Inhaltszusammenfassung zur Seite Nr. 1
L5AF2_US.book 1 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分
INSTRUCTION MANUAL
VCC-3944
COLOR CCD camera
About this manual
Before installing and using the camera, please read this manual carefully. Be sure to keep it handy for later reference.
Inhaltszusammenfassung zur Seite Nr. 2
L5AF2_US.book 1 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分 Depending on the conditions of use, installation and FEATURES environment, please be sure to make the appropriate settings and adjustments. If you need help with installation and/or settings, please consult your dealer. • Built-in interline transfer method 1/4" CCD, approx. 270,000 picture elements Equipped with a DSP (Digital Signal Processor) function CONTENTS Horizontal resolution, more than 350 TV lines High sensitivity, minimum
Inhaltszusammenfassung zur Seite Nr. 3
L5AF2_US.book 2 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分 INFORMATIN TO USER This equipment has been tested and found to comply with the Safety Guard limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. THIS SYMBOL INDICATES THAT THERE ARE These limits are designed to provide reasonable protection IMPORTANT OPERATING AND MAINTENANCE against harmful interference in a residential installation. This INSTRUCTIONS IN THE LITERATURE equipment generates, uses, and can radiate radio fre
Inhaltszusammenfassung zur Seite Nr. 4
L5AF2_US.book 3 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分 PRECAUTIONS In case of problem Protect from humidity and dust Do not use the camera if smoke or a strange odour comes To prevent damages to the camera, do not install it where from the unit, or if it seems not to function correctly. Disconnect there is greasy smoke or steam, where the dampness may get the power cord immediately, and consult your dealer (or a too high, or where there is a lot of dust. Sanyo Authorized Service
Inhaltszusammenfassung zur Seite Nr. 5
L5AF2_US.book 4 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分 PARTS NAMES 1 Flange-back lock screw (LOCK) 2 Flange-back adjustment dial 2 3 Lens mount cap The cap is installed to protect the lens mount section. Remove the lens mount cap before installing a lens (sold separately). 4 Camera installation bracket 3 The bracket can be fixed at the top or bottom of the camera. When fixing the bracket, be sure to 1 use the longer screws and install the shorter screws on the opposite side to seal the openings.
Inhaltszusammenfassung zur Seite Nr. 6
GB.fm 5 ペー ジ ２０ ０２年 １２月 ２０日 金曜 日 午 後２時 ２分 PARTS NAMES 5 Camera setup section 6 White balance adjustment volume (WB R or B) 9 7 Line phase adjustment volume (PHASE) 8 Lens iris adjustment volume (LEVEL) 9 Lens iris output connector (LENS) This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type 8 7 lens. 6 F Video output connector (VIDEO OUT: BNC type) 5 Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector. G 24 V AC or
Inhaltszusammenfassung zur Seite Nr. 7
L5AF2_US.book 6 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分 MOUNTING THE LENS Please use a DC type auto-iris lens (sold separately). 1 Check the lens mount Do not use a lens if the length “L” is more than 5 mm. That may damage the camera and prevent proper installation. C mount type lens L 2 1 Remove the lens mount cap from the camera. 2 Install the auto-iris lens. CS mount type lens Carefully align the lens mount with the camera opening, then turn the lens slowly to install it. C mount type lens 3 To
Inhaltszusammenfassung zur Seite Nr. 8
L5AF2_US.book 7 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分 MOUNTING THE LENS Pin layout DC type lenses 2 1 1 Brake coil (–) 2 Brake coil (+) 4 3 3 Drive coil (+) 4 Drive coil (–) Flange-back adjustment If the pick-up surface is not correctly positioned with relation to the lens focal point, the picture 3 will be out of focus (in particular when using auto-iris power zoom lenses, sold separately). If that is the case, adjust the flange-back position as described below. 1 Using a + scr
Inhaltszusammenfassung zur Seite Nr. 9
L5AF2_US.book 8 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分 CONNECTIONS 1 24 V AC connection 12 V DC connection (A) GND AC24V GND AC24V DC12V DC12V Figure 1 Figure 2 (Video signal connections) : VIDEO IN : VIDEO OUT Basic connection for monitoring or recording The peripheral devices (VCR, monitor, lens, etc.), AC 3 Insert the plug of this power cord into a wall outlet. adaptor and cables are sold separately. The POWER indicator (A) will light. Adjust the picture on the monitor using the
Inhaltszusammenfassung zur Seite Nr. 10
