Inhaltszusammenfassung zur Seite Nr. 1
Installation instructions
and User guide
Freestanding cooker
OR60 models
NZ AU
Inhaltszusammenfassung zur Seite Nr. 2
Inhaltszusammenfassung zur Seite Nr. 3
1 Contents Safety and warnings 2 Installation instructions 6 Using your oven for the first time 14 Using your oven 15 Cooking functions 16 Using your gas cooktop 17 Cooktop troubleshooting 21 Care and cleaning 22 Warranty and service 28 Important! SAVE THESE INSTRUCTIONS The models shown in this User Guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go to
Inhaltszusammenfassung zur Seite Nr. 4
2 Safety and warnings Installation WARNING! Electrical Shock Hazard Always disconnect the cooker from the mains electricity supply before carrying out any maintenance operations or repairs. Failure to do so may result in death or electrical shock. WARNING! Cut Hazard Take care - panel edges are sharp. Failure to use caution could result in injury or cuts. Important safety precautions General To avoid hazard, follow these instructions carefully before installing or using this product. Ple
Inhaltszusammenfassung zur Seite Nr. 5
3 Safety and warnings The switch must always be accessible. The power supply cable must not touch any hot parts and must be positioned so that it does not O exceed 75 C at any point. To connect the cooker to the mains, do not use adapters, reducers or branching devices as they can cause overheating and burning. This cooker must be connected to a suitable double pole control unit adjacent to the cooker. No diversity can be applied to this control unit. If the electrical supply cord i
Inhaltszusammenfassung zur Seite Nr. 6
4 Safety and warnings Operation Your freestanding cooker has been carefully designed to operate safely during normal cooking procedures. Please keep the following guidelines in mind when you are using it: WARNING! Explosion Hazard Do not store flammable materials such as gasoline near the cooktop. Do not store flammable material in the oven or drawer. Do not spray aerosols near the cooktop during use. Failure to do so may result in death or serious injury. WARNING! Electrical Shock
Inhaltszusammenfassung zur Seite Nr. 7
5 Safety and warnings Important safety precautions Isolating switch: make sure this cooker is connected to a circuit which incorporates an isolating switch providing full disconnection from the power supply. Household appliances are not intended to be played with by children. Children, or persons with a disability which limits their ability to use the appliance, should have a responsible person to instruct them in its use. The instructor should be satisfied that they can use the applia
Inhaltszusammenfassung zur Seite Nr. 8
6 I Installa nstallation instruc tion instructions tions Clearances Installation clearances and protection of combustible surfaces shall comply with the current local regulations eg. AG 601 (AS 5601) Gas Installations code. Installation shall comply with the dimension in Fig. 1 bearing in mind that: Overhead Clearances In no case shall the clearance above the highest part of the cooker be less than 600 mm or, for an overhead exhaust fan, 750 mm. AII other downward facing combustible surfaces
Inhaltszusammenfassung zur Seite Nr. 9
7 Installation instructions Levelling the cooker To fit the adjustable feet: Place the cooker on its back as shown. Screw the four feet to the cooker. Stand the cooker and level it by screwing or unscrewing the feet with a spanner. Fig. 2a Fitting the adjustable feet (supplied with the cooker in a separate kit) 0 + 8 mm + 8 mm + 15 mm Fig. 2b Fitting the optional spacer (supplied with the cooker in a separate kit)
Inhaltszusammenfassung zur Seite Nr. 10
365 235 600 mm 8 Installation instructions Anti-tilt bracket Important! To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall. To fit the anti-tilt bracket: After you have located where the cooker is to be positioned mark, on the wall, the place where the two screws of the anti-tilt bracket have to be fitted. Please follow the indications given in the drawing below. Make two 8 mm diameter holes in the wall and insert the pl
Inhaltszusammenfassung zur Seite Nr. 11
9 Installation instructions Gas supply The gas connection must be carried out by an authorised person according to the relevant standards. Before connecting the appliance to the gas main, mount the brass conical adaptor onto the gas inlet pipe, upon which the gasket has been placed (see Fig.s following). Conical adaptor and gasket are supplied with the appliance (packed with conversion kit for use with Natural gas or LPG gas). This appliance is suitable for use with Natural Gas or LP
