dust collection hose assembly has a
1
dust from the disc sander on the g 1183/g 1276 2 ⁄2" adapter for connection to your dust collection
Combination sanders that were manufactured system.
before august, 2010.
NOTICE
DO NOT operate the Model G1183/G1276
The installation of the dust port requires
sander without an adequate dust collec-
that you remove the

Inhaltszusammenfassung zur Seite Nr. 2

Installation in order to attach the dust port, you need to remove the cast aluminum lower disc guard, cre- 3 ate a 1 ⁄8" hole in it, and tap two #10-24 holes near this hole for attaching the dust port. if you are not experienced with these tasks, get assistance from someone who is to reduce the risk of personal injury or damaging the lower disc guard. Tools Needed Qty another person .................................................. 1 lower Knob phillips s crewdriver .......................

Inhaltszusammenfassung zur Seite Nr. 3

6. take care to retain the motor shaft key, then phillips slide the disc off the shaft. this will also head screws remove the lower disc guard. (1 side shown) Note: It may be necessary to gently tap on the back of the disc with a dead blow hammer or rubber mallet to aid in removing it from the shaft. 7. refer to Figures 8–9 for the location of the 3 1 ⁄8" hole for the dust chute, then mark the location of the hole on the guard and use the bi-metal hole saw to make the hole. Important:

Inhaltszusammenfassung zur Seite Nr. 4

8. position the dust chute over the hole you 13. Make sure the disc is fully seated on the made in Step 7 so that it completely covers it motor shaft, then re-tighten both set screws and is facing down and to the right, then mark to secure it. the locations of the #10-24 mounting holes. 14. re-install the upper disc guard with the eight 9. remove the dust chute, then drill and tap the phillips head screws that you removed in two #10-24 holes. Step 4. 10. secure the included cover to the bott