L5AF2_US.book 9 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分 SETTINGS Camera setup section No. Settings Position Electronic Iris (EI)/Auto iris (AI) setting 1 AI Gain up setting 2 NORM HI (High)/NORM (Normal) Backlight compensation mode setting (BLC) 3 OFF MULTI (Multi)/OFF 7 Backlight compensation mode setting (BLC) 4 OFF CENT (Center)/OFF White balance setting 5 ATW MANU (manual)/ATW (auto tracing white balance) 123456 Syncronisation (SYNC) setting 6 INT LL (Line lock)/INT (Internal
Inhaltszusammenfassung zur Seite Nr. 11
L5AF2_US.book 10 ペー ジ ２ ００２ 年１２ 月２０ 日 金 曜日 午後１ 時４８ 分 SETTINGS Iris function setting 1 1 1 1 When using an auto-iris lens (for indoor/ This should normally be set to the down (AI) position. outdoor use) Use a manual or fixed iris lens and set the lens aperture to the Set the switch 1 to the down (AI) position. shortest F stop. Set the switch 1 to the up (EI) position. CAUTION: EI If conditions are outside the electronic iris operation range or more than the maximum illumination, it w
Inhaltszusammenfassung zur Seite Nr. 12
L5AF2_US.book 11 ペー ジ ２ ００２ 年１２ 月２０ 日 金 曜日 午後１ 時４８ 分 SETTINGS (MULTI mode: 64 sections) Backlight compensation setting 3 3 3 3 4 4 4 4 This camera has two different backlight correction functions: multi-spot MULTI CENT photometry (MULTI) and center focus photometry (CENT). The normal setting (switch 3 and 4) is the down position, 34 but you can change the switch 3 or 4 setting in accordance with the backlight conditions. MULTI mode: Use this position when applying backlight
Inhaltszusammenfassung zur Seite Nr. 13
GB.fm 12 ペー ジ ２ ００２ 年１２ 月２０ 日 金 曜日 午後２ 時３５ 分 SETTINGS White balance adjustment 5555 Line phase adjustment 6666 Normally the switch 5 is set to the down (ATW: auto white When using a camera switcher to connect 2 cameras or more balance) position and the white balance is adjusted to one monitor, there may be a vertical roll of the images when automatically. If a manual white balance adjustment is switched. In such a case, set as described below. necessary, follow the steps bel
Inhaltszusammenfassung zur Seite Nr. 14
L5AF2_US.book 13 ペー ジ ２ ００２ 年１２ 月２０ 日 金 曜日 午後１ 時４８ 分 SETTINGS Lens iris adjustment 7 7 7 7 If using a DC type auto-iris lens, you will need to set the LEVEL volume when shooting in the conditions described below. LH LEVEL L (counterclockwise): To decrease the contrast H (clockwise): To increase the contrast If shooting simultaneously in a dark room and through a bright window. If the subject background is extremely bright or dark. If the brightness of the picture on the monit
Inhaltszusammenfassung zur Seite Nr. 15
L5AF2_US.book 14 ペー ジ ２ ００２ 年１２ 月２０ 日 金 曜日 午後１ 時４８ 分 TROUBLESHOOTING Before taking the camera for repairs, please check below to make sure that the camera is used correctly. If it still does not perform correctly, please consult your dealer or a Sanyo Authorized Service Centre. No picture on the monitor screen Is the power turned on to all connected devices? Is the voltage correct? Are all the signal connecting cables correctly connected? Is the lighting sufficient? Has the l
Inhaltszusammenfassung zur Seite Nr. 16
L5AF2_US.book 15 ペー ジ ２ ００２ 年１２ 月２０ 日 金 曜日 午後１ 時４８ 分 SPECIFICATIONS Camera: Lens mount : CS mount Environmental conditions : Temperature: –10°C – +50°C Scanning system : NTSC standard Humidity: less than 90% (525 TV lines, 30 frames/sec.) (no condensation) Interlace : PLL 2:1 interlace Power supply : 24 V AC, 60 Hz/12 V – 15 V DC Image device : 1/4 inch solid state image Power consumption : Approx. 2.8 W (with AI, lens) device CCD Approx. 2.1 W (without AI, lens) Picture elements :
Inhaltszusammenfassung zur Seite Nr. 17
L5AF2_US.book 16 ペー ジ ２ ００２ 年１２ 月２０ 日 金 曜日 午後１ 時４８ 分 SPECIFICATIONS Dimensions 108 56 1.4 99 45 10.7 16 M6 28 25.8 Features and specifications are subject to change without prior notice or obligations. 16 English
Inhaltszusammenfassung zur Seite Nr. 18
L5AF2_US.book 1 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分
Inhaltszusammenfassung zur Seite Nr. 19
L5AF2_US.book 2 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分 SANYO INDUSTRIAL VIDEO COLOR VIDEO CAMERA LIMITED WARRANTY OBLIGATIONS In order to obtain warranty service, the product must be delivered to and picked up from an Authorized Sanyo Service Center at the user’s expense, unless specifically stated otherwise in this warranty. The names and addresses of Authorized Sanyo Service Centers may be obtained by calling the toll-free number listed below. For product operation, authorized
Inhaltszusammenfassung zur Seite Nr. 20
L5AF2_US.book 3 ページ ２０ ０２年 １２月 ２０日 金曜 日 午 後１時 ４８分 Printed on recycled paper Sanyo Electric Co, Ltd. 1AC6P1P2620-- Printed in Japan L5AF2/US (0103KPS-CZ)
