ملخص المحتوى في الصفحة رقم 1
Photo All-In-One
series
Getting Started
Read Me First
Make sure to read this manual before using the machine. Please keep it in hand for future reference.
ملخص المحتوى في الصفحة رقم 2
■ Symbols Used in This Document Instructions including important information. Be sure to read these indications. Instructions as notes for operation or additional explanations. Descriptions for operations that take some time to complete. Indicates operations in Windows. Indicates operations in Macintosh. • Microsoft is a registered trademark of Microsoft Corporation. • Windows is a trademark or registered trademark of Microsoft Corporation in the U.S. and/or other countries. • Windows Vista is a
ملخص المحتوى في الصفحة رقم 3
Contents Preparation ....................................... 2 Network Connection ........................... 20 Preparation .................................................................. 2 Select Connection Type ............................................... 20 Devices Required to Connect to Computers ........... 2 Notes on Network Connection ................................. 20 Check the Included Items ........................................ 3 Wireless Setup .....................
ملخص المحتوى في الصفحة رقم 4
Preparation Preparation ■ Devices Required to Connect to Computers USB Connection Network Connection Wireless Wired Connection Connection USB cable Access point or Router, etc. Ethernet cable wireless router An access point or router that supports IEEE802.11b/g is A network device (router, etc.) and Ethernet cable are A USB cable is required. required. required. Preparation
ملخص المحتوى في الصفحة رقم 5
Preparation ■ Check the Included Items Before turning on the machine, remove all orange tape and protective sheets from □ Choosing a Location the inside and outside of the machine. The Print Head is placed inside of the Paper Output Tray (A). Open the Paper Output Tray and take it out. • Do not install the machine where an object may fall Print Head A on it. The object may fall inside the machine, resulting in malfunction. • Do not place any object on top of the machine. It may fall into t
ملخص المحتوى في الصفحة رقم 6
Hardware Setup Turn the Power On 4 1 2 3 C D B A E F Plug the power cord into the back Open the Operation Unit (B) and Use the { or } button (D) on the Operation When the above left of the machine, then connect press the ON button (C) to turn on the Panel to select the language for the LCD (E), screen is displayed, the other end to the wall outlet. machine. then press the OK button. press the OK button and go to the next step. • Do NOT connect the USB cable or Ethernet cable at this stage.
ملخص المحتوى في الصفحة رقم 7
Install the Print Head 1 2 C B C A D Open the Paper Output Tray (A), then lift the Scanning Unit (Cover) (B) Make sure that the Print Head Holder until it stops. (D) moves to the installation position. Close the Document Cover (C) and lift it with the Scanning Unit (Cover). • Handle the Print Head carefully. Do not drop or apply excessive pressure to it. • The Print Head Holder makes a noise as it moves. This is normal operation. • If the Print Head Holder does not move, make sure that the mac
ملخص المحتوى في الصفحة رقم 8
Install the Print Head 4 3 5 E F G H Firmly raise the Print Head Lock Lever (E) of the Print Head Holder until it Remove the Print Head from the Remove the orange protective cap. stops. silver package. • Do not touch the inside (G) or metal parts (H) of the Print Head. The machine may not print properly if you touch them. • There may be some transparent or light blue ink on the inside of the bag the Print Head • Do not touch the inside of the Print Head Holder (F). The machine may not print co
ملخص المحتوى في الصفحة رقم 9
Install the Print Head 6 7 Tilt the Print Head forward and set it in place as shown. Lower the Print Head Lock Lever completely. • Hold the Print Head Lock Lever firmly and lower it gently. • Do not knock the Print Head against the sides of the holder. • Once you have installed the Print Head, do not remove • Install in a well-lit environment. it unnecessarily. Hardware Setup
ملخص المحتوى في الصفحة رقم 10
Install the Ink Tanks 1 2 A C B 1 2 Pull the orange tape (1) in the direction of the While pressing down with your left thumb, twist off arrow to peel off the protective film and remove the orange protective cap (A) located on the bottom the film (2) completely. of the ink tank. • Handle the ink tanks carefully. Do not drop or apply excessive pressure to them. • If the Scanning Unit (Cover) is left open for more than 10 minutes, the Print Head Holder moves to the right. In this case, close
ملخص المحتوى في الصفحة رقم 11
