Inhaltszusammenfassung zur Seite Nr. 1
WhaleII_general-copy_SEC.book 1 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分
MODEL
AR-BC320
DIGITAL FULL COLOR MULTIFUNCTIONAL
SYSTEM
OPERATION MANUAL
(for general information and copier operation)
Page
• BEFORE USING
THE PRODUCT 1-1
• MANAGING THE MACHINE 2-1
• PERIPHERAL DEVICES 3-1
• BEFORE MAKING
COPIES 4-1
• BASIC PROCEDURE
FOR MAKING COPIES 5-1
• CONVENIENT COPY
FUNCTIONS 6-1
• MACHINE MAINTENANCE
(FOR COPYING) 7-1
• SPECIFICATIONS 8-1
Be sure to become thoroughly familiar with this manual
Inhaltszusammenfassung zur Seite Nr. 2
WhaleII_general-copy_SEC.book 1 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 The power switch positions are marked " I " to indicate power "ON" and " " to indicate stand-by. In the stand-by position, power is being supplied to a drying heater within the optical system of the copier. Caution: For complete electrical disconnection, pull out the main plug. The socket-outlet shall be installed near the equipment and shall be easily accessible. FOR YOUR RECORDS ... To protect against loss or theft, record an
Inhaltszusammenfassung zur Seite Nr. 3
WhaleII_general-copy_SEC.book 1 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 Part 1: General Information
Inhaltszusammenfassung zur Seite Nr. 4
WhaleII_general-copy_SEC.book 2 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分
Inhaltszusammenfassung zur Seite Nr. 5
sec_whale_00.fm 1 ペー ジ ２ ００４ 年１１ 月１６ 日 火 曜日 午後１ 時８分 NOTES Considerable care has been taken in preparing this manual. If you have any comments or concerns about the manual, please contact your nearest SHARP Service Department. This product has undergone strict quality control and inspection procedures. In the unlikely event that a defect or other problem is discovered, please contact your dealer or nearest SHARP Service Department. Aside from instances provided for by law, SHARP is not r
Inhaltszusammenfassung zur Seite Nr. 6
WhaleII_general-copy_SEC.book 2 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 INSTALLATION REQUIREMENTS Improper installation may damage this product. Please note the following during initial installation and whenever the machine is moved. 1. The machine should be installed near an accessible power outlet for easy connection. 2. Be sure to connect the power cord only to a power outlet that meets the specified voltage and current requirements. Also make certain the outlet is properly grounded. For the p
Inhaltszusammenfassung zur Seite Nr. 7
WhaleII_general-copy_SEC.book 3 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 INSTALLATION REQUIREMENTS Moving this machine Pull out the four handles as shown below, grasp them firmly, and keep the machine horizontal while moving it. Left side Right side Exit Bypass tray tray Handles Handles Before lifting the machine, Before lifting the machine, fold up the exit tray and fold up the bypass tray tape it securely to the and tape it securely to the machine. machine. Caution Two people are required to lif
Inhaltszusammenfassung zur Seite Nr. 8
WhaleII_general-copy_SEC.book 4 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 CAUTIONS 1. Do not touch the photoconductive drum. Scratches or smudges on the drum will cause dirty prints. 2. The fusing unit is extremely hot. Exercise care in this area. 3. Do not look directly at the light source. Doing so may damage your eyes. Fusing unit 4. Four adjusters are provided on all optional stand/ paper drawer units. These adjusters should be lowered until they contact the floor. When moving the machine with
Inhaltszusammenfassung zur Seite Nr. 9
WhaleII_general-copy_SEC.book 5 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 CONTENTS OPERATION MANUALS.................................................0-1 CHAPTER 3 INSTALLATION REQUIREMENTS.................................0-2 PERIPHERAL DEVICES Moving this machine..................................................0-3 CAUTIONS......................................................................0-4 SADDLE STITCH FINISHER ......................................... 3-2 Part names and functions ........
Inhaltszusammenfassung zur Seite Nr. 10
WhaleII_general-copy_SEC.book 6 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 CONTENTS IMAGE EDIT MENU ..................................................... 6-16 CHAPTER 4 Single color ............................................................. 6-17 BEFORE MAKING COPIES Mirror image............................................................ 6-17 Photo Repeat .......................................................... 6-18 PART NAMES AND FUNCTIONS (The Reversing Automatic Multi shot............
Inhaltszusammenfassung zur Seite Nr. 11
WhaleII_general-copy_SEC.book 1 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 CHAPTER 1 BEFORE USING THE PRODUCT This chapter contains basic information that should be read before using the product. Page INTRODUCTION ...........................................................................................1-2 MAIN FEATURES..........................................................................................1-2 PART NAMES AND FUNCTIONS ................................................................