Inhaltszusammenfassung zur Seite Nr. 12
10 Installation instructions After installing the freestanding cooker and connecting the gas supply: 1 Using a suitable leak detection fluid solution (e.g. Rocol) check each gas connection one at a time by brushing the solution over the connection. The presence of bubbles will indicate a leak. If there is a leak, tighten the fitting and then recheck for leaks. Important! Do not use a naked flame to test for leaks. 2 Adjust the test point pressure or supply pressure to the value that is app
Inhaltszusammenfassung zur Seite Nr. 13
11 Installation instructions Converting to a different gas type This appliance is suitable for use with Natural gas or LPG gas (check the “gas type” sticker attached to the appliance). To convert from one gas type to another, you need to replace the injectors, and then adjust the minimum burning setting. To replace the injectors Remove pan supports and burners from the cooktop. Using a spanner, remove the injector (shown in Fig.s following) and replace it with one according to the gas ty
Inhaltszusammenfassung zur Seite Nr. 14
12 Installation instructions Adjusting the minimum burner setting Check whether the flame spreads to all burner ports when the burner is lit with the gas tap set to the minimum position. If some ports do not light, increase the minimum gas rate setting. Check whether the burner remains lit even when the gas tap is turned quickly from the maximum to the minimum position. If the burner does not remain lit, increase the minimum gas rate setting. To adjust the minimum gas rate setting: Turn
Inhaltszusammenfassung zur Seite Nr. 15
13 Installation instructions Lubrication of the gas taps A qualified technician must lubricate the gas taps. Wiring diagram Cod. 1131682
Inhaltszusammenfassung zur Seite Nr. 16
14 Using your oven for the fi rst time Temperature Front left Rear right (semi- indicator light (auxiliary) rapid) burner knob burner knob Function Temperature Rear left (semi-rapid) Front right knob knob burner knob (triple-ring wok) burner knob Fig. 11 Control panel Before using your new oven, please: 1 Read this user guide, taking special note of the ‘Safety and warnings’ section. 2 Remove all accessories and packaging. 3 Condition the oven: Slide in the shelves and grill pan as shown. F
Inhaltszusammenfassung zur Seite Nr. 17
15 Using your oven Fig. 13 Function and temperature knobs 1 Select the function using the function knob. The oven light will come on. 2 Select the temperature using the temperature control knob. The oven temperature indicator light, above the temperature knob on the control panel, will glow until the oven has reached the set temperature, and then it will go out. When you have finished cooking, turn the function and temperature control knobs to the off O 3 position.
Inhaltszusammenfassung zur Seite Nr. 18
16 Cooking functions OVEN LAMP Only the oven light comes on. It remains on in all the cooking functions. BAKE The upper and lower heating elements come on. BAKE is the traditional method of cooking. It is best to cook on only one shelf at a time in this function. FAN BAKE The upper and lower heating elements and the fan come on. FAN GRILL Both the grill and the fan come on. Use with the oven door closed and the temperature knob between 50 °C and 175°C. Do not grill for longer than 30 minut
Inhaltszusammenfassung zur Seite Nr. 19
17 Using your gas cooktop 2 2 1 3 Fig. 15 Cooktop layout 1 Auxiliary burner 2 Semi-rapid burner 3 Triple-ring wok burner Gas burners The knob controls the flow of gas through the safety tap. = closed valve 0 = maximum aperture or flow = minimum aperture or flow You can choose to cook at any heat between and , but never between and . 0 Fig. 16 Burner control knob
Inhaltszusammenfassung zur Seite Nr. 20
18 Using your gas cooktop Before using your cooktop Before using your new cooktop, please: Read this user guide, taking special note of the ‘Safety and warnings’ section. Turn the cooker on. Make sure all controls are turned off. Lighting the cooktop 1 Choose the control knob for the burner you want to use. 2 Press the knob down gently and turn it anticlockwise to the position. The ignitors on all the burners will spark. 3 Adjust the flame anywhere between the and positions. Do not