Install the Ink Tanks 4 3 Tilt the ink tank, then insert it under the label and against the back end of the Press the PUSH mark on the ink tank firmly until it clicks. slot. When the installation is completed properly, the Ink lamp lights red. Make sure that the color of the label matches the ink tank. • Install in a well-lit environment. Hardware Setup
ملخص المحتوى في الصفحة رقم 12
Install the Ink Tanks 5 6 7 D E Make sure that the Inner Install all the other ink tanks in the same way. Close the Scanning Unit (Cover) (E). Cover (D) is closed by Install all the ink tanks. • Wait until the LCD changes as shown in the illustration (about 5 touching it with your minutes) and go to the next step. Make sure all the Ink lamps light red. hand. • The machine may make some operating noises when preparing to print. This is normal operation. • Once you have installed the ink tank
ملخص المحتوى في الصفحة رقم 13
Align the Print Head 1 2 A B C Load a sheet of supplied specialty paper (Matte Confirm the message on the LCD and press the OK Photo Paper MP-101) in the Rear Tray (A) by button. referring to steps to in "Loading Paper" Extend the Output Tray Extension (C). Align the Print Head for better print results. on page 49. • Print Head Alignment takes about 5 minutes to This takes about 5 minutes. complete. Use a sheet of supplied specialty paper (Matte Wait until the pattern is printed, then go t
ملخص المحتوى في الصفحة رقم 14
Align the Print Head 4 3 3 2 1 D E Make sure that a pattern similar to Confirm the message on the LCD, follow the procedure below to load plain paper into the Cassette (E), then press the the one shown in the illustration is OK button. printed. Slide the Paper Guide to align with the actual size of the paper. Remove the printed paper, then close 1 the Paper Output Tray (D). Load paper along the right edge of the Cassette. 2 Slide the Paper Guide against the left edge of the paper. 3 • When an
ملخص المحتوى في الصفحة رقم 15
Select Connection Method Select Connection Method Select the method to connect the machine to the computer according to your system environment. This is the recommended installation when you use the machine on single computer, which is not networked. USB Connection Go to "[USB Connection] Install the Software" on page 14. This is the recommended installation when you use the machine on a computer connected to a network. Use the machine over a wireless or wired Network Connection connection. Con
ملخص المحتوى في الصفحة رقم 16
USB Connection Install the Software To use the machine by connecting it to a computer, software including the drivers needs to be copied (installed) to the computer's hard disk. The installation □ If the Found New Hardware or Found New process takes about 20 minutes. (The installation time varies depending on the Hardware Wizard dialog box appears: computer environment or the number of applications to be installed.) The screens below are based on Windows Vista operating system Ultimate Edit
ملخص المحتوى في الصفحة رقم 17
Install the Software 1 2 □ For Windows Vista/ XP TURN OFF THE Turn on the computer, then If you are using Internet A MACHINE (A). insert the Setup CD-ROM into Explorer 7 or later, the CD-ROM drive. you can use the Web print software Easy- The setup program will start WebPrint EX. An internet automatically. connection is required for installation. (It is also possible to install this software later.) • Operating noise continues • If the program does not start automatically, double-click
ملخص المحتوى في الصفحة رقم 18
Install the Software Windows Vista 3 Windows XP/2000 Click Run Msetup4.exe on the AutoPlay screen, then click Continue on the User Account Control dialog box. If the User Account Control dialog box reappears in following steps, click Continue. 3 Double-click the Setup icon of the CD-ROM folder to proceed to the following screen. Enter your administrator name and password, then click OK. If you do not know your administrator name or password, click Help, then follow the on-screen instructions.
ملخص المحتوى في الصفحة رقم 19
Install the Software 4 5 Click Easy Install. Click Install. The drivers, application software, and on-screen manuals are installed all together. For Windows Vista/XP • If you are using Internet Explorer 7 or later, you can use the Web print software Easy-WebPrint EX. An internet connection is required for installation. (It is also • If you want to select particular items to install, click Custom Install. possible to install this software later.) USB Connection
ملخص المحتوى في الصفحة رقم 20
Install the Software 6 Important Information for the Installation □ Necessary Information for the User □ About Extended Survey Program Registration B Select Use the printer via USB, then click Next. Follow any on-screen instructions to proceed with the software installation. The product serial number is required when If you can agree to Extended Survey Program, registering the product. The serial number is click Agree. located inside the machine (as shown in the If you click Do not agree, th
