Inhaltszusammenfassung zur Seite Nr. 16
SpectraLink 6300 MCU: Facility Preparation Operator’s Console and software when the card is installed. Interface Modules of different interface types can be mixed within a shelf. Interface Modules are “hot swappable”; they can be removed and replaced without affecting service on the rest of the system. Intershelf Junction Panel (JPI300) The Intershelf Junction Panel (JPI300) connects Expansion Shelf Controllers on expansion shelves to the system controller, creating a completed communica
Inhaltszusammenfassung zur Seite Nr. 17
SpectraLink 6000 Wireless Telephone Components ccSpectraLink 6000 System The ccSpectraLink 6000 System (WTS) is designed to meet the high simultaneous call capacity and advanced level of telephone feature integration of the call center environment. The ccSpectraLink 6000 System uses a special High Density Base Station which can be installed with minimal spacing (as little as 20 feet between Base Stations.) SpectraLink 6000 Wireless Telephones The SpectraLink 6000 Wireless Telephone is a
Inhaltszusammenfassung zur Seite Nr. 18
SpectraLink 6300 MCU: Facility Preparation SpectraLink 6020 Wireless Telephone Each handset requires a line appearance (port) from the telephone system. Typically the handset extension number corresponds with the user’s internal telephone extension number. On most switching systems the user’s desk phone and the handset port can be bridged so that incoming calls ring both phones simultaneously. Operator’s Console The system uses a proprietary software program for administration and ma
Inhaltszusammenfassung zur Seite Nr. 19
4 Site Preparation The following steps must be completed before installing the system hardware. If the steps are not already completed refer to each individual section for details. MCU location prepared. Typically the MCU is installed in the telephone equipment room. This location must have sufficient backboard space or rack space, and -48 volt power available. The correct number of cross-connect blocks (or equivalent) are installed and connected to a 25-pair Telco wire terminated
Inhaltszusammenfassung zur Seite Nr. 20
SpectraLink 6300 MCU: Facility Preparation Required Materials Provided by Customer Required hardware Rack The shelves are designed to fit into a 19” mounting rack. Each shelf measures 15” high x 19” wide x 9” deep, and weighs approximately 35 pounds fully loaded. Backboard Space As an alternative to rack mounting, the shelves can be wall mounted to 3/4” plywood securely screwed to a wall. Screws Required to mount the shelves to the wall, or to secure it in the rack. For wall m
Inhaltszusammenfassung zur Seite Nr. 1
SpectraLink 6300 MCU
Installation
SpectraLink 6000 System
November 2009 Edition
1725-36122-001
Version M
Inhaltszusammenfassung zur Seite Nr. 2
SpectraLink 6300 MCU: Facility Preparation Patent Information Notice The accompanying product is protected by one Polycom, Inc. has prepared this document for or more US and foreign patents and/or pending use by Polycom personnel and customers. The patent applications held by Polycom, Inc. drawings and specifications contained herein are the property of Polycom and shall be neither reproduced in whole or in part without the prior Copyright Notice written approval of Polycom, nor be impli
Inhaltszusammenfassung zur Seite Nr. 3
About This Guide This document explains installation and operation of Polycom’s SpectraLink 6300 MCU and Base Stations. The installation process connects the SpectraLink 6000 System to the facility’s telephone system, and activates the SpectraLink 6000 Wireless Telephones. Polycom Model Numbers This document covers the following registered model numbers: JPI300, MCS300, RCC400, RCO400, RCU100, RCU200, RCU201 Related Documents SpectraLink 6300 MCU: Facility Preparation (1725-36121-001)
Inhaltszusammenfassung zur Seite Nr. 4
SpectraLink 6300 MCU: Facility Preparation Customer Support Polycom wants every customer to have a successful installation. Please refer questions to the Customer Support Hotline at (800) 775-5330. The hotline is open Monday through Friday, 6 a.m. to 6 p.m. Mountain time. For Technical Support: technicalsupport@polycom.com For Knowledge Base: http://www.polycom.com/usa/en/support/voice/voice.html For Return Material Authorization: rmacoordinator@polycom.com Icons and Conventions Th
Inhaltszusammenfassung zur Seite Nr. 5
Contents 0 About This Guide......................................................................3 Polycom Model Numbers..................................................................3 Related Documents.............................................................................3 Customer Support...............................................................................4 Icons and Conventions.......................................................................4 1 Installation Ov
Inhaltszusammenfassung zur Seite Nr. 6
SpectraLink 6300 MCU: Facility Preparation Install Demarc Blocks .......................................................................32 Program Telephone System.............................................................32 Connect Cables from Base Stations and Phone Lines to Demarc Blocks ...................................................................................33 5 System Installation..................................................................39 Facility Analysis ......
