Inhaltszusammenfassung zur Seite Nr. 1
UC01501BB_0 8/9/06 2:46 PM Page i
Inhaltszusammenfassung zur Seite Nr. 2
UC01501BB_0 8/9/06 2:46 PM Page 1 Introducing your Digital Cordless Telephone Welcome Crystal clear digital sound quality Thank you for purchasing a Uniden Multi-Handset Caller ID* to see who’s calling before you pick phone. up the phone Note: Illustrations in this manual are used for 30 Number Caller ID explanation purposes. Some illustrations in this 100 Phonebook entries manual may differ from the actual unit. Last 10 number redial 10 handset ringer options (6 Melodies and 4 T
Inhaltszusammenfassung zur Seite Nr. 3
UC01501BB_0 8/9/06 2:46 PM Page 2 Contents Setting up 4 Store a redial number to the phonebook 14 Finding a location 4 Deleting numbers from the redial list 15 Connecting your phone 4 Mute (privacy) 15 Preparing the handsets 5 Finding/paging handsets 15 Installing and charging the handset battery pack 5 Keypad lock 16 Battery Low Warning 6 Conversation recording Battery Performance 6 (DECT1080/DECT1080-2 only) 16 Setting the date and time 6 Using the phonebook 17 Connecting the telephone line
Inhaltszusammenfassung zur Seite Nr. 4
UC01501BB_0 8/9/06 2:46 PM Page 3 Settings menu 26 Record Memo 38 Tones 26 Answering Machine Settings 38 Dial Mode 26 Answer on/off 39 Tone Dialing Switch-Over 27 Play/Delete/Record OGM 39 Registering a new handset 27 Select OGM 39 De-register a handset or a base 28 Setting Call Screen 39 Base PIN code 29 Using Call Screen 39 Selecting a base 29 Ring Delay 40 Resetting your phone 30 Message Length 40 Setting Remote PIN 40 Default settings 31 Message Alert 40 Network services 32 Language 40 Ca
Inhaltszusammenfassung zur Seite Nr. 5
UC01501BB_0 8/9/06 2:46 PM Page 4 Connecting your phone Setting up 1 Connect the base power supply to the back of Follow these simple steps to prepare your the base. Plug the other end into the wall phone for use. electrical outlet. Finding a location WARNING Use only the power supply that came with your The location should be close to both a phone phone. jack and a continuous power outlet (one which is not connected to a switch). Using another power supply could seriously damage your pho
Inhaltszusammenfassung zur Seite Nr. 6
UC01501BB_0 8/9/06 2:46 PM Page 5 Preparing the handsets NOTE: Once your handset is fully charged, your phone is designed for the base charge Installing and charging the handset battery pack LED to turn off for approximately 4 seconds during the following instances: 1 On each handset: Remove the battery compartment cover. 1) just after reaching a full charge Press down on the semi-circle indent and slide 2) 1 minute after reaching a full charge the cover off. 3) every 5 minutes after reaching
Inhaltszusammenfassung zur Seite Nr. 7
UC01501BB_0 8/9/06 2:46 PM Page 6 BATTERY LOW WARNING Setting the date and time If the symbol is displayed on the handset, The phone uses the 24 hour clock. CHARGE BATTERY appears and you hear the In standby: low battery tone, you will need to recharge your 1 Press . handset. 2 Press or until Time & Alarm is For optimum performance, be sure to return the displayed and press . handset to the cradle after each call. If the handset is left off of the base, the actual talk 3 Press or until Set D
Inhaltszusammenfassung zur Seite Nr. 8
UC01501BB_0 8/9/06 2:46 PM Page 7 Your Handset Up/Redial Earpiece • Press during a call to increase the Display earpiece or speaker phone volume. • Use to scroll through the phonebook, Clear menu, redial list, or CALLER ID log. • Use to delete incorrect digits or letters. • Use to access the redial list. • Press to go back to the previous menu. Menu/OK • Press and hold to mute the • Press to access the menus. ringer temporarily. • Press to confirm a setting. Down/Phonebook • Use for handset
Inhaltszusammenfassung zur Seite Nr. 9
UC01501BB_0 8/9/06 2:46 PM Page 8 Your base AC power (yellow) AC power (yellow) Telephone line Telephone line Answering Machine LED Display Charge LED • Lights up when handset is charging in the cradle. In Use LED • Lights up when handset is in use. Find HS • Press to page handset(s). play/stop • Press to play messages. • Press to stop playback. skip • Press to play next message. delete • Delete a message. Ans (answering machine) on/off • Press to turn answering machine On or Off. repeat/bac
Inhaltszusammenfassung zur Seite Nr. 10
UC01501BB_0 8/9/06 2:46 PM Page 9 Your handset display Symbol Explanation Symbol Explanation Always displayed when your handset is Displayed when you are in handsfree. on, shows the battery status. Displayed when the ringer volume is set Battery fully charged. to OFF. Half charged. Always displayed when your handset is on, shows the handset is linked to the Empty and you hear a warning tone - base. the battery is low and needs charging. Flashes and you hear a warning tone Remains steady wh
Inhaltszusammenfassung zur Seite Nr. 11
