Inhaltszusammenfassung zur Seite Nr. 1
43-789.fm Page 1 Monday, August 16, 1999 8:32 AM
Cat. No. 43-789
OWNER’S MANUAL
Please read before using this equipment.
TAD-1029
Digital Answering System
with 25-Channel Cordless Telephone
Inhaltszusammenfassung zur Seite Nr. 2
43-789.fm Page 2 Monday, August 16, 1999 8:32 AM FEATURES Your RadioShack TAD-1029 Digital An- Announce-Only — lets you play an an- swering System uses advanced cord- nouncement for callers to hear, without less telephone technology to give you recording their messages. superior audio quality. Its cordless oper- ation lets you move freely around your LED Message Counter — shows the home or office. number of messages the TAD has re- corded. The TAD-1029 stores all messages on a computer chip.
Inhaltszusammenfassung zur Seite Nr. 3
43-789.fm Page 3 Monday, August 16, 1999 8:32 AM ANSWER Button — lets you turn the Headset Jack — lets you connect an TAD on or off without disconnecting it. optional headset (available at your local RadioShack store) for hands-free con- Phone Pick-Up Detection — stops re- venience. cording when you pick up any phone on the same line as the TAD. Hearing Aid Compatible — lets you use this telephone with hearing aids that have a T (telephone) switch. Telephone Features This telephone device has
Inhaltszusammenfassung zur Seite Nr. 4
43-789.fm Page 4 Monday, August 16, 1999 8:32 AM We recommend you record the TAD’s FCC STATEMENT serial number here. The number is on the bottom of the base. Your TAD-1029 complies with Part 68 of FCC Rules. You must, upon request, Serial Number ________________ provide the FCC Registration Number and the REN to your phone company. Important: Cordless phones such as These numbers are on the label on the this one require AC power to operate. back of the base. When AC power is off, you cannot d
Inhaltszusammenfassung zur Seite Nr. 5
43-789.fm Page 5 Monday, August 16, 1999 8:32 AM CONTENTS Preparation .............................................................................................................. 7 Selecting a Location ........................................................................................... 7 Installing the Phone ............................................................................................ 7 Placing the Base on a Desk Top ....................................................
Inhaltszusammenfassung zur Seite Nr. 6
43-789.fm Page 6 Monday, August 16, 1999 8:32 AM Recording Incoming Messages ........................................................................ 25 Recording a Memo ........................................................................................... 25 Using the Handset ..................................................................................... 25 Using the Base ........................................................................................... 25 Playing Message
Inhaltszusammenfassung zur Seite Nr. 7
43-789.fm Page 7 Monday, August 16, 1999 8:32 AM PREPARATION SELECTING A LOCATION INSTALLING THE PHONE You can place the phone on a desk top Placing the Base on a or table, mount it on a standard wall Desk Top plate, or mount it directly on the wall. Se- lect a location that is: 1. Remove the mounting bracket by holding in both tabs and gently pull- • near an AC outlet ing out the wide end of the bracket. • near a telephone line jack • out of the way of normal activities • away from electrica
Inhaltszusammenfassung zur Seite Nr. 8
43-789.fm Page 8 Monday, August 16, 1999 8:32 AM 4. Insert the supplied AC adapter’s 7. Plug the adapter into a standard AC barrel plug into the DC 12V jack on outlet. The message counter counts the back of the base. down from 18 to 00 and the TAD- 1029 beeps. 8. Fully extend the base’s antenna and place it in a vertical position. 5. Route the adapter’s cord through the strain relief slot on the back of the base. Strain Relief Slot Mounting the Base on a Wall 6. Insert the tabs on the narro
Inhaltszusammenfassung zur Seite Nr. 9
43-789.fm Page 9 Monday, August 16, 1999 8:32 AM 2. Plug one end of the supplied short the bracket into the inner pair of modular cord into the telephone jack slots near the top of the base as on the back of the base. shown. 3. Insert the supplied AC adapter’s barrel plug into the DC 12V jack on 6. Snap the tabs at the wide end of the the back of the base. bracket into place. 4. Route the modular cord through ei- ther groove on the right bottom of the base and the adapter cord 7. Plug the mod
Inhaltszusammenfassung zur Seite Nr. 10
43-789.fm Page 10 Monday, August 16, 1999 8:32 AM 15 8. Plug the AC adapter into a standard 1. Drill two holes 3 /16 3 /16" AC outlet. The message counter inches (100 mm) counts down from 18 to 00 and the apart. Then thread a TAD-1029 beeps. screw into each hole, letting the heads ex- 3 tend about /16 inch (5 15 3 /16" mm) from the wall. 9. Fully extend the base’s antenna and raise it to a vertical position. 2. Remove the mounting bracket by holding in both tabs and gently pull- ing out the w
Inhaltszusammenfassung zur Seite Nr. 11
