Inhaltszusammenfassung zur Seite Nr. 1
Basic Useful
Introduction Quick Start Setup Connections Appendix
Operation Features
MULTIMEDIA PROJECTOR
MODEL
XG-MB67X-L
OPERATION MANUAL
XG-MB67XL_EN_CD__cover 7 06.9.11, 6:53 AM
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT • For your assistance in reporting the loss Model No.: or theft of your Projector, please record the Model and Serial Number located on the bottom of the projector and retain this Serial No.: information. • Before recycling the packaging, please ensure that you have checked the con- tents of the carton thoroughly against the list of “Supplied accessories” on page 11. ii XG-MB67XL_EN_CD_a 2 06.9.11, 6:42 AM
Inhaltszusammenfassung zur Seite Nr. 3
SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporat- ing a 10A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted. In the unlikely event of the socket outlet in your home not being comp
Inhaltszusammenfassung zur Seite Nr. 4
The supplied CD-ROM contains operation instructions in English, German, French, Swedish, Spanish, Italian, Dutch, Portuguese, Chinese and Korean. Carefully read through the operation instructions before operating the projector. Die mitgelieferte CD-ROM enthält Bedienungsanleitungen in Englisch, Deutsch, Französisch, Schwedisch, Spanisch, Italienisch, Niederländisch, Portugiesisch, Chinesisch und Koreanisch. Bitte lesen Sie die Bedienungsanleitung vor der Verwendung des Projektors sorgfältig durc
Inhaltszusammenfassung zur Seite Nr. 5
Introduction Before using the projector, please read this operation manual carefully. Introduction ENGLISH There are two important reasons for prompt warranty registration of your new SHARP Projector, using the REGISTRATION CARD packed with the projector. 1. WARRANTY This is to assure that you immediately receive the full benefit of the parts, service and labor warranty applicable to your purchase. 2. CONSUMER PRODUCT SAFETY ACT To ensure that you will promptly receive any safety notification of
Inhaltszusammenfassung zur Seite Nr. 6
The enclosed computer cable must be used with the device. The cable is provided to ensure that the device complies with FCC Class A verification. U.S.A. ONLY WARNING: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. WARNING: The cooling fan in this projector continues to run for about 90 seconds after the projector enters standby mode. During normal operation, when putting the projecto
Inhaltszusammenfassung zur Seite Nr. 7
Introduction How to Read this Operation Manual • In this operation manual, the illustration and the screen display are simplified for explanation, and may differ slightly from the actual display. Using the Menu Screen ENTER button Adjustment buttons (P/R/O/Q) MENU/HELP button Adjustment buttons (P/R/O/Q) MENU/HELP button ENTER button Buttons used in RETURN button this operation • Press lRETURN to return to the previous screen when the menu is displayed. Menu Selections (Adjustments) Example: Adj
Inhaltszusammenfassung zur Seite Nr. 8
Contents Preparing Introduction Setup How to Read this Operation Manual .... 3 Setting up the Projector ...................... 18 Setting up the Projector ....................... 18 Contents ............................................... 4 Standard Setup (Front Projection) ....... 18 IMPORTANT SAFEGUARDS ............... 6 Ceiling-mount Setup ............................ 18 How to Access the PDF Operation Projection (PRJ) Mode ......................... 19 Manuals ................................
Inhaltszusammenfassung zur Seite Nr. 9
Introduction Reference Appendix Computer Compatibility Chart ............ 60 Troubleshooting .................................. 61 Maintenance ....................................... 52 For SHARP Assistance ...................... 63 Cleaning and Replacing the Dust Specifications ..................................... 64 Filters ................................................ 53 Dimensions ......................................... 65 Maintenance Indicators ...................... 55 Index ........
Inhaltszusammenfassung zur Seite Nr. 10
IMPORTANT SAFEGUARDS CAUTION: Please read all of these instructions before you operate this product and save these instructions for later use. Electrical energy can perform many useful functions. This product has been engineered and manufactured to assure your personal safety. BUT IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. In order not to defeat the safeguards incorporated in this product, observe the following basic rules for its installation, use and servicing. 1. R
Inhaltszusammenfassung zur Seite Nr. 11
Introduction 15. Overloading 19. Replacement Parts Do not overload wall outlets, extension cords, or When replacement parts are required, be sure integral convenience receptacles as this can the service technician has used replacement result in a risk of fire or electric shock. parts specified by the manufacturer or have the same characteristics as the original part. 16. Object and Liquid Entry Unauthorized substitutions may result in fire, Never push objects of any kind into this product electr
Inhaltszusammenfassung zur Seite Nr. 12
Observe the following safeguards when setting up your projector. Caution concerning the lamp unit When using the projector in high-altitude Potential hazard of glass par- areas such as mountains (at altitudes of ticles if lamp ruptures. In approximately 1,500 meters (4,900 feet) case of lamp rupture, contact or more) your nearest Sharp Autho- When you use the projector in high-altitude rized Projector Dealer or Ser- areas with thin air, set “Fan Mode” to “High”. vice Center for replacement.