Inhaltszusammenfassung zur Seite Nr. 12
WhaleII_general-copy_SEC.book 2 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 INTRODUCTION To gain the maximum benefits in using this product, it is recommended that the user read this manual to become familiar with all the features and functions of the basic product and the precautionary information contained in the manual. This product is a high speed Digital full color copier / printer that can be expanded to become multifunctional through the installation of optional peripheral devices. The product c
Inhaltszusammenfassung zur Seite Nr. 13
sec_whale_01_1.fm 3 ページ ２００ ４年９ 月１７ 日 金 曜日 午前１ １時３ 分 MAIN FEATURES Advanced image processing features based on digital technology 3 The scanned image data is converted to digital data, enabling the following advanced image processing features: Photo Repeat : Up to 24 full-size copies of a photo image can be made on a single sheet of paper (page 6-18). Multi shot : Up to four original pages can be copied onto a single sheet (page 6-19). 1 Pamphlet copy* : Copies of original page
Inhaltszusammenfassung zur Seite Nr. 14
sec_whale_01_1.fm 4 ページ ２００ ４年９ 月１６ 日 木 曜日 午前１ ０時３ ５分 PART NAMES AND FUNCTIONS Exterior Left tray (See page 5-5) Bypass tray Finished sheets are deposited here. Special papers (including transparency film) and copy paper can be fed from the bypass tray. Left side cover Stand/1 x 500 sheet paper drawer* Open this cover when a paper misfeed occurs in the fusing unit or the transfer unit. (See page 2-7) Reversing automatic document feeder Stand/3 x 500 sheet paper drawer* (See page 4-2) (See pag
Inhaltszusammenfassung zur Seite Nr. 15
WhaleII_general-copy_SEC.book 5 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 PART NAMES AND FUNCTIONS Interior 1 Fusing unit Toner cartridge Toner images are fused here. The toner cartridge must be replaced when indicated on the operation panel. (See page 2-15) Right side cover CAUTION Open when a misfeed has occurred in the paper feed area. The fusing unit is hot. Take care in removing misfed paper. Right cover of paper drawer Open this cover to remove paper misfed in the paper drawer. 1-5
Inhaltszusammenfassung zur Seite Nr. 16
WhaleII_general-copy_SEC.book 6 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 PART NAMES AND FUNCTIONS Part names and functions of peripheral devices Large Capacity tray (AR-LC8) Stand/3 x 500 sheet paper drawer (AR-D18N) The large capacity tray provides the added This stand has three paper trays. Each tray can convenience of having 3,500 sheets of 8-1/2" x 11" hold approximately 500 sheets of the 2 2 or A4 paper (21 lbs. or 80 g/m ) available. recommended paper for color (21 lbs. or 80 g/m ), or approxi
Inhaltszusammenfassung zur Seite Nr. 17
WhaleII_general-copy_SEC.book 7 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 PART NAMES AND FUNCTIONS Other optional equipment PS3 expansion kit (AR-PK4) Facsimile expansion kit (AR-FX10) This kit provides compatibility of PostScript level 3 This kit must be installed to use the fax function. to the printer. Fax memory (8 MB) (AR-MM9) This adds memory for use by the fax function. 1 256 MB optional memory (AR-SM5) This adds memory that is used for the copy function, printer f
Inhaltszusammenfassung zur Seite Nr. 18
WhaleII_general-copy_SEC.book 8 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 PART NAMES AND FUNCTIONS Operation panel Touch panel Numeric keys The machine status, messages and touch keys are Use to enter number values for various settings. displayed on the panel. When using the touch [ ] key ([ACC.#-C] key) panel, first change the display to the mode that you This is used when the copy, network scan, and fax* wish to use: printer mode, copy mode, network functions are used. scanner mode, or fax mode*. F
Inhaltszusammenfassung zur Seite Nr. 19
WhaleII_general-copy_SEC.book 9 ページ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 PART NAMES AND FUNCTIONS Touch panel Using the touch panel Selection of function [Example 1] [Example 1] Items on the touch panel Items which are CANCEL OK JOB QUEUE SETS / PRO are easily selectable by highlighted at the time a COPY 003 / 00 LEFT RIGHT touching the key screen appears are 1 BINDING BINDING associated with the item Suzuki 003 / 00 already selected and will with a finger. Selection be registered to function if 06
Inhaltszusammenfassung zur Seite Nr. 20
WhaleII_general-copy_SEC.book 10 ペー ジ ２０ ０４年 ９月１ ４日 火曜日 午前 １１時 ４５分 PART NAMES AND FUNCTIONS Job status screen (common to print, copy, network scan and fax) This screen is displayed when the [JOB STATUS] key on the operation panel is pressed. A job list showing the current job at the top of the job queue or a list showing completed jobs can be displayed. The contents of jobs can be viewed or jobs can be deleted from the queue. (The screen below is an example and differs from actual screens.)
