Inhaltszusammenfassung zur Seite Nr. 1
43-768.fm Page 1 Friday, August 13, 1999 2:49 PM
Cat. No. 43-768
OWNER’S MANUAL
Please read before using this equipment.
TAD-1006
Digital Answering System Telephone
with Time/Day Stamp
Inhaltszusammenfassung zur Seite Nr. 2
43-768.fm Page 2 Friday, August 13, 1999 2:49 PM FEATURES Your TAD-1006 Digital Answering TAD System Telephone with Time/Day Day/Time Stamp — records the day Stamp is a sophisticated, fully digital and time each message was record- message center that combines a tele- ed. phone and an answering machine in one convenient package. Digitally-Synthesized Voice — guides you through operation of the Fully digital means the TAD-1006 TAD-1006. stores all messages on a computer chip. This gives you ad
Inhaltszusammenfassung zur Seite Nr. 3
43-768.fm Page 3 Friday, August 13, 1999 2:49 PM Memo Recording — lets you leave Outgoing Message Remote Skip — messages for yourself or others in stops playing your outgoing message your home or office. during remote operation as soon as you press . Two-Way Recording — lets you record both sides of your phone con- This system has been tested and versation. found to comply with all applicable UL and FCC standards. Room Monitor — lets you listen from a remote phone to the room where the We rec
Inhaltszusammenfassung zur Seite Nr. 4
43-768.fm Page 4 Friday, August 13, 1999 2:49 PM READ THIS BEFORE FCC STATEMENT INSTALLATION Your system complies with Part 68 of FCC Rules. You must, upon request, We have designed your system to provide the FCC registration number conform to federal regulations, and and the REN to your phone company. you can connect it to most telephone Both numbers appear on the bottom lines. However, each device that you of your system. connect to the phone line draws pow- er from the line. We refer to th
Inhaltszusammenfassung zur Seite Nr. 5
43-768.fm Page 5 Friday, August 13, 1999 2:49 PM CONTENTS Installation ............................................................................................................ 7 Selecting a Location ........................................................................................ 7 Connecting the AC Adapter ............................................................................ 7 Installing a Backup Battery ......................................................................
Inhaltszusammenfassung zur Seite Nr. 6
43-768.fm Page 6 Friday, August 13, 1999 2:49 PM Screening Calls ............................................................................................. 22 Recording a 2-Way Conversation .................................................................. 22 Recording a Memo ........................................................................................ 23 Playing Messages ......................................................................................... 23 Playing Incomin
Inhaltszusammenfassung zur Seite Nr. 7
43-768.fm Page 7 Friday, August 13, 1999 2:49 PM INSTALLATION Important: To be sure your TAD-1006 company update the wiring for works properly, follow this sequence you. to install it. • The phone company will charge 1. Select a location (see “Selecting a you for the installation of neces- Location”). sary jacks. 2. Connect the AC adapter (see • The USOC number of the jack to “Connecting the AC Adapter”). be installed is RJ11C for a base- board jack or RJ11W for a wall- 3.Install a backup ba
Inhaltszusammenfassung zur Seite Nr. 8
43-768.fm Page 8 Friday, August 13, 1999 2:49 PM 2. Plug the other end of the AC INSTALLING A BACKUP adapter into a standard AC outlet. BATTERY The TAD-1006 initializes, the L. BATT (low battery) indicator lights If AC power fails or you unplug the steadily, and the ANSWER, TAD-1006, a 9V backup battery (not MEMO, and PLAY indicators flash supplied) saves the messages and the six times. Then the TAD-1006 settings for the day, time, and security beeps once and the ANSWER code. We recommend yo
Inhaltszusammenfassung zur Seite Nr. 9
43-768.fm Page 9 Friday, August 13, 1999 2:49 PM Replace the battery if the L.BATT (low 2. Plug the modular cord’s other end battery) indicator turns on while the into a modular phone line jack. AC adapter is properly connected. Connecting the Wall Bracket illustration If you plan to mount the TAD-1006 on a modular jack wall plate or directly on the wall, you must first connect the supplied mounting bracket to the back of the TAD-1006. To connect the Cautions: bracket, insert the tabs on the
Inhaltszusammenfassung zur Seite Nr. 10
43-768.fm Page 10 Friday, August 13, 1999 2:49 PM 4. Line up the keyhole slots on the Mounting on a Wall Plate bracket with the studs on the wall 1. Plug one end of the supplied mod- plate, then slide the TAD-1006 ular cord into the TO LINE jack on down onto the wall plate until it is the back of the TAD-1006. secure. illustration illustration 2. As shown below, press the modu- lar cord into the right groove on the mounting bracket and press the AC adapter’s cord into the left 5. Press up on
Inhaltszusammenfassung zur Seite Nr. 11