Inhaltszusammenfassung zur Seite Nr. 13
Introduction When turning off the projector, the cooling fan Using the projector in other countries runs to decrease the internal temperature for The power supply voltage and the shape of a while. Unplug the power cord after the cool- the plug may vary depending on the region ing fan stops. The period the cooling fan runs or country you are using the projector in. will vary, depending on the circumstances and When using the projector overseas, make the internal temperature. sure you use an a
Inhaltszusammenfassung zur Seite Nr. 14
How to Access the PDF Operation Manuals PDF operation manuals in several languages are included in the CD-ROM. To uti- ® ® lize these manuals, you need to install Adobe Reader on your computer (Win- ® ® dows or Macintosh ). ® ® Please download Adobe Reader from the Internet (http://www.adobe.com). Accessing the PDF Manuals ® ® For Windows : For Macintosh : 1 Insert the CD-ROM in the CD-ROM drive. 1 Insert the CD-ROM in the CD-ROM drive. 2 Double click the “My Computer” icon. 2 Double click the “
Inhaltszusammenfassung zur Seite Nr. 15
Introduction Accessories Supplied accessories Two R-6 batteries RGB cable Lens cap (attached) Remote control (“AA” size, UM/SUM-3, (10' (3.0 m)) CCAPHA024WJSA RRMCGA398WJSA HP-7 or similar) QCNWGA045WJPZ DIN-D-sub RS-232C adaptor 57 / " (15 cm)) (5 64 QCNWGA015WJPZ Power cord* (1) (2) (3) (4) For U.S. and For Europe, For U.K. and For Australia, New Canada, etc. except U.K. Singapore Zealand and Oceania (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) QACCDA007WJPZ QACCVA011WJPZ QACCBA036WJPZ
Inhaltszusammenfassung zur Seite Nr. 16
Part Names and Functions Numbers in Z refer to the main pages in this operation manual where the topic is explained. Projector Top View Power Lamp indicator 29, 55 28, 55 indicator Temperature warning 55 indicator STANDBY/ 28, 29 ON button For turning the power on and Volume buttons 32 putting the (–O/Q+) projector into For adjusting the speaker standby sound level. mode. INPUT button (P/R) 32 ENTER button 40 For switching input mode For setting 1, 2, 3 or 4. items selected or adjusted on the me
Inhaltszusammenfassung zur Seite Nr. 17
Introduction Numbers in Z refer to the main pages in this operation manual where the topic is explained. Rear View Refer to “INPUT Terminals and Connectable Main Equipment” on page 21. Terminals OUTPUT (INPUT 1, 2) 25 INPUT 3 terminal 24 terminal Terminal for connect- (Shared computer RGB and component ing video equipment signals output terminal for INPUT 1 and 2) with an S-video Terminal for connecting a monitor. terminal. AUDIO (INPUT 1, 2) 23 RS-232C 26 terminal (Shared for terminal 24 INPUT
Inhaltszusammenfassung zur Seite Nr. 18
Part Names and Functions (Continued) Numbers in Z refer to the main pages in this operation manual where the topic is explained. ON button STANDBY button 29 28 For turning the power on. For putting the projector into the standby mode. MENU/HELP button 40 For displaying adjustment KEYSTONE button 33 51 and setting screens, and For entering the help screen. Keystone Correction mode. RETURN button 40 Adjustment buttons 40 For returning to the (P/R/O/Q) previous menu screen • For selecting menu item
Inhaltszusammenfassung zur Seite Nr. 19
Introduction Inserting the Batteries Press the P mark on the cover and slide it in the 1 direction of the arrow. Insert the batteries. 2 • Insert the batteries making sure the polarities correctly match the m and n marks inside the battery compartment. Attach the cover and slide it until it clicks into place. 3 Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below. Caution • Danger of explosion if battery is incorrectly replaced. Replace only with
Inhaltszusammenfassung zur Seite Nr. 20
Quick Start This section shows the basic operation (projector connecting with the computer). For details, see the page described below for each step. Setup and Projection In this section, connection of the projector and the computer is explained using one example. 3 STANDBY/ON STANDBY button 8 8 button INPUT button 6 ON button 3 ENTER button 4 Adjustment buttons 7 KEYSTONE button 7 (P/R/O/Q) ENTER button KEYSTONE 4 7 button Adjustment buttons 7 (P/R/O/Q) Focus ring 4 HEIGHT INPUT 1 button 4 6 AD
