Inhaltszusammenfassung zur Seite Nr. 1
UP354BH(WDECT2355+2) OM 5/14/04 12:04 PM Page a
WDECT
+
2355 2
Wide Band Digital
Technology provides
the clearest sound
and the best privacy.
Quick Start
Guide
Inhaltszusammenfassung zur Seite Nr. 2
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page i INSTALLATION & SAFETY Choosing the best location for your phone. When choosing a location for your phone there are a number of appliances the phone should not be near, and areas you should avoid. AVOID - CHARGE - Television sets and AVOID - the new phone other electronic Moisture for 15 - 20 hrs. appliances AVOID - Microwave ovens • This symbol AVOID - indicates important moisture operating and servicing instructions. Don’t - AVOID - overloa
Inhaltszusammenfassung zur Seite Nr. 3
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page ii QUICK START GUIDE This page is a very condensed version of the Owner’s Start Manual. It is designed to allow you to get your phone installed and operating as quickly as possible - Here! however it does not attempt to explain any of the advanced features of the WDECT2355 series. Installing the Base Unit 1) Connect the AC adapter to the DC IN 9V jack and to a standard AC wall outlet. 2) Connect the telephone line cord to the TEL LINE jack and to
Inhaltszusammenfassung zur Seite Nr. 4
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page iii 3) Set the base on a desk or tabletop. 4) Raise the antenna to a vertical position. Connecting the charger 1) Connect the AC adapter into the charging cradle and to a AC wall outlet. 2) Set the charger on a desk or tabletop. Installing the battery pack 1) Press down on the battery cover release and slide the • Charge the handset cover down until it comes off. battery pack for at least 15-20 hours before using your 2) Connect the battery plug t
Inhaltszusammenfassung zur Seite Nr. 5
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page iv Charging the handset(s) 1) Place the handset(s) in the main base unit or charging cradle with the keypad facing forward. Recharge your phone on a regular basis by returning the handset to the base after each phone call. 2) Make sure the charge LED illuminates. If the LED does not illuminate, check to see that the AC adapter is plugged in and that the handset makes good contact with the base charging contacts. During a power cut or if the AC ada
Inhaltszusammenfassung zur Seite Nr. 6
UP354BH(WDECT2355+2) OM 5/14/04 2:20 PM Page v CONTENTS INSTALLATION & SAFETY i PHONEBOOK 30 Phonebook 30 QUICK START GUIDE ii Storing Phone Numbers, Names, CONTENTS v Distinctive Rings, and Speed Dial 30 GETTING STARTED 1 Steps for Entering Names and Special Characters 32 Controls and Functions 1 Viewing the Phonebook 34 Uniden Company Philosophy 3 Making Calls Using the Phonebook 35 Speed Dialing 35 Welcome 3 Editing or Erasing a Stored Name, Features 4 Phone Number, Distinctive Ring, and
Inhaltszusammenfassung zur Seite Nr. 7
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page 1 CONTROLS AND FUNCTIONS 1. Handset Antenna 2. Headset Jack Cover 1 3. Beltclip Hole 4. Hands-Free Speaker 6 2 5. Handset Battery Compartment 7 6. New Message LED 3 7. Handset Earpiece 4 8 8. LCD Display 14 9. /del Key 15 9 10. /vol/ / Key 16 10 a. ringer volume control 17 b. scroll keys for display screen 5 11. Key 12. redial/pause Key 11 18 13. speaker Key 12 19 14. Key 13 20 15. Key 21 16. Key 22 17. Key Handset Remote Operation (P. 54) (Review
Inhaltszusammenfassung zur Seite Nr. 8
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page 2 Main Base 23 24 25 26 27 28 29 30 31 32 49 50 33 40 34 41 35 42 Charger Base 36 43 37 38 44 53 45 51 39 46 47 48 23. Base Speaker 35. Greeting Key 24. Clock/MENU Key 36. Mem Key 52 25. repeat/SELECT Key 37. Redial/p Key 26. delete Key 38. Flash Key 47. Key 27. Charge LED 39. Base Charging Contacts 48. Microphone 28. Message Counter Display 40. Intercom Key 49. DC IN 9V Jack 29. In use LED 41. Mute/find handset Key 50. TEL LINE Jack 30. play
Inhaltszusammenfassung zur Seite Nr. 9
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page 3 UNIDEN COMPANY PHILOSOPHY To bring outstanding wireless communication products to people’s lives throughout the world. WELCOME Congratulations on your purchase of the Uniden Multi-Handset Cordless System telephone. This unit is different from conventional cordless telephones. When the base unit is connected to AC power and a telephone line, it can support up to 4 handsets. Using extra handsets, you can establish a 3-way conference call (2 handse
Inhaltszusammenfassung zur Seite Nr. 10
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page 4 FEATURES Great features of this cordless phone include: • Designed and Engineered in Japan • Wide Band Digital Technology • Multi (4) Handset Capable • Digital Duplex Speakerphone on Handset Advanced Alpha Display Caller ID Features: • Alpha Memory Dialling • POP ID - Caller Name Identification* • 20 Individual Caller Allocations • 100 Caller ID* Memories with Phonebook • 3 Line Backlit Full Dot Matrix LCD Display with Clock • Maxi-Sound - Extra
Inhaltszusammenfassung zur Seite Nr. 11