43-789.fm Page 11 Monday, August 16, 1999 8:32 AM 4. Insert the supplied AC adapter’s 7. Align the keyhole slots with the barrel plug into the DC 12V jack on mounting screws and slide the base the back of the base. downward to secure it. 5. Route the modular cord through ei- ther groove on the right bottom of 8. Plug the adapter into a standard AC the base and the adapter cord outlet. The message counter counts through the groove below the strain down from 18 to 00 and the TAD- relief slot. 1
Inhaltszusammenfassung zur Seite Nr. 12
43-789.fm Page 12 Monday, August 16, 1999 8:32 AM 2. Put the batteries in the compartment INSTALLING BACKUP as indicated by the polarity symbols BATTERIES (+ and –) marked inside. The TAD-1029 requires AC power to op- erate. However, if AC power fails or you unplug the TAD-1029, four AAA backup batteries (not supplied) save the mes- sages, day and time settings, and re- mote operation security code for up to 12 hours. We recommend you use alka- 3. Replace the cover. line batteries, such as R
Inhaltszusammenfassung zur Seite Nr. 13
43-789.fm Page 13 Monday, August 16, 1999 8:32 AM CONNECTING AND CHARGING THE HANDSET BATTERY CHARGE PACK Indicator The TAD-1029 comes with a recharge- able nickel-cadmium battery pack in the handset but not connected. Before using Recharge the battery pack when the your phone, you must connect the bat- BATT LOW indicator on the handset tery pack and then charge it for about 15 flashes. hours. BATT LOW 1. Press down and slide off the battery Indicator compartment cover. Notes: • If the CHA
Inhaltszusammenfassung zur Seite Nr. 14
43-789.fm Page 14 Monday, August 16, 1999 8:32 AM • When you first use the phone after SETTING THE DIALING charging or recharging the battery MODE pack, the phone might not work and you might hear 3 short beeps when Set T/P (Tone/Pulse) on the back of the you press TALK. If this happens, re- base for the type of service you have. If turn the handset to the base for about you are not sure which type you have, 5 seconds. This resets the security after you charge the handset battery access-prot
Inhaltszusammenfassung zur Seite Nr. 15
43-789.fm Page 15 Monday, August 16, 1999 8:32 AM Note: If you plan to check your messag- TURNING THE RINGERS es by long distance, set the number of OFF OR ON rings to toll-saver (see “Using Toll- Saver” on Page 28). To turn off the ringers on the base and handset, set RINGER on the right side of the base to OFF. You can still make or SETTING THE DAY AND receive calls using this phone, and tele- phones on the same line still ring when TIME there is an incoming call. The IN USE in- dicator
Inhaltszusammenfassung zur Seite Nr. 16
43-789.fm Page 16 Monday, August 16, 1999 8:32 AM 3. To change the day, repeatedly press 2. To change the day of the week, re- SKIP (6) to move forward or REPEAT peatedly press SKIP( ) to move (4) to move backward. forward or REPEAT( ) to move backward. 3. Press CLOCK. The TAD announces 4. Press CLOCK. The TAD announces the hour and “AM” or “PM.” the hour and “AM” or “PM.” 4. To change the hour, repeatedly 5. To change the hour, repeatedly press SKIP or REPEAT. press SKIP or REPEAT. 5. Press
Inhaltszusammenfassung zur Seite Nr. 17
43-789.fm Page 17 Monday, August 16, 1999 8:32 AM TELEPHONE OPERATION MAKING AND RECEIVING SETTING THE HANDSET’S A CALL VOLUME To make a call, lift the handset and press You can change the handset’s volume TALK. When you hear the dial tone, dial during a call by repeatedly pressing the desired phone number or memory VOLUME. The volume steps up and number (see “Memory Dialing” on down the three settings (low, medium, Page19). and high) and remains set for subse- quent calls. To answer a call
Inhaltszusammenfassung zur Seite Nr. 18
43-789.fm Page 18 Monday, August 16, 1999 8:32 AM For example, if you have Call Waiting, USING REDIAL press FLASH to answer an incoming call without disconnecting the current call. You can quickly redial the last number di- Press FLASH again to return to the first aled. Simply lift the handset and press call. TALK. When you hear the dial tone, press REDIAL. Note: If you do not have any special phone services, pressing FLASH might disconnect the current call. USING TONE SERVICES Notes: ON A P
Inhaltszusammenfassung zur Seite Nr. 19
43-789.fm Page 19 Monday, August 16, 1999 8:32 AM Notes: USING PAGE/INTERCOM • Paging does not work during a call. You can use the TAD-1029 as a pager • You cannot speak and hear the oth- and a two-way intercom between the er party at the same time during an base and the handset. This is useful if intercom conversation. you want to find the handset, or if you want to have a conversation between • If a phone call comes in during an someone with the handset and some- intercom conversation, pres
Inhaltszusammenfassung zur Seite Nr. 20
43-789.fm Page 20 Monday, August 16, 1999 8:32 AM Notes: • Each tone or pause entry uses one digit of memory. • If you wait more than 20 seconds to press a key or enter more than 16 digits, the phone sounds three quick beeps. Start over at Step 1. Dialing a Stored Number • To keep your accounts secure, we recommend you do not store To dial a stored number, lift the handset your personal access code for TALK and press . When you hear the dial services such as bank-by-phone MEM tone, press , th
