ملخص المحتوى في الصفحة رقم 1
AS182ATNDA
AU182AFNBA
(HSU-18CW03/R1)
AS162ATNCA
AU162AFNAA
(HSU-16CW03/R1)
AS072AZBDA
AU072ABBAA
(HSU-07HW03/R1)
AS072AZNDA
AU072ABNAA
(HSU-07CW03/R1)
ملخص المحتوى في الصفحة رقم 2
Contents Cautions 1-2 Parts and functions 3-6 Operation 7-14 Maintenance 15-17 Trouble shooting 18
ملخص المحتوى في الصفحة رقم 3
Cautions Disposal of the old air conditioner All these valuable materials may be taken to a waste collecting center and used Before disposing an old air conditioner again after adequate recycling. that goes out of use, please make sure it's inoperative and safe. Unplug the air Consult your local authorities for the name conditioner in order to avoid the risk of and address of the waste materials child entrapment. collecting centers and waste paper disposal services nearest to your house. I
ملخص المحتوى في الصفحة رقم 4
Cautions Always remember to unplug the air conditioner before opening inlet grill. Never unplug your air conditioner by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet. All electrical repairs must be carried Series 07 16,18 out by qualified electricians. Inadequate 2 2 type 3G1.5MM 3G2.0MM repairs may result in a major source of Series 07 danger for the user of the air conditioner. 2 2 type 3G1.5MM +2G0.75MM Do not damage any parts o
ملخص المحتوى في الصفحة رقم 5
Parts and Functions Indoor Unit Inlet grill Air filter Vertical flap Timer mode indicator Operation mode indicator Power Use remote controller to Lights up when unit starts. Lights up when Timer Lights up during compressor adjust up and down air flow. operation is selected. running. (Don't adjust it manually.) AS072AZBDA AS072AZNDA AU072ABBAA AU072ABNAA (HSU-07HW03/R1) (HSU-07CW03/R1) Test running Used only for test running in cooling when room temp. is below 16 . Inlet grill Don't
ملخص المحتوى في الصفحة رقم 6
For models: For models: AU182AFNBA AU162AFNAA AU072ABBAA AU072ABNAA (HSU-18CW03/R1) (HSU-16CW03/R1) (HSU-07HW03/R1) (HSU-07CW03/R1) Power Failure Resume (to be applied for a necessary situation): After the power failure compensation is set, if power failure suddenly occurs while the air conditioner is working, it will resume the previous working state when the power is again. Setting Method: When the remote controller is on (excluding timer mode and fan mode), press the " SLEEP " button on the r
ملخص المحتوى في الصفحة رقم 7
Parts and Functions Operation Buttons and display of the remote Power TEMP. Used for unit start and Used to select stop. your AUTO FA SWING Used to select fan AM PM Used to set auto speed: ON OFF fan AM AM PM PM SLEEP TEMP MODE ON Used to select sleep OFF SWING FAN mode. Used to select AUTO run, COOL,DRY,HEAT and MODE SLEEP FAN operation. SET CLOCK SET Used to confirm Timer TIMER and Clock settings. CLOCK RESET LOCK CODE Used to set correct time Used to set correct Used to select code
ملخص المحتوى في الصفحة رقم 8
Parts and Functions Buttons and display of the remote Operation HEA DR AUTO FAN COOL AM PM ON O FF AM AM PM PM SIGNAL SENDING AUT TEMP ON TEMP OFF SWING FAN SWING MODE SLEEP CLOCK CLOCK SET FAN TIMER MED LO LOCK RESET LOCK AUT HI TIMER OFF AUT TIMER ON SLEEP Clock When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows: Press CLOCK button, "AM" or "PM" flashes. Press or to set correct time. Each press will in
ملخص المحتوى في الصفحة رقم 9
ملخص المحتوى في الصفحة رقم 10
Operation Auto run, Fan operation Enjoy yourself by just a gentle press. (1) Unit start Press ON/OFF button, unit starts. Previous operation status appears on display. (Not Timer setting) AUTO (2) Select operation mode Press MODE button. For each press, AM operation TEMP AUT DR HEA FA COOL ON SWING OFF FAN 1 Unit will run in selected mode. 3 4 Stop display at " " AUTO or " " FAN. MODE SLEEP CLOCK SET 2 (3) FAN TIMER Press FAN button. For each press, fan speed changes LOCK RESET MED
ملخص المحتوى في الصفحة رقم 11
Operation COOL, HEAT and DRY operation Recommendations: Use COOL in summer. Use HEAT in winter. Use DRY in spring, autumn and in damp climate. (1) Unit start Press ON/OFF button, unit starts. Previous operation status appears on display. (Not Timer setting) AUTO Power indicator on indoor unit lights up. (2) Select operation mode AM Press MODE button. For each press, operation TEMP 3 ON AUT COOL DR HEA FA 5 OFF SWING FAN 1 4 6 Unit will run in operation mode displayed on MODE SLEEP LCD. 2 CLOC