UC01501BB_0 8/9/06 2:46 PM Page 10 Standby Display Once charged, your handset display will appear as illustrated below, displaying the handset name and number, and time and date. This is referred to as ‘standby mode’. For example: Battery Level Indicator Handset-Base Signal Indicator You can personalize your handset with your name (see page 22). Day/Month Time of Day Handset Number [10]
Inhaltszusammenfassung zur Seite Nr. 12
UC01501BB_0 8/9/06 2:46 PM Page 11 Quick Guide Function Button press Make a call , enter number. Make a call by pre-dialing Enter number, . Adjust earpiece volume During a call, or . End a call or place handset on base/charger. Receive a call Phone rings, . Redial then or to display number, . Privacy During a call, and select Mute, repeat the same step to select “Unmute” to resume a call. Store phonebook number then , select New Entry, , enter name, , enter number, . Select Tone, , then selec
Inhaltszusammenfassung zur Seite Nr. 13
UC01501BB_0 8/9/06 2:46 PM Page 12 Handset range Using your phone If the handset is too far away from the base, during standby, Searching appears and the Make a call symbol will flash. During a call you will hear a warning tone. You will need to mover closer to the 1 Press the symbol is displayed. When base for clearer reception and to avoid being you hear the dial tone, dial the number you disconnected. want. The number is shown in the display. After a short delay the call timer will start
Inhaltszusammenfassung zur Seite Nr. 14
UC01501BB_0 8/9/06 2:47 PM Page 13 During a call: Call Waiting 1 Press . The symbol is displayed while If you subscribe to Call Waiting and the call handsfree. waiting tone sounds during a call, press to switch between callers. 2 Press or again to go back to the This model has a special call waiting tone in normal talk operation. addition to the one you typically hear from your local service provider. This tone will be heard after End a call the standard tone when you receive a call waiting 1
Inhaltszusammenfassung zur Seite Nr. 15
UC01501BB_0 8/9/06 2:47 PM Page 14 Store a redial number to the phonebook Redial 1 In standby, press to display the last Redial the last number called number called. 1 Press . 2 Press or to display the redial 2 Press . number you want. 3 Use or to select Redial. 3 Press , then use or to select Store to Phbk, press . 4 Press . 4 is displayed. Redial any of the last 10 numbers called Enter a name using the keypad and press . Your handset saves the last 10 numbers called For inform
Inhaltszusammenfassung zur Seite Nr. 16
UC01501BB_0 8/9/06 2:47 PM Page 15 Deleting numbers from the redial list Press and then select Unmute. 1 In standby, press to display the last Finding/paging handsets number called. You can use the Find Handset button on the base to locate a missing handset or page the user 2 Press or to display any of the last 10 (paging calls cannot be answered by a handset). numbers called. 1 Press on the base. 3 With the number you want displayed, press . Any handsets registered to your base will ring.
Inhaltszusammenfassung zur Seite Nr. 17
UC01501BB_0 8/9/06 2:47 PM Page 16 Keypad lock Conversation recording The keypad lock helps prevent accidental dialing (DECT1080/DECT1080-2 only) when you are carrying the handset around and When on a call, you can record a conversation. can also be used to stop younger children dialing out accidentally. 1 During a call, press . When the keypad lock is on, you can still receive 2 Press or to select Rec Converse, calls by pressing or , but you cannot press . make calls except for emergency 911
Inhaltszusammenfassung zur Seite Nr. 18
UC01501BB_0 8/9/06 2:47 PM Page 17 If you enter a letter and the next letter is on the Using the phonebook same button, press to move the cursor to the right before trying to enter the next letter. You can store your 100 frequently used names and numbers in the phonebook for easy dialing. To switch between upper and lower case, Press to exit the phonebook menu and press . return to standby at any time. 5 is displayed. Enter the Store a phonebook name/number number. Press . Ph
Inhaltszusammenfassung zur Seite Nr. 19
UC01501BB_0 8/9/06 2:47 PM Page 18 Entering a ‘pause’ in a stored number Edit a phonebook name/number You may need to enter a pause in some 1 Press to access the phonebook list. international or charge card numbers or if you are connected to a switchboard. 2 The display shows the first alphabetical entry in the phonebook. When storing a number, at the point where you Press or to display the name for want a pause, press and hold . You will see the entry you want (or search alphabetically). a
Inhaltszusammenfassung zur Seite Nr. 20
UC01501BB_0 8/9/06 2:47 PM Page 19 Copy phonebook names/numbers 9 Select Save or Go Back and press . 1 Using the handset that you want to copy from, press to access the phonebook list. 10 Press to exit and return to standby. 2 Press or to display the name for the entry you want (or search alphabetically). Delete a phonebook name/number Or skip this step if you want to copy the whole 1 Press to access the phonebook list. phonebook to another handset. 2 The display shows the first alphabeti