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page 5 CHECKING THE PACKAGE CONTENTS Make sure you have received the following items in the package. If any of these items are missing or damaged, contact your retailer. • Base unit (1) • Handset (3) • AC adapter (3) • Rechargeable battery pack (3) • Line adapter (Australia only) (1) • Linecord (1) • Beltclip (3) • Charger (2) • Wall Mount Adapter (1) Also included: • This Owner’s Manual • Other Printed Material TERMINOLOGY Throughout this manual, term
Inhaltszusammenfassung zur Seite Nr. 12
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page 6 MOUNTING THE BASE UNIT ON A WALL You can mount your base directly to the wall. Before doing this, consider the following: • Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. • Mount your phone within distance of a working phone jack. • Make sure the wall material is capable of supporting the weight of the base and handset. • Use screws with anchoring devices
Inhaltszusammenfassung zur Seite Nr. 13
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page 7 BATTERY MAINTENANCE Battery use time (per charge) Fully charged • Up to 7 hours continuous use • Up to 10 days when the handset is in the standby mode (up to 15 hours when in DirectLink mode) Recharge your phone on a regular basis by returning the handset to the charger after each phone call. Low battery alert When the batteries are very low and need to be charged, the phone is programmed to eliminate functions in order to save power. The batte
Inhaltszusammenfassung zur Seite Nr. 14
UP354BH(WDECT2355+2) OM 5/14/04 10:48 AM Page 8 Battery replacement and handling When the operating time becomes short, even after a battery is recharged, please replace the battery. With normal usage, your battery should last about one year. Please contact your place of purchase or the Uniden Parts Department for a replacement battery. Caution • Use only the specified Uniden battery pack (BT-446). • Do not remove the batteries from the handset to charge them. • Never throw the battery into a
Inhaltszusammenfassung zur Seite Nr. 15
UP354BH(WDECT2355+2) OM 5/14/04 10:49 AM Page 9 HEADSET INSTALLATION (OPTIONAL) The headsets is used to make or receive a call. With the headset, you can have the convenience of hands free communication while using your cordless phone. 1) Place the headset on your head so the speaker covers your ear. The other end of the headset should rest comfortably against the side of your head above your ear. Do not place the end of the headband against the other ear. 2) The microphone arm swings over th
Inhaltszusammenfassung zur Seite Nr. 16
UP354BH(WDECT2355+2) OM 5/14/04 10:49 AM Page 10 ABOUT THE MENU OPTIONS There are 6 main menu options, (DirectLink Mode, Room Monitor, Handset Setup, Answ. Setup, Global Setup and System Reset) and submenu options. During Global Setup Summary of the Main Menu and Submenu and System Reset, make sure your cordless phone is in Two Way Communication between the Handsets Anywhere without the standby mode (not Base (DirectLink) in use), and all DirectLink Mode allows a pair of handsets to work wit
Inhaltszusammenfassung zur Seite Nr. 17
UP354BH(WDECT2355+2) OM 5/14/04 10:49 AM Page 11 Handset Setup The following submenu options must be set separately for each handset. Submenu name Description Ringer Tones Adjusting the ringer tone (tone your phone makes when ringing) (Default is Flicker) (see page 16). Set the distinctive ring (see page 16). “Distinctive Ring” allows you to preset memory locations with a designated ring tone. When an incoming call is received and the Caller ID information matches the information in one of
Inhaltszusammenfassung zur Seite Nr. 18
UP354BH(WDECT2355+2) OM 5/14/04 10:49 AM Page 12 Answering Setup This main menu option allows you to set up TAD settings from your handset. You can also set these submenu options from the base (see page 45). Submenu name Description Security Code Select a two-digit Personal Identification Number (PIN) code. A PIN code is (Default is 80) required to play your messages from a remote location, you will need to enter a two-digit PIN code (see page 17). Ring Time Allows you to set the number of r
Inhaltszusammenfassung zur Seite Nr. 19
UP354BH(WDECT2355+2) OM 5/14/04 10:49 AM Page 13 Global Setup If you change one of the Global settings, you change the setting for all additional handsets. Only one handset can change Global settings at a time. Submenu name Description Day & time Set the day and time of your display (see page 19). Name Tag (POP ID) Display the stored name with the Caller ID telephone number, if the displayed (Default is on) Caller ID telephone number is exactly the same as a number stored in the phone book
Inhaltszusammenfassung zur Seite Nr. 20
UP354BH(WDECT2355+2) OM 5/14/04 10:49 AM Page 14 SETTING UP THE MENU Entering the Menu 1) Press the /del key in standby mode. DirectLink Mode 2) Use /vol/ or /vol/ to move the pointer to To back to the a desired main menu (DirectLink Mode, Room Monitor, Room Monitor previous screen, press /del. Handset Setup, Answ. Setup, Global Setup, and Handset Setup System Reset). 3) Press to select the desired main menu. 4) Use /vol/ or /vol/ to select a desired submenu, and then press to enter. In the
