Bedienungsanleitung Stanton DJ FOCUS SIGNATURE MIXER SA-8

Inhaltszusammenfassung zur Seite Nr. 1

W A R R A N T Y
This unit has been designed and manufactured using quality components.
Therefore, it is warranted to be free from defects in materials (limited as speci-
fied below), and workmanship for a period of twelve (12) months from the origi-
SA-8
nal purchase date. During this period, all service and parts necessary to repair a
defect will be free of charge. This limited warranty applies to mechanical parts
DJ FOCUS SIGNATURE MIXER
which are subject to wear and tear as specified:
• Fade

Inhaltszusammenfassung zur Seite Nr. 2

T E C H N I C A L S P E C I F I C AT I O N S Thank you for making Stanton your first choice in professional DJ mixers. Line inputs: 2 (RCA) x 2 channels, -10 dBV / 37 kOhm Phono inputs: 2 (RCA) x 2 channels, -50 dBV / 47 kOhm This innovative family of mixers has been developed with input from the Aux inputs: 2 (RCA) -10 dBV /22 kOhm professional DJ community, bringing to the marketplace a previously unavailable, Return inputs: 2 (1/4"), -10 dBV / 22 kOhm affordable combination of user-frie

Inhaltszusammenfassung zur Seite Nr. 3

FADER CLEANING AND REPLACEMENT SA-12 FUNCTIONS & FEA T U R E S 6.5) Insert dust cover. 6.6) Insert fader track back into fader body with The SA-8 DJ Focus Signature Mixer wires coming out open end of fader body. G 6.7) Secure the remaining end block ensuring that "From the mind of focus" comes the SA-8, the ultimate performance mixer. Never the track wires (I) are not pinched between the before has so much scrutiny been put into the layout of a scratch mixer, each fea- end block and fader casing

Inhaltszusammenfassung zur Seite Nr. 4

FADER CLEANING AND REPLACEMENT DESCRIPTION OF FUNCTIONS CLEANING A P&G FADER: 1. Remove 2 mounting screws from fader plate. (NOTE: The P&G fader is designed with floating mounting threads for precise mechanical centralizing of the fader. If you desire to keep your fader`s current mounting position we suggest that you make 2 marks on both ends of the fader on the fader plate to indicate the P&G fader position.) See Figure 1. A 2. Once fader is removed from unit, remove the two screws (A) from the

Inhaltszusammenfassung zur Seite Nr. 5

FADER CLEANING AND REPLACEMENT DESCRIPTION OF FUNCTIONS After constant scratch use the SA-8 faders may need to be cleaned and lubri- cated from time to time. This will ensure long life and keep a smooth feeling throughout the fader's lifetime. Follow the instructions below to lubricate and clean your faders: REMOVING A FADER 1. Make sure mixer is powered off and power supply is disconnected from back of mixer. 2. To remove the lower faceplate, take off all the fader knobs and then remove the 4

Inhaltszusammenfassung zur Seite Nr. 6

DESCRIPTION OF FUNCTIONS on a channel the mixer is close to clip- of any effects processing device. The signal that is selected by the FX On/Off ping (distorting) the audio signal and the gains should be turned down. switches (14) will be sent though the FX send. (23) Phones – Standard 1/4” & 1/8” headphone output connectors. (35) FX Return – Connects to the out- put of the same effects processor to (24) Reverse – Reverses the direction complete the effects loop. In order to of each respective l