Inhaltszusammenfassung zur Seite Nr. 1
FAVORIT 65050 VI
Fully Integrated Dishwasher
User Instructions
Inhaltszusammenfassung zur Seite Nr. 2
Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages of these user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, 1 Important!) are used to highlight instructions that are important for your safety or for the function of the appliance. It is imperative that these instructions are
Inhaltszusammenfassung zur Seite Nr. 3
Contents CONTENTS Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Economical and Ecological Dishwashing . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Appliance Features, Display and Control Panel . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 4
Contents Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 Cleaning the Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33 What to do, if ... . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 ...Error messages are displayed. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 ...there are problems with the operation of the di
Inhaltszusammenfassung zur Seite Nr. 5
Operating Instructions OPERATING INSTRUCTIONS 1 Safety Instructions The safety aspects of AEG electrical appliances comply with accepted technical standards and the German Appliance Safety Law. Neverthe- less, as a manufacturer we consider it our obligation to make you aware of the following safety information: Installation, Connection and Placing into Operation The dishwasher may only be transported upright. Check the dishwasher for transport damage. Do not in any circum- stances connect
Inhaltszusammenfassung zur Seite Nr. 6
Operating Instructions Never place the dishwasher in operation if the mains cable, water inlet or drain hose is damaged; or the control panel, work top or plinth area is damaged such that the inside of the appliance is freely accessible. If the mains lead is damaged, or is to be replaced for a longer lead, the cable (obtainable from AEG Service Force) must be replaced by a service engineer authorised by AEG. Never unplug the appliance by pulling on the cable, always pull the plug.
Inhaltszusammenfassung zur Seite Nr. 7
Operating Instructions In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: remove the fuse. 2 Disposal Disposing of the Packaging Material Dispose of the dishwasher packaging material correctly. All the packag- ing materials used are harmless to the environment and can be recy- cled. Plastic parts are marked with standard international abbreviations: – >PE< for polyethylene, e.g.
Inhaltszusammenfassung zur Seite Nr. 8
Operating Instructions Appliance Features, Display and Control Panel Top Spray Nozzle Rubber Seal for Connecting the Water Feed to the Spray Arm Spray Arms Water Hardness Switch Container for Special Salt Container for Rinse Aid Detergent Dispenser Display and Control Panel Rating plate Filters 8
Inhaltszusammenfassung zur Seite Nr. 9
Operating Instructions Display and control panel Multi-display Function buttons Indicators ON/OFF button 1 2 3 4 Set start delay Function buttons: In addition to the programme and/or start delay selected, the following functions can also be set with the help of these buttons: Function button 1 Set water softener Function button 2 Activate/deactivate rinse aid inflow Function button 3 Activate/deactivate acoustic signal Function button 4 - not programmed - The multi-display can indicate: – t
Inhaltszusammenfassung zur Seite Nr. 10
Operating Instructions Prior to using for the first time Prior to using for the first time, remove all the clips with which the baskets are secured for transport. Then perform the following steps: 0 1. Adjust the water softener 2. Fill with Salt for the Water Softener 3. Fill with Rinse Aid Water softener To avoid scale deposits on the dishes and in the dishwasher, the dishes must be washed with soft water, i.e. water with a low lime content. The dishwasher therefore has a built-in water
Inhaltszusammenfassung zur Seite Nr. 11
Operating Instructions 1) The water hardness will only be indicated acoustically if the acoustic signal has been activated. 2) (°d) German degree, measure of the hardness of water 3) [mmol/l] millimol per litre, international unit for the hardness of water 4) On this setting the length of the programme may be slightly longer. *) Factory setting Setting the water softener Using the table as a guide, adjust the water softener to that which cor- responds to the hardness of the water in your area:
Inhaltszusammenfassung zur Seite Nr. 12
