Inhaltszusammenfassung zur Seite Nr. 1
R
MT1192
19'' Color Television
Owner's Manual
®
As an ENERGY STAR Partner, MEMCORP has
®
determined that this product meets the ENERGY STAR
guidelines for energy efficiency.
Inhaltszusammenfassung zur Seite Nr. 2
BEFORE YOU OPERATE YOUR NEW TELEVISION To get the most from your new color television, read and follow this Owner's Manual carefully. INSTALLATION GUIDELINES Place your TV in a room with adequate ventilation. Keep your TV set away from sources of direct heat, such as heat registers or direct sunlight. Do not place your TV on soft surfaces, such as rugs or blankets. Leave enough room for air to circulate around the bottom, top and back of the set. ANTENNA CONNECTIONS For best picture
Inhaltszusammenfassung zur Seite Nr. 3
FEATURES On-screen graphics guide you through setup features and operations Automatic programming of channels allows easy selection of stations available in your viewing area Sleep timer programs the TV to turn itself off at a preset time One day timer programs the TV to come on once at a preset time Weekly timer programs the TV to come on at a preset time every day 26-button infrared remote control allows remote operation VHF/UHF/CATV tuning allows reception of standard broa
Inhaltszusammenfassung zur Seite Nr. 4
LOCATION OF CONTROLS 9 3 8 7 5 4 2 1 6 1 POWER SWITCH 1 2 CHANNEL (UP) BUTTON 2 3 CHANNEL (DOWN) BUTTON 3 4 VOLUME 4 (UP) BUTTON 5 VOLUME (DOWN) BUTTON 5 6 REMOTE CONTROL SENSOR 6 7 AUDIO IN (PUT) JACK 7 9 8 VIDEO IN (PUT) JACK 8 9 VHF / UHF EXT. A
Inhaltszusammenfassung zur Seite Nr. 5
REMOTE CONTROL T T
Inhaltszusammenfassung zur Seite Nr. 6
Inhaltszusammenfassung zur Seite Nr. 7
ANTENNA CONNECTIONS If you are using an indoor or outdoor antenna (antennas no included) follow the instructions below that correspond to your antenna system. If you are using a cable television service (CATV), refer to CATV connections. Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire) 75 ohm Connect the 75 ohm cable from combination VHF/UHF antenna to the OR ANT antenna jack. OR Transformer (not included) If your combination antenna has a 300 300 Ohm ohm twin-l
Inhaltszusammenfassung zur Seite Nr. 8
Some cable companies offer "premium pay" channels in which the signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device which is generally provided by the cable company. The illustrations below show how to connect these types of converter/descrambler devices with the TV's VHF antenna jack. You may need a two-set signal splitter (sometime called a "two-set coupler) and an A/B switch box from the cable installer or an electronic supply store.
Inhaltszusammenfassung zur Seite Nr. 9
input
Inhaltszusammenfassung zur Seite Nr. 10
SELECTING A LANGUAGE The menu screen that appears when you press the MENU button can be programmed to appear in English, French, or Spanish. Follow the directions below to program the menu screen to appear in a language other than the one that is now on-screen when you press the MENU button. 3 Press the MENU button until the menu 1 Press the MENU button to bring up the screen is in the language you want to menu-screen. select. MENU SUN - - : - - AM 4 Use the + or – button to highlight C
Inhaltszusammenfassung zur Seite Nr. 11
SETTING THE CLOCK 1 Press the MENU button twice to bring CLOCK SET up the menu screen and select CLOCK SET. TUE 1 : 35 AM EXIT CLOCK SET SUN - - : - - AM EXIT [MENU] : MOVE [+] / [-] : ADJUST 7 Press the MENU button to go to the [MENU] : MOVE [+] / [-] : ADJUST next step. 8 Use the + or – button to select AM or 2 Use the + or – button to select the PM. correct day of the week. CLOCK SET CLOCK SET TUE 1 : 35 PM TUE - - : - - AM EXIT EXIT [MENU] : MOVE [MENU] : MOVE [+] / [-
Inhaltszusammenfassung zur Seite Nr. 12
PROGRAMMING CHANNELS With automatic programming, the TV automatically places every channel you receive in its memory, allowing you to scan through those channels when you press the CHANNEL (Up/Down) buttons. With manual programming, you tell the TV what channels you want to scan through when you press the CHANNEL (Up/Down) buttons. Automatic Programming 1 Press the MENU button to bring up the 4 Use the + or – button to highlight menu screen. AUTO SEARCH. MENU TUE 1 : 35PM CH PROGRAM CLOCK
