Bedienungsanleitung Teledex AC8210S, AC82055, AC92105

Inhaltszusammenfassung zur Seite Nr. 1

iPhone DECT Cordless Series User Guide
For Models AC8205S, AC8210S (1.8 GHz) and AC9205S, AC9210S (1.9 GHz)
It is recommended that the battery be charged for approxi-
Included in Your Package
mately 10 to 12 hours without interruption before use.
Cordless Handset Rubber Battery Screw Cover
To charge the battery, place the handset, keypad down, in the
AC Adapter Phillips Screw
base unit. Ensure that the CHARGE LED on the base lights.
Base Unit 15-foot, 8-wire Cable
User Guide (with RJ-45 con

Inhaltszusammenfassung zur Seite Nr. 2

To assign a ring tone to a line (crescendo ring mode): “off-hook” answering the ringing line. 1. Select desired ring tone: Press the FLASH key (see Fig. 1); 3. To end the call, place the handset in the base unit cradle, then a key on the dial pad from 1-4, depending upon the or press the illuminated line key on the handset. desired ring tone. The phone will ring once to provide a To answer a call using the handset while it is resting on sample of the selected ring tone. the base: 2. Assi

Inhaltszusammenfassung zur Seite Nr. 3

Using the Hold Key The HOLD key places the call on hold locally at the cordless The Ringer Equivalence Number (REN) of this device is 0.7B. telephone. Notice: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum number of To Place a Call on Hold: terminals allowed to be connected to a telephone interface. The 1. With a call active, press the red HOLD key on either the termination on an interface may consist of any combination of handset

Inhaltszusammenfassung zur Seite Nr. 4

FCC Interference Information - Reorient or relocate the receiving antenna for the radio or television This device complies with Part 15 of the FCC Rules. Operation is that is receiving the interference). subject to the following two conditions: (1) This device may not cause - Reorient or relocate and increase the separation between the harmful interference; and (2) This device must accept any interference telecommunications equipment and receiving antenna. received, including interference