Operating Instructions 9. When the hardness setting is correct, press the ON/OFF switch. The hardness setting is now saved. Special salt for the water softener If the water hardness in your area is less than 4 °d, then the water in 3 your dishwasher does not need to be softened and you do not need to use special salt or salt substitute. Water can be softened in one of two ways: If you are using dishwasher detergent that already contains salt sub- stitute, the detergent only is put into the
Inhaltszusammenfassung zur Seite Nr. 13
Operating Instructions 0 1. Set the water softener manually and electronically to the desired water hardness: Manual Electronic Multi-display Addition of special salt setting setting indicator 0 1 IL Do not add special salt. Addition of special salt 0 - 1 2-10 2l to10l via salt container (factory setting) If the water softener is electronically set at “1” for the purpose of using 3 detergent that includes special salt, the special salt indicator is deacti- vated. Adding special salt If you
Inhaltszusammenfassung zur Seite Nr. 14
Operating Instructions 6. Turn the lid clockwise to the stop, otherwise dishwasher salt will leak into the wash water, this could lead to poor wash results. To avoid this run a rinse programme after filling the salt container with special salt. This will wash away salt water and any salt crystals that have been spilt. Depending on the size of the salt grains, it can take several hours for 3 the salt to dissolve in the water and the special salt indicator J to extinguish. The setting of the
Inhaltszusammenfassung zur Seite Nr. 15
Operating Instructions If the only LED indicator illuminated is one that belongs to a pro- 3 gramme button, this means that this programme has been activated. The Programme must be cancelled (RESET): Press function buttons 2 and 3 simultaneously for approx. 1 second. The LED indicators for all the buttons in the control panel that are now able to be selected will become illuminated. 2. Press function buttons 2 and 3 simultaneously and keep them pressed. The LED indicators for function button
Inhaltszusammenfassung zur Seite Nr. 16
Operating Instructions 4. Fill with rinse aid exactly up to the level marked “max”; this corresponds to a quantity of approx. 140 ml. 5. Close the lid and press until it locks into place. 6. Wipe up any spilt rinse aid with a cloth. Otherwise too much foam will be formed during the wash. Adjusting Rinse Aid Dosing As the dishes are washed rinse aid is released from the dispenser into 3 the wash water. The dose is factory set at 4, and can be adjusted from 1 to 6. Only change the setting
Inhaltszusammenfassung zur Seite Nr. 17
Operating Instructions Activating/deactivating the acoustic signal The acoustic signal can indicate acoustically: – at which water hardness the water softener is set. – when a programme has finished. – when an error has occurred with the dishwasher. You can switch on/off the acoustic signal in the following way: 1. Press the ON/OFF button. The LED indicators for all the buttons in the control panel that are now able to be selected will become illuminated. If the only LED indicator illuminated i
Inhaltszusammenfassung zur Seite Nr. 18
Operating Instructions In Daily Use Check the salt and rinse aid levels. Load cutlery and dishes into the dishwasher Fill with dishwasher detergent Select a wash programme suitable for the cutlery and dishes Start the wash programme Loading Cutlery and Dishes Sponges, household cloths and any object that can absorb water should 1 not be washed in the dishwasher. For washing in the dishwasher the following cutlery/dishes are not suitable: are of limited suitability: Cutler
Inhaltszusammenfassung zur Seite Nr. 19
Operating Instructions – To avoid damage to glasses, they must not touch – Do not lay small objects (e.g. lids) in the cutlery rack Loading Cutlery Long bladed knives stored in an 1 upright position are a potential hazard. Long and/or sharp items of cutlery 1 such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unload- 1 ing sharp items such as knives. To ensure that all items of cutlery are completely washed, you should 0 1. Place th
Inhaltszusammenfassung zur Seite Nr. 20
Operating Instructions On some models of dishwasher it is possible to open the cutlery basket. To ensure that the cutlery rack 1 cannot open on removal from the appliance, you should always hold both parts of the two part handle. 0 1. Place the cutlery rack on a table or work surface 2. Open the two part handle 3. Remove cutlery 4. Close the two part handle. 20
