Bedienungsanleitung Philips Cordles Telephone

Inhaltszusammenfassung zur Seite Nr. 1

ID937_QSG_EN.fm Page 1 Thursday, December 21, 2006 12:24 PM
EN
Welcome
Quick start guide
Connect
1 1
Install
2 2
Enjoy
3 3

Inhaltszusammenfassung zur Seite Nr. 2

ID937_QSG_EN.fm Page 2 Thursday, December 21, 2006 12:24 PM What’s in the box Power supply for Base station Handset base station 2 AAA rechargeable Splitter Line cord batteries Quick Start Guide Warranty card User Guide The line adaptor may not be attached to the line cord. In this case, you have to connect the line adaptor to the line cord first before plugging the line cord to the line socket. In multihandset packs, you will find one or more additional handsets, chargers with power supply

Inhaltszusammenfassung zur Seite Nr. 3

ID937_QSG_EN.fm Page 3 Thursday, December 21, 2006 12:24 PM EN Connect 1 Connect the base station 1. Place the base station in a central location near the telephone line socket and electricity sockets. Power supply Line cord Splitter 2. Connect the supplied splitter to the connector at the back of the base station and then plug the line cord and the power cable into the respective line jacks on the splitter. 3. Connect the other end of the line cord to the telephone line socket and the other

Inhaltszusammenfassung zur Seite Nr. 4

ID937_QSG_EN.fm Page 4 Thursday, December 21, 2006 12:24 PM Enjoy 3 Make a call Enter the phone number and press r. OR Press r and enter the phone number. Answer a call When the phone rings, press r key. End a call Press e key. Adjust earpiece volume during a call Press : to select from Volume 1 to Volume 5. Set the ring melody 1. Press mMENU, scroll : to Personal Set and press mSELECT, press mSELECT to enter Handset Tones, scroll : to Ring Melody and press mSELECT. 2. Scroll : to your desire

Inhaltszusammenfassung zur Seite Nr. 5

ID937_QSG_EN.fm Page 5 Thursday, December 21, 2006 12:24 PM EN Switch the handset On/Off Press and hold e key for 3 seconds to switch off the handset in stand-by mode. Short press e key to switch on the handset again. Keypad lock/unlock Press and hold * key for 2 seconds to lock or unlock keypad in stand-by mode. Paging 1. Short press p key on the base. The handset starts to ring. 2. Once retrieved, press any key on the handset to end the paging. Press To Enter the main menu from stand-by m

Inhaltszusammenfassung zur Seite Nr. 6

ID937_QSG_EN.fm Page 6 Thursday, December 21, 2006 12:24 PM Troubleshooting For more information, please refer to page 58 of the user manual. Problem Solution • No dialling tone • Check the connections • Charge the batteries for at least 24 hours • Use the line cable provided • Poor audio quality • Move closer to the base station • Move the base station at least one metre away from any electrical appliances • Register the handset to the base station • The icon is blinking • Move closer to th