Inhaltszusammenfassung zur Seite Nr. 7
Contents Base Station Location Worksheet....................................................61 Extension Assignments Worksheet................................................62 Customer Acceptance Form ............................................................63 11 Safety Notices ........................................................................ 102H65 12 Index 53H ..................................................................................... 103H67 PN: 1725-36122-001_M.doc
Inhaltszusammenfassung zur Seite Nr. 8
Inhaltszusammenfassung zur Seite Nr. 9
1 Installation Overview Installation has three phases. In most cases, a separate person is responsible for each phase. 1. Site preparation and wire installation: Usually done by a wire technician or contractor, with the assistance of a customer representative such as a project manager. Please refer to the SpectraLink 6300 MCU: Facility Preparation manual for more information. 2. Installing the SpectraLink system: Done by Polycom or one of our certified distributors. 3. Programming th
Inhaltszusammenfassung zur Seite Nr. 10
SpectraLink 6300 MCU: Facility Preparation Installation Steps and Responsibilities Wire Customer Task Field Service Contractor or Project Mgr/ Description Engineer Electrician Sys Admin Site Preparation Required materials provided by customer Prepare location and arrangement of shelves Prepare –48V power for shelves Run cables to Base Stations Terminate cables at Base Stations Prepare and install demarc blocks Program Telephone System ports Conne
Inhaltszusammenfassung zur Seite Nr. 11
2 SpectraLink 6000 System Description This section generally explains the installation and site requirements of the SpectraLink 6000 System. The SpectraLink 6000 System is a wireless communication system that allows hand-held SpectraLink 6000 Wireless Telephones to communicate using the existing telephone system. The SpectraLink 6000 System’s advanced micro-cellular architecture utilizes Base Stations, or cells, located throughout the facility to accommodate on-premise roaming. As a h
Inhaltszusammenfassung zur Seite Nr. 12
SpectraLink 6300 MCU: Facility Preparation SpectraLink 6000 System 12 PN: 1725-36122-001_M.doc
Inhaltszusammenfassung zur Seite Nr. 13
3 SpectraLink 6000 System Components The Master Control Unit The Master Control Unit is the processing center for calls to and from the SpectraLink 6000 System. It consists of at least one primary shelf (MCS300) and may have up to 19 expansion shelves. Residing adjacent to the telephone switching equipment, the MCU operates as a standalone, external system while maintaining full PBX functionality for handset users. The MCU connects to the telephone system in two ways. The MCU can eit
Inhaltszusammenfassung zur Seite Nr. 14
SpectraLink 6300 MCU: Facility Preparation handsets to the system. Up to 20 shelves can be connected together to maximize the system capacity. The following diagram illustrates a sample star topology for the SpectraLink 6000 System. 1 2 3 4 5 6 7 8 9 10 11 12 1 2 3 4 5 6 7 8 9 10 11 12 Shelf 2 - Expansion Shelf Shelf 1 - Primary Shelf 1 2 3
Inhaltszusammenfassung zur Seite Nr. 15
SpectraLink 6000 Wireless Telephone Components Shelf Shelves are designed for 19” rack or wall mounting. Each shelf has 12 universal card slots. The first two slots are reserved for controller cards, the remaining ten slots are for Interface Modules. Wiring to each card is on the front panel. Power is -48V DC through the back or side panel. System Controller (CSC or CSO301, 306, and 320) Each system requires one system controller card, which occupies two slots (slots 1 and 2) in the mai