43-768.fm Page 11 Friday, August 13, 1999 2:49 PM 4. As shown below, press the modu- Mounting Directly on the Wall lar cord into the right groove on To install the TAD-1006 directly on the the mounting bracket and press wall, you need a drill and two screws the AC adapter’s cord into the left (not supplied) with heads that fit into groove. the keyhole slots on the mounting bracket. illustration 1. At the desired mounting location, 15 drill two holes 3 /16 inches apart, one above the other. il
Inhaltszusammenfassung zur Seite Nr. 12
43-768.fm Page 12 Friday, August 13, 1999 2:49 PM 7. Press up on the handset holder to SETTING THE TONE- remove it, turn it over so its tabbed PULSE SWITCH edge faces up, then press it back down into its slot on the base. Set TONE-PULSE for the type of ser- vice you have. If you are not sure which type you have, do this test. illustration illustration CONNECTING THE HANDSET TONE- 1. Lift the handset and set PULSE TONE to . To connect the handset to the base of the TAD-1006, plug one end of
Inhaltszusammenfassung zur Seite Nr. 13
43-768.fm Page 13 Friday, August 13, 1999 2:49 PM TELEPHONE OPERATION Use the telephone as you would any USING TONE SERVICES other to make and answer a call. ON A PULSE LINE This section explains how to use your If you have pulse service and TONE- TAD-1006’s special telephone fea- PULSE is set to PULSE, you can tem- tures. porarily switch to sending tones for banking services or computer transac- tions. USING REDIAL Dial the number as usual, then simply To redial the last number dialed, lift
Inhaltszusammenfassung zur Seite Nr. 14
43-768.fm Page 14 Friday, August 13, 1999 2:49 PM 4. To store the number in a priority Storing a Number in Memory memory location, press a priority Note: It is not unusual to hear beep- memory dial key (P1, P2, or P3) to ing/buzzing or the operator’s voice on store the number in that location. the line as you store a number in the To store the number in a standard TAD-1006’s memory. memory location, press a number key (0-9) to store the number in 1. Press STORE. that location. To store additi
Inhaltszusammenfassung zur Seite Nr. 15
43-768.fm Page 15 Friday, August 13, 1999 2:49 PM Storing a Pause in Memory Dialing a Stored Number In some telephone systems, you must To dial a number stored in a priority dial an access code (9, for example) memory location, simply press that and wait for a second dial tone before number’s priority memory dial key (P1, you can dial an outside number. You P2, or P3). can store the access code with the phone number; however, you must To dial a number stored in a standard also store a pause a
Inhaltszusammenfassung zur Seite Nr. 16
43-768.fm Page 16 Friday, August 13, 1999 2:49 PM TAD PREPARATION Complete the procedures in this sec- Notes: tion before you begin using the TAD to • Once you turn on the TAD, it is set answer calls. to answer calls (see “Setting the TAD to Answer/Not Answer Calls” Notes: on Page 20). • The keypad is located under the • You can also turn on the TAD cover on the front of the TAD- remotely (see “Remote Answer- 1006. Lift the cover to access the On” on Page 27). keys. SETTING THE DAY illustrat
Inhaltszusammenfassung zur Seite Nr. 17
43-768.fm Page 17 Friday, August 13, 1999 2:49 PM 2. Press 1/TIME. The TAD says, SETTING THE NUMBER “Press one for Monday, two for OF RINGS Tuesday, three for Wednesday, four for Thursday, five for Friday, The TAD is preset to sound four rings six for Saturday, seven for Sun- before it answers the first call. Follow day.” these steps to change the number of rings (from 1-9). illustration Notes: • If you plan to check your mes- sages by long distance, be sure the number of rings is set to at
Inhaltszusammenfassung zur Seite Nr. 18
43-768.fm Page 18 Friday, August 13, 1999 2:49 PM 2.Release OGM and record your RECORDING announcement (at least 2 sec- ANNOUNCEMENTS onds, but no more than 1 minute long). Speak toward the front of Recording the Outgoing the TAD-1006 from about 12 inches away. Announcement The TAD has a built-in outgoing an- nouncement that says “Please leave illustration your message after the tone.” You can record a different announce- ment (up to 1 minute long) for the call- Note: Be sure the outgoing me
Inhaltszusammenfassung zur Seite Nr. 19
43-768.fm Page 19 Friday, August 13, 1999 2:49 PM Checking/Deleting the Outgoing Announcement illustration You can press OGM at any time to play the outgoing announcement. Ad- just VOLUME on the side of the TAD to a comfortable listening level. 2. Speak toward the front of the TAD-1006 in a strong voice from illustration about 12 inches away. 3. Press ON/OFF when you finish recording the announcement. The To stop listening to the outgoing an- TAD plays the current memory full nouncement befo
Inhaltszusammenfassung zur Seite Nr. 20
43-768.fm Page 20 Friday, August 13, 1999 2:49 PM TAD OPERATION Be sure you complete the procedures the next call. The PLAY indicator in “Installation” and “TAD Preparation” flashes to indicate an incoming mes- before you begin using the TAD. sage(s) has been recorded. SETTING THE TAD TO illustration ANSWER/NOT ANSWER CALLS To set the TAD to answer calls, simply Notes: turn it on by pressing ON/OFF so the • Many local phone companies use ANSWER indicator turns on. calling party control (CPC
