Inhaltszusammenfassung zur Seite Nr. 1
D1384 Series User's Guide
What's in the box? You will also find:
Accessory handset
and charger
D1384 base with
Not pictured:
answering system
x Rechargeable
and cordless
battery (BT-1021)
handset
x Battery cover
x AC adapter
(PS-0035)
You should
If you purchased
model number: have:
D1384 None
Not pictured:
D1384-2 1 of each
x Rechargeable battery (BT-1021)
D1384-3 2 of each
x Battery cover
D1384-4 3 of each
x AC adapter (PS-0035)
D1384-5 4 of each
x Telephone cord
D1384-6 5 of each
x If
Inhaltszusammenfassung zur Seite Nr. 2
What’s in the manual? Getting Started ....................................... 3 Personalizing the Greeting .....................10 Installing Your Phone ............................... 3 Accessing the Answering System ...........11 Getting to Know Your Phone ...................4 Getting Your Message ............................11 Using the Menu ....................................... 6 Using the System While You’re Away from Home ......................................... 12 Using Your Phone ...
Inhaltszusammenfassung zur Seite Nr. 3
GETTING STARTED Installing Your Phone Charge the Battery 1. Unpack all handsets, battery packs, and battery covers. If you need to remove a cover, press in on the notch and slide the cover down and off. 2. Line up the battery connector with the jack inside the handset; the connector only fits one way. 3. Push the connector in until it clicks into place; tug gently on the wires to make sure the battery is securely connected. 4. Replace the battery cover and slide it into place. 5. Use an AC a
Inhaltszusammenfassung zur Seite Nr. 4
Getting to Know Your Phone Earpiece Status Indicator Display UP FIND HANDSET MENU/SELECT SPEAKER Display PHONEBOOK/ CALLER ID/RIGHT LEFT END TALK/ DOWN FLASH Charging Twelve- Contacts key dial pad Base REDIAL/ PAUSE MESSAGE/ Key What it does MUTE INTERCOM/ Microphone CLEAR fINd x In standby: page all handsets. Charging contacts Handset Key (icon) What it does x In standby: increase the ringer volume. p ( u ) x During a call: increase the volume. x In any menu or list: move the cursor up one
Inhaltszusammenfassung zur Seite Nr. 5
Key (icon) What it does x In standby: decrease the ringer volume. x During a call: decrease the volume. N owd ( ) x In any menu or list: move the cursor down one line. x In standby: access your answering system. MEGE ssa /MuTE x During a call: mute the microphone. ( ) x While the phone is ringing: ignore this call (mute the ringer). LED What it means sTaTus x On: the battery is charging. INdIcaToR x Blinking: there are new messages. Reading the Display The icons appear based on what you're do
Inhaltszusammenfassung zur Seite Nr. 6
To... Press... rotate through the punctuation and symbols 0. Using the Menu To open the x If you don't press any keys menu, press Press MENU/SELECT MENU/SELECT. for about thirty seconds, the to choose the highlighted option. handset exits the menu. The cursor shows the Handset Setup Handset Setup x During a call, use hopNEbook/ highlighted Answering Setup T-coil option. LET f to back out of the menu Use UP & DOWN to rotate without hanging up. through the To go back a press END opt
Inhaltszusammenfassung zur Seite Nr. 7
Menu Option What it does Dial Mode Choose tone or pulse dialing (see p. 3). Set Line Mode Do not change it unless instructed to by customer service. VMWI Reset Reset the Visual Message Waiting Indicator (see p. 10). USING YOUR PHONE Basics To... Using the earpiece Using the speakerphone make a call, dial the number, and press TaLk/fLash . press spEakER . answer a call press TaLk/fLash . press spEER ak . hang up press ENd or put the handset in the cradle. ignore a call/mute the ringer press MEssa
Inhaltszusammenfassung zur Seite Nr. 8
x Each handset remembers the last 5 numbers you dialed on it. x Only one handset can access one of the lists at a time. To... Press... phoNEbook/LET f , aLLER c Id/RIGhT , or open the list REdIaL/pausE . scroll through the list up or owdN . dial the current entry TaLk/fLash or spEakER . add 1 at the front of CID number before dialing for a toll call. * store the current CID or redial entry MENu/ELE s cT , then select Store Into Pb. to the phonebook Proceed to edit the name and number. edit t
Inhaltszusammenfassung zur Seite Nr. 9
Using Call Waiting x Call Waiting, a service available from your telephone provider, lets you receive calls while you are on another call. Caller ID on Call Waiting (CIDCW) service displays CID information for a waiting call. x If you get a Call Waiting call, the phone sounds a tone. Press TaLk/fLash to switch between the current call and the waiting call; each time you switch, there is a short pause before you’re connected to the other caller. Multi-Handset Features # To use the features in
