Digi EIA-422 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

EIA-422 Mode (EtherLite 2 or 162 only) Environmental Specifications
EtherLite
To operate a port of the EtherLite 162 EIA-422 in EIA-422 mode, set the
Operating Temperature
port’s EIA-422 ENABLED switch to the up position. Set the TERMINA-
32°F (0°C) to 122°F (50°C) for units with less than 32 ports
TION (422 ONLY) switch to the down position. This switch connects a
32°F (0°C) to 95°F (35°C) for 32-port units
Hardware
120 ohm, 1/2 watt resistor across the input signals.
Information Guide
Storag

ملخص المحتوى في الصفحة رقم 2

Installing the EtherLite Hardware Rack Mount Considerations EIA-232 DTE Pinouts EtherLite 1. Write the MAC address of the EtherLite module on the following When doing a rack mount installation consider the following: Signal DB-25 Pin DB-9 Pin RJ-45 Pin line. It will be needed during software installation. This address is • Cumulative power requirements of the unit and other equipment printed on a label next to the power plug at the back of the unit. 1 RTS (out) 4 7 installed in the rack. Do n