ملخص المحتوى في الصفحة رقم 12
Operation (5) Air flow direction adjustment After operation mode is selected, vertical flap will open automatically according to the mode. Referring to the Fig. COOL HEAT o o About 10 About 60 Up and down (Use remote controller) Left and right air flow adjustment (manual) Press SWING button, vertical flap will move within the range shown in the Fig. Press SWING button Move the horizontal blade by a knob on stop it at a fixed position. air conditioner to adjust left and right direction o Abou
ملخص المحتوى في الصفحة رقم 13
Operation TIMER operation Set Clock correctly before starting Timer operation(referring to page 6) You can let unit start or stop automatically at following times: Before you wake up in the TIMER ON/OFF (1)After unit start, select your desire operation mode. Operation mode will be displayed on LCD. Power indicator on indoor unit lights up. (2)TIMER mode selection Press TIMER button to change TIMER mode. AM Every time the button is pressed, display changes as ON AM blan ON ON OFF OFF TIMER ON-
ملخص المحتوى في الصفحة رقم 14
Operation TIMER ON-OFF (1)After unit start, select your desired operation mode Operation mode will be displayed on LCD. Power indicator on indoor unit lights up. (2) Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows: blan ON OFF ON OFF TIMER OFF TIMER ON TIMER ON-OFF AM Select TIMER ON-OFF. "ON" will ON OFF AM AM (3)Time setting for TIMER ON TEMP Press HOUR Every time the button is pressed, time increases 10min. ON OFF SWING FAN If but
ملخص المحتوى في الصفحة رقم 15
Operation Emergency operation and test operation Emergency Carry out this operation only when the remote controller is defective or lost. When the emergency operation switch is pressed, a " Pi " sound starts once, which means the start of this operation. In this operation, it is not possible to change the settings of temperature and air flow speed, it is also impossible to do an operation by the timer. Room Designated Designated Timer Air Operatio temperature temperatur temperatur
ملخص المحتوى في الصفحة رقم 16
Operation Comfortable SLEEP AM Before going to bed at night, you can simply press TEMP ON the SLEEP button and unit will bring you a sound OFF SWING FAN sleep in selected mode. MODE SLEEP CLOCK SET TIMER LOCK RESET In COOL mode One hour after SLEEP mode starts, temp. will o become 1 C higher than temp. setting. After o running for another 1 hour, temp. rises by 1 C further. Unit will run for 6 hours then stops automatically. Temp. is higher than temp. setting so that room temp. won
ملخص المحتوى في الصفحة رقم 17
Maintenance Cleaning of unit casing Cut off power supply before cleaning wipe unit casing with soft cloth. In case of heavy stain, clean it with neutral detergent. squeeze water in the cloth, wipe off the detergent on unit Cleaning of remote controller Don't use water to wash unit casing, please use dry cloth. Don't use glass cleanner or cloth soaked with chemicals. Cleaning of air filter
ملخص المحتوى في الصفحة رقم 18
Maintenance
ملخص المحتوى في الصفحة رقم 19
Maintenance Better use of air conditioner Proper room Cleaning of the air filter. Once every Proper temperature Effective use of the Closing of doors and windows during operation. Curtains or blinds for windows Avoid time- wasteful Never fail to observe the Do not sprinkle water over Do not block the inlet or the unit. outlet. Do not pull power plug. Do not use for other Such as food preservation, plant cultivation, or animal breeding.
ملخص المحتوى في الصفحة رقم 20
Trouble Shooting Before asking for service, check the following first. Phenomenon Cause or check The system does not restart When unit is stopped, it won't restart immediately until 3 minutes have elapsed immediately. to protect the system. When the electric plug is pulled out and reinserted, the protection circuit will work for 3 minutes to protect the air conditioner. During unit operation or at stop, a swishing Noise is heard. or gurgling noise may be heard. At first 2-3 minutes after
