ملخص المحتوى في الصفحة رقم 1
�
�
�
�
KM60100_ownman_v1.indd 1 11/21/05 10:38:34 PM
ملخص المحتوى في الصفحة رقم 2
Caution: To reduce the hazard of electrical shock, do not remove cover or back. No user serviceable parts inside. Please refer all servic- ing to qualified personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the products enclosure that may be of sufficient magni- tude to
ملخص المحتوى في الصفحة رقم 3
Table of Contents Introduction 2 Hartke KM60 and KM100 Keyboard Amplifier Features 3 Guided Tour - Front Panel 4 Guided Tour - Rear Panel 6 Setting Up and Using Your KM60 and KM100 7 Using the Footswitch Jack and Effects Loop 9 KM60 and KM100 Sample Settings 10 Specifications 13 Copyright 2005, Samson Technologies Corp. Printed November, 2005 v1.2 Samson Technologies Corp. Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 516-364-3888 KM60100_ownman_v1.indd 1 11/21/05 10:38:36 PM
ملخص المحتوى في الصفحة رقم 4
Introduction Congratulations on purchasing the Hartke KM60 or KM100 Keyboard Amplifier! The KM60 and KM100 are perfect solutions for just about any keyboard player who needs a flexible mix /moni- tor system to handle a sophisticated instrument rig, and who demands a high quality ampli- fier that faithfully reproduces the sound, nuances, and soul, of their performance. The KM60 achieves this goal by delivering a solid 60 watts of power, driving a custom designed Hartke 10” aluminum cone low
ملخص المحتوى في الصفحة رقم 5
Hartke KM60 and KM100 Keyboard Amplifier Features � � � � The Hartke KM60 and KM100 keyboard amplifiers offer all the newest concepts in Keyboard amplification. Here are some of their main features: • Four Channel Keyboard mixer amplifier with 2-way speaker system. • Microphone input, plus 3 additional mono input channels. • T he KM60 features 60 Watts of clean Hartke power while the KM100 provides 100 Watts, delivered to thier 2-way internal speaker system. • F or rocking lows, the KM6
ملخص المحتوى في الصفحة رقم 6
Guided Tour - Front Panel � � � � � � � � � � � 1. Channel 1 MIC IN - XLR input connector for connecting to Channel 1’s Low-noise Microphone Pre-amp. 2. A UX IN/CD - Your KM Series amplifier features a CD input which you can use with a por- table CD player, cassette, mini disk or MP3 player. You can use the CD input to jam with pre- recorded tracks or to learn a riff from a favorite recording. 3. Channel 1 Volume - Control knob is used to control the overall level of the Channel 1 input. 4.
ملخص المحتوى في الصفحة رقم 7
Guided Tour - Rear Panel � � � � � �� � � � � A A C INLET - Connect the supplied standard IEC power cable here. B. Direct Output XLR - This connector carries the Balanced signal from the KM60 or 100's mixer output and can be used to connect to the main PA mixer. C. Channel 3 Input - 1/4-inch phone jack for connecting line level inputs. Use this input if you are connecting a mono signal source. D. Channel 1 Input - 1/4-inch phone jack for connecting line level inputs like those fro
ملخص المحتوى في الصفحة رقم 8
Setting Up and Using Your Hartke KM60 and KM100 Keyboard Amplifier KM200 Basic Operation Setting up your Hartke KM60 or Km100 Keyboard amplifier is a simple procedure which takes only a few minutes: 1. Remove all packing materials (save them in case of need for future service) and decide where the amplifier is to be physically placed. To avoid potential overheating problems, be sure that the rear panel is unobstructed and that there is good ventilation around the entire unit. 2. Connect
ملخص المحتوى في الصفحة رقم 9
Setting Up and Using Your Hartke KM60 and KM100 Keyboard Amplifier 6. Set the output of your keyboard to about 3/4’s the way up and then, while playing, slowly turn the main Volume control up until the desired level is achieved. If you hear distortion even at low amplifier Master volume settings, back off the output of your Keyboard (or check for a faulty cable). 7. Next, experiment with the KM60 or KM100's graphic equalizer. Begin by setting each of the seven sliders to their flat
ملخص المحتوى في الصفحة رقم 10
Using the KM60 and KM100's Set-ups Using the Direct Output The KM 60 and KM100 feature a Direct Out jack for connencting to the main PA systems. Use this electronically balanced XLR jack to route signal from the KM60 or KM100 to a professional mixing console or as a tap to a main PA system via a mic input on the console. The signal out- put from this jack is low impedance (100 ohm) with an output level of approximately -30 to -20 dB. You can also use the Direct Out jack to route signal to a
ملخص المحتوى في الصفحة رقم 11
About Equalization The Hartke KM60 or KM100 Keyboard amplifier gives you enormous control over shaping the sound of your keyboard rig, using a process called equalization. To understand how this works, it’s important to know that every naturally occur- ring sound consists of a broad range of pitches, or frequen- cies, combined together in a unique way. This blend is what gives every sound its distinctive tonal color. EQ controls allow you to alter a sound by boosting or attenuating speci
ملخص المحتوى في الصفحة رقم 12
About Equalization Then, one by one, raise and lower each slider, listening carefully to the effect of each. Note that turning all EQ controls up the same amount will have virtually the same effect as simply turning up the main Volume; conversely, turning them all down the same amount will have virtually the same effect as turning down the main Volume. Both approaches are pointless (after all, that’s why we gave you a main Volume control!) In many instances, the best way to deal with
ملخص المحتوى في الصفحة رقم 13
Specifications Nominal Input Level Mic Input (CH1) -50 dBu. Line Inputs ( CH1 - CH4) -20 dBu. Nominal Output Level Line Out +4 dBu Stereo Line 0 dBu Rated Output Power KM60 60 watts KM100 100 watts Total Harmonic Distortion less than .5% Equalizer Seven-Band Graphic (Main Output) ±12 dB, center @ 100 Hz, 250 Hz, 500 Hz, 1 kHz, 2.5 kHz, 5 kHz, 10 kHz Connectors Ch1-4 Input 1/4” phone Mic Input XLR Line Output XLR Aux In Left and Right RCA Headphone - St. TRS 1/
ملخص المحتوى في الصفحة رقم 14
KM60 and KM100 Block Diagram 12 KM60100_ownman_v1.indd 12 11/21/05 10:38:47 PM
ملخص المحتوى في الصفحة رقم 15
KM60100_ownman_v1.indd 13 11/21/05 10:38:48 PM
ملخص المحتوى في الصفحة رقم 16
Hartke Phone:(1-800-372-6766) Fax: 516-364-3888 www.hartke.com KM60100_ownman_v1.indd 14 11/21/05 10:38:48 PM
