Inhaltszusammenfassung zur Seite Nr. 1
3-221-711-11 (1)
2-Line Cordless
Telephone
Operating Instructions
US
Manual de instrucciones
ES
SPP-M937
©2000 Sony Corporation
Inhaltszusammenfassung zur Seite Nr. 2
Owner’s Record should not be placed in a built-in installation unless proper ventilation The model and the serial numbers are is provided. located at the bottom of the unit. Record 7. This product should be operated only the serial number in the space provided from the type of power source below. Refer to these numbers whenever indicated on the marking label. If you you call upon your Sony dealer are not sure of the type of power regarding this product. supply to your home, consult your dealer o
Inhaltszusammenfassung zur Seite Nr. 3
may result in damage and will often INFORMATION FOR require extensive work by a qualified GENERAL TELEPHONES technician to restore the product to normal operation. 1. This equipment complies with Part 68 of the FCC rules. On the bottom of this equipment is E. If the product has been dropped or a label that contains, among other the cabinet has been damaged. information, the FCC certification number and ringer equivalence number (REN) for this F. If the product exhibits a distinct equipment. If r
Inhaltszusammenfassung zur Seite Nr. 4
If your telephone is equipped with automatic dialers When programming emergency numbers and (or) making test calls to emergency numbers: 1. Remain on the line and briefly explain to the dispatcher the reason for the call. 2. Perform such activities in the off-peak hours, such as early morning or late evenings. Caution You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Note This equipment has been tested a
Inhaltszusammenfassung zur Seite Nr. 5
Table of contents 32 Transferring a call Getting Started 32 To transfer from the base 6 Read this first phone to the handset 7 Step 1: Checking the package 33 To transfer from the handset contents to the base phone 8 Step 2: Setting up the base phone 34 Having a conference call 12 Step 3: Preparing the battery 34 Making another call while pack talking 14 Identifying the parts 35 Receiving a call while talking 36 Switching conference from the handset to the base phone Basics 36 Switching
Inhaltszusammenfassung zur Seite Nr. 6
Getting Started Read this first Before you use your phone, you must first set it up. Here’s a quick way to set up your phone: Steps 1, 2 and 3. Step 1 (page 7) First, unpack the phone and the supplied accessories. Step 2 (pages 8 to 11) Next, you need to do three things to set up the base phone, including finding the best location for the base phone. Base phone Step 3 (pages 12 to 13) Finally, insert the battery pack into the handset and charge it for more than 12 hours. Handset That’s it!
Inhaltszusammenfassung zur Seite Nr. 7
Getting Started Step 1 Checking the package contents Make sure you have received the following items in the package. If anything is missing, contact your local Sony dealer. AC power adaptor (AC-T122) Base phone Handset Telephone line cords (3) Wall bracket for base phone Rechargeable battery Directories (2) Belt clip pack (BP-T23) US Getting Started 7
Inhaltszusammenfassung zur Seite Nr. 8
Step 2 Setting up the base phone Do the following steps: • Choose the best location • Connect the base phone • Choose the dialing mode Choose the best location Where you place the base phone affects the reception quality of the handset. Away from noise sources such as a window by a street with heavy traffic Away from television sets and other Away from heat sources, such as radiators, electronic equipment airducts, and sunlight Away from a microwave oven Away from excessive moisture, extremel
Inhaltszusammenfassung zur Seite Nr. 9
Getting Started Connecting the base phone If you want to hang the base phone on the wall, see page 37. To connect the base phone to a single outlet having two lines 3 Hook the cord. To an AC outlet To DC IN 9V 2 AC power adaptor DATA jack (supplied AC-T122) To L1/L1+L2 To the telephone outlet 1 Telephone line cord (supplied) 1 Connect the telephone line cord to the L1/L1+L2 jack and to a telephone outlet. 2 Connect the AC power adaptor to the DC IN 9V jack and to an AC outlet. 3 Raise the antenn
Inhaltszusammenfassung zur Seite Nr. 10
Step 2: Setting up the base phone (continued) To connect the base phone to two separate outlets 3 Hook the cord. To an AC outlet To DC IN 9V 2 AC power adaptor DATA jack (supplied AC-T122) To the telephone outlets To L1/L1+L2 Telephone line cord (supplied) Line 1 To L2 1 Telephone line cord (supplied) Line 2 1 Connect the telephone line cords to the L1/L1+L2 and L2 jacks and to the telephone outlets. 2 Connect the AC power adaptor to the DC IN 9V jack and to an AC outlet. 3 Raise the antenna. Ma
Inhaltszusammenfassung zur Seite Nr. 11
Getting Started Notes Polarity of the plug • Use only the supplied AC-T122 AC power adaptor. Do not use any other AC power adaptor. • Connect the AC power adaptor to a continuous power supply. • Place the base phone close to the AC outlet so that Modular you can unplug the AC power adaptor easily. Tips • If your telephone outlet is not modular, contact your L1 telephone service company for assistance. • L1 is the first phone line connected to center pair of wires. L2 is the second phone line co
