Inhaltszusammenfassung zur Seite Nr. 1
™
PresentationPro
Public Address System
Owner’s Manual
PA300+UHF Wireless
PA300+ Wired
MB-350
wall/tripod mounting
bracket and TP-30 tripod
califone.com
sold seperately
Inhaltszusammenfassung zur Seite Nr. 2
™ PresentationPro Owner’s Manual Thank you for purchasing this PresentationPro™ (PA300+UHF or PA300+), the most versatile and portable PA for use in school, business, Houses of Worship and government facilities. I invite you to register your product online for its limited six year warranty coverage at our website: www.califone.com — while you’re there — make sure to visit our complete line of multimedia players and recorders, wired and wireless headphones and headsets, computer peripherals,
Inhaltszusammenfassung zur Seite Nr. 3
PA300+UHF Shown Recommended Set-up Procedure Ideally volume on the unit should be set at maximum before the microphone volume is adjusted to the desired level. Turn on the main power switch and use either a wireless microphone or cabled microphone to adjust the volume. Operating The Sound System • Place the PresentationPro at its desired location. • CAUTION: Assure the 120/240 switch is in the correct position. • Plug the power cord into a grounded 120 volt, 60 Hz outlet. • Connect and audio
Inhaltszusammenfassung zur Seite Nr. 4
Wireless Receiver (PA300+UHF only) continued from page 2 d) It is very important to ensure that the channel number selected on the PA300+UHF is the same as the channel number selected on the mic. The channel indicator can be found on the Belt Pack Transmitter (M316) in the case of neckband & clip on wireless mics & on the handle of the wireless handheld mic. e) It is advisable to ALWAYS have spare batteries handy for the Belt pack Transmitters and Handheld radio mic. Nothing is
Inhaltszusammenfassung zur Seite Nr. 5
Mic Input (Balanced) Use this input for a dynamic (low impedance) microphone with an XLR plug. Condenser/electret (high impedance) microphones which may need phantom (polarizing) voltage. Mic Impedance Switch This switch is used to compensate for mic impedance differences. It assures full amplifier output regardless of the microphone used. Note: All connections must be made with shielded cable to avoid hum, buzzing, or radio interference. LED There are 3 LED indicator lights behind the spea
Inhaltszusammenfassung zur Seite Nr. 6
Accessories Wired Microphones PADM-515 Dynamic, balanced, low impedance (50 ohms) with a cardiod pick-up pattern and comes with a 20’ cable with XLR phone plug. PADM-510 Dynamic, unbalanced, high impedance (500 ohms) with a cardiod pick-up pattern and comes with a 20’ cable with a ¼” phone plug. PADM-510 Dynamic, unbalanced, high impedance (500 ohms) with a cardiod pick-up pattern and comes with a 20’ cable with a ¼” phone plug. Wireless Microphones (for use with PresentationPro+UHF only)
Inhaltszusammenfassung zur Seite Nr. 7
Specifications Rated power output: 30 watts RMS at 2% THD Sensitivity for rated output: Line: 125 mVrms Microphone:: 4 mVrms Auxiliary: 250 mVrms Frequency response: 60 Hz – 20 kHz+ 3dB Treble: +dB, -10dB, 10kHz Bass: +5dB, -4.5dB 70Hz Speakers: Woofer: 6” High efficiency 4oHms, with non inductive external shield Tweeter: 2” mylar dome, with crossover capacitor Crossover: L/C – 6dB/Octave @ 4kHz Volume control: Steps up/down 4.5 dB per step. 10 steps to maximum
Inhaltszusammenfassung zur Seite Nr. 8
CAUTION RISK OF ELECTRIC SHOCK - DO NOT OPEN ! CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QAULIFIED PERSONNEL. The exclamation point within a The lightening flash with arrowhead triangle is intended to tell the user within a triangle is intended to tell that important operating and servicing the user that parts inside the product instructions are in the papers with ! are a risk of electric shock to perso