Inhaltszusammenfassung zur Seite Nr. 10
Privacy Mode To activate privacy mode on a call in progress, press MENu/sELEcT twice. As long as privacy mode is on, you’ll see a in the display, and no other handsets can join your call. Privacy mode turns off automatically when you hang up; you can also turn it off by pressing MENu/sELET c twice. Using a Voice Mail Service x If you subscribe to a voice mail service, your phone can notify you when you have a new message waiting. This feature supports Frequency-Shift Keying (FSK) message n
Inhaltszusammenfassung zur Seite Nr. 11
With the phone in standby, open the menu. Select Answering Setup and select an action from the following table: To... Follow these steps: 1. Select Record Greeting. and press MENu/ELE s T c . 2. Wait until the system says "Record greeting", then you Record a can start recording. Press MENu/sELEcT to stop recording. personal 3. The system plays back your new greeting. To keep greeting the greeting, press ENd . To re-record it, wait until the playback ends and then press MENu/sELET c . Swit
Inhaltszusammenfassung zur Seite Nr. 12
To... Follow these steps: skip a message Select 3:Skip. delete this message Select 4:Delete. play old messages After the system plays all new messages, select 2:Play. stop playback Select 5:Stop. Screening Your Calls While the system takes a message, you can listen from a handset. Only one handset can screen calls at a time. If another handset tries to screen calls, it beeps and returns to standby. To... Press... hear the caller leaving a message MEssaGE/MuTE . answer the call TaLk/fLash . m
Inhaltszusammenfassung zur Seite Nr. 13
3. The system announces the time, the number of messages in memory, and a help prompt. It beeps to let you know it’s waiting for a command; enter a 2-digit command 01 Repeat message 05 Stop playback from the chart. # If you don’t press 02 Play message 06 Turn the system on any keys for 15 03 Skip message 09 Turn the system off seconds, the 04 Delete message 10 Hear help prompts system hangs up and return to standby. IMPORTANT INFORMATION Troubleshooting General problems Possible solutions
Inhaltszusammenfassung zur Seite Nr. 14
Multi-handset problems Possible solutions x Move the handset closer to the base. A handset says Unavailable. x See if any handset is in Privacy Mode. Answering system problems Possible solutions x Make sure the answering system is on. The answering system does not work. x Make sure the base is plugged in. The system won't record x See if Record Time is set to Announce Only. messages. x Delete messages (memory may be full). A handset can't access the x See if another handset is using the system.
Inhaltszusammenfassung zur Seite Nr. 15
x As part of our commitment to protecting our Adapter and Battery Information environment and conserving natural AC adapter Base Charger resources, Uniden Part number PS-0035 PS-0035 voluntarily participates in ® Input voltage 120V AC, 60 Hz an RBRC industry program to collect and recycle used Output 8V AC @ 8V AC @ Ni-MH batteries within the voltage 300mA 300mA United States. Please call 1-800-8-BATTERY for information on Ni-MH Battery pack (normal use) ® battery recycling in your ar
Inhaltszusammenfassung zur Seite Nr. 16
line. Excessive RENs on a phone line may Any changes or modifications to this product result in devices not ringing in response to not expressly approved by the manufacturer an incoming call. In most but not all areas, or other party responsible for compliance the sum of RENs should not exceed five (5.0). could void your authority to operate this To be certain of the number of devices that product. may be connected to a line, as determined NOTICE: According to telephone company by the tota
Inhaltszusammenfassung zur Seite Nr. 17
is subject to the following two conditions: (1) RF Exposure Information this device may not cause interference, and This product complies with FCC radiation (2) this device must accept any interference, exposure limits under the following including interference that may cause conditions: undesired operation of the device. "Privacy of x The base must be placed to allow a minimum communications may not be ensured when of 20 cm (8 inches) between the antenna and using this telephone." all
Inhaltszusammenfassung zur Seite Nr. 18
® As an Energy Star Partner, Uniden has WARRANTIES OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING determined that this product meets the ® Energy Star guidelines for energy efficiency. BY OPERATION OF LAW, INCLUDING, BUT ® NOT LIMITED TO ANY IMPLIED WARRANTIES Energy Star is a U.S. registered mark. OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY ® DOES NOT COVER OR PROVIDE FOR x Uniden is a registered THE REIMBURSEMENT OR PAYMENT OF trademark of Un