Inhaltszusammenfassung zur Seite Nr. 12
Step 3 Preparing the battery pack Charge the battery pack for more than 12 hours before you start using your phone. 1 Slide open the battery compartment lid of the handset. 2 Insert the battery pack (with contacts facing down) into the BP-T23 battery compartment. 3 Close the battery compartment lid. 4 Place the handset on the base phone. The CHARGE lamp lights up when the handset is properly seated on the charge terminals of the base phone. Charge the battery pack for more than 12 hours so that
Inhaltszusammenfassung zur Seite Nr. 13
Getting Started Battery duration A fully charged battery pack lasts for about: • Approx. 7 hours when you use the handset continuously • Approx. 7 days when the handset is in standby mode. Notes • The battery pack will gradually discharge over a long period of time, even when not in use. • If you leave the battery pack in the handset without charging it, the battery pack will be completely discharged. It may require several times of charging to recover to its full capacity. To obtain the best pe
Inhaltszusammenfassung zur Seite Nr. 14
Identifying the parts Refer to the pages indicated in parentheses for details. Base Phone 1 2 qa 3 4 qs 5 qd 6 qf 7 8 qg 9 qh 0 qj qk 1 SPEED DIAL button (p. 24) 7 MUTING button and lamp (p. 21) Automatically dials the numbers programmed. Mutes your voice during a conversation, and lights up during 2 REDIAL/PAUSE button (p.19) muting. Redials the last number called/ 8 MIC (microphone) inserts a pause in the dialing sequence. 9 CONF (conference) button (p. 34) 3 Dialing keys (p. 18) Lets you talk
Inhaltszusammenfassung zur Seite Nr. 15
Getting Started wd qlw;wa ws ql Hook for AC power adaptor qf VOLUME +/– button (p. 18, 21) cord (p. 9) Adjusts the speaker volume. w; DC IN 9V jack (p. 9, 37) qg DIAL MODE switch (p. 11) wa L1/L1+L2 jack (p. 9, 37) Selects pulse or tone dialing. ws L2 jack (p. 10, 37) qh RINGER LEVEL switches (L1, L2) (p. 21) wd DATA jack (p. 11) Adjusts the ringer volume. qj INTERCOM button (p. 30, 32) Used to make an intercom call. qk OFF button (p. 18) Allows you to disconnect the call. continued US Getting S
Inhaltszusammenfassung zur Seite Nr. 16
Identifying the parts (continued) Handset 1 qa 2 qs 3 4 qd 5 qf 6 qg 7 8 9 qh 0 qj qk 1 Antenna qs FLASH button (p. 17, 20) Switches to a second call if you 2 Speaker have “call waiting” service, or lets 3 INTERCOM/BATT LOW lamp you make a new call. (p. 17) qd OFF button (p. 17) Flashes when the battery becomes Allows you to disconnect the call. weak/lights up during an intercom qf CONF (conference) button call. (p. 34) 4 VOL (volume) switch (p. 17) Lets you talk with two parties at the Adjusts
Inhaltszusammenfassung zur Seite Nr. 17
Basics Basics Making calls 1 Pick up the handset from the base phone. INTERCOM/ 2 Press (LINE 1) or (LINE 2) to BATT LOW lamp I (HEADSET) select the line. jack The corresponding line button lights up. (FLASH) VOL switch You will then hear a dial tone. If you hear an error beep, move (HOLD) closer to the base phone. 3 Dial the phone number. (*TONE) 4 When you are done talking, press (OFF) or replace the handset on the base phone. (REDIAL/PAUSE) (CHANNEL) The LINE 1 or LINE 2 button goes off. Maki
Inhaltszusammenfassung zur Seite Nr. 18
Making calls (continued) Notes • If you hear ringer tones during the conversation, another call is coming in on the other line (see page 22). • Do not press (CHANNEL) when you are far from the base phone. The call may be disconnected. • If you hear an short error beep when you press (CHANNEL), move closer to the base phone. Tips • You can talk on the base phone by pressing (LINE 1) or (LINE 2) on the base phone after you have dialed on the handset (speakerphone). • The LINE 1 or LINE 2 button on
Inhaltszusammenfassung zur Seite Nr. 19
Basics To obtain the best speakerphone performance • You may not be able to hear the other party's voice in a noisy place. Therefore, use the speakerphone in a quiet room. • Do not bring your hand or other object too close to the microphone or you will hear a shrill noise (“feedback”). • When the speaker volume is loud, or the telephone has been placed close to a wall, you may find that the volume drops suddenly. This is due to a circuit in the telephone designed to protect against feedback. In
Inhaltszusammenfassung zur Seite Nr. 20
Receiving calls 1 When you hear the phone ring, • Press (LINE 1) or (LINE 2) whichever button is flashing. or • Pick up the handset from the base phone when the handset is placed on the base (FLASH) phone. VOL switch The corresponding line button lights up, so you can know (HOLD) which line is used. 2 When you are done talking, press (OFF) or replace the handset on the base phone. The corresponding line button goes off. When calls come in on line 1 and line 2 at the same time The phone rings wit