Inhaltszusammenfassung zur Seite Nr. 13
ADDING/DELETING CHANNELS Manual Programming Press the CHANNEL (Up or Down) 1 Press the MENU button to bring up the 5 button or Number buttons to select the menu screen. channel you want to add to or delete MENU TUE 1 : 35PM from the TV's memory. CLOCK SET PROGRAM TIMER V-BLOCK SET PICTURE ADJUST Press the + button to add the channel 6 CH PROGRAM LANGUAGE (it will turn white). Or, press the – EXIT button to delete the channel (it will turn [+] / [-] : MENU SELECT red). [MENU] : ENTER
Inhaltszusammenfassung zur Seite Nr. 14
SETTING THE TIMERS You can program your TV to turn on a specific channel at a preset time once (one day timer) or at the same time every day or every week (weekly timer). You also can program your TV to turn itself off after a specified amount of time (Sleep timer). ONE DAY TIMER One Day Timer ON TIME OFF TIME CH 1 Press the MENU button to bring up the - - : - - AM - - : - - AM 10 menu-screen. EXIT MENU TUE 1: 35PM [MENU] : MOVE CLOCK SET [+] / [-] : ADJUST PROGRAM TIMER V-BLOCK SET P
Inhaltszusammenfassung zur Seite Nr. 15
Weekly Timer 6 Use the + or – button to select the hour you want the timer to come on, 1 Press the MENU button to bring up the then press the MENU button. Use the menu screen. + or – button to select the minute(s) you want the timer to come on, then MENU TUE 1 : 35PM press the MENU button. Use the + or CLOCK SET PROGRAM TIMER – button to select AM or PM, then V-BLOCK SET PICTURE ADJUST press the MENU button. Follow the CH PROGRAM same steps to set the time off. LANGUAGE EXIT Use
Inhaltszusammenfassung zur Seite Nr. 16
Sleep Timer 2 Press the SLEEP button until the desired sleep time (10, 20, 30, 40, 50, 1 Press the SLEEP button to bring up the 60, 70, 80 or 90 minutes) appears on- sleep timer screen. screen. The timer will begin counting down to zero, and the on-screen display will disappear. When the timer SLEEP 00 reaches zero, the TV will turn itself off. SLEEP 60 NOTES To check the time remaining for a sleep timer, press the SLEEP button. The time remaining will appear on-screen. To cancel a sl
Inhaltszusammenfassung zur Seite Nr. 17
ADJUSTING THE PICTURE 1 Press the MENU button to bring up the 5 Use the + or – button to adjust the menu screen. picture. The bar scale at the bottom of the screen shows the level of MENU TUE 1 : 35PM adjustment. CLOCK SET PROGRAM TIMER 6 Press the MENU button until the V-BLOCK SET PICTURE ADJUST picture adjust screen appears. CH PROGRAM LANGUAGE 7 Use the + or – button to highlight EXIT EXIT, then press the MENU buton to [+] / [-] : MENU SELECT [MENU] : ENTER exit. PICTURE ADJUST 2
Inhaltszusammenfassung zur Seite Nr. 18
3190 – P17 CLOSED CAPTION MODE Close caption mode allows you to read the 1 Press the TV/CAP(tion)/Text button words of a broadcast on-screen while you until CAPTION or TEXT – whichever are hearing them. you want – appears in the lower right corner of the screen. There are two types of closed captioning: Captions – Dialogue and descriptions of the action appear in a box at the bottom of the screen. Text – Words appear on the screen. This is often used for channel guides. Often, you can acc
Inhaltszusammenfassung zur Seite Nr. 19
CABLE TV OPERATION 1 Press the MENU button to bring up the main menu screen. 2 Use the + or – button to highlight CH PROGRAM, then press the MENU button to select it. 3 Press the MENU button until CABLE appears to the right of AIR/CABLE. On CATV (Cable Television) systems, programs are brought into the home on VHF channels 2–13, mid-band channels A–I, super band channels J–W, hyper band channels AA–CCC, ultra band channels W+30–W+84 and sub midband channels (5A, A5–A1). When CATV is selected
Inhaltszusammenfassung zur Seite Nr. 20
SETTING V-BLOCK V-Block allow users to program their TV set to automatically block an incoming program that contains a particular level of violence, sexual content and strong language . User can easily block program based on the age based ratings, the content based ratings, or a combination of the two. 1 Press the MENU button to bring up the Press the MENU button. The OFF (or 5 menu-screen. ON) to the right of V-BLOCK will flash. MENU SUN 11:23 AM V-BLOCK SET CLOCK SET PROGRAM TIMER V
