Carrier CPLPCONV006A00 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Small Packaged Products
Standard Altitude Only 0–2000 ft
Accessory LP Conversion Kit
Cancels: IIK 582A-18-6 IIK 582A-18-7
1-01
Installation Instructions
60,000–130,000 Btu/hr
Part Number: CPLPCONV006A00 2 to 5 Tons
NOTE: Read the entire instruction manual before starting the
Firing Tube
installation.
This symbol → indicates a change since the last issue.
SAFETY CONSIDERATIONS
Installing and servicing air conditioning equipment can be hazard-
ous due to system fuels. Only trained and qualified pe

ملخص المحتوى في الصفحة رقم 2

5. Disconnect yellow flame sensor wire from the ignition con- 12. Replace the manifold/gas valve assembly into the burner trol. assembly using the four screws saved from Step 10. 6. Remove the screw securing the brown wire from the burner 13. Reconnect the blue wires to the rollout switch and reinstall assembly and the green wire from the induced-draft motor at rollout switch. the sheet metal partition. Save screw. 14. Reconnect the gray wire removed in Step 7 to terminal 1 (M1) 7. Disconnect th

ملخص المحتوى في الصفحة رقم 3

→ Table 2–LP Gas Orifice Sizes LP GAS ORIFICE GAS SUPPLY PART NO. LP NOMINAL MANIFOLD PRESSURE NUMBER OF AND SIZE UNIT SIZES HEATING PRESSURE (IN W/C) (LP) ORIFICES ALTITUDE (FT) INPUT (BTUH) (IN W/G) (LP) MIN MAX 0–2000 2001–6000 018040 THIS KIT APPLIES TO MODELS WITH HEATING INPUT OF 024040 40,000 57,000 BTUH AND HIGHER. FOR 40,000 BTUH MODELS USE KIT # CPLPCONV008A00 030040 024060 030060 LH32RF080 57,000 2 4.0 13.0 3.5 036060 No. 46 042060 THIS KIT APPLIES TO STANDARD ALTITUDE 036090 INSTALLA

ملخص المحتوى في الصفحة رقم 4

CLOSED END BURNER (3) FLAME SENSOR CLOSED END MANIFOLD BURNER RACK PIPE PLUG SPARKER GAS VALVE ORIFICE (3) 85,500 BTUH TO 127,000 BTUH UNITS CLOSED END BURNER (2) CLOSED END FLAME SENSOR MANIFOLD BURNER RACK PIPE PLUG SPARKER GAS VALVE ORIFICE (2) 57,000 BTUH UNITS C00149 → Fig. 2–Orifice Installation 4

ملخص المحتوى في الصفحة رقم 5

THIS APPLIANCE HAS BEEN CONVERTED TO LP. GAS. KIT NO. _______________________ BY _______________________ DATE: ________ WHO ACCEPTS THE RESPONSIBILITY FOR THE CORRECTNESS OF THIS CONVERSION. 48SS500283 A99309 → Fig. 3–Conversion Responsibility Label ROLLOUT SWITCH BURNER BRACKET C00150 → Fig. 4—Burner Bracket 5

ملخص المحتوى في الصفحة رقم 6

6

ملخص المحتوى في الصفحة رقم 7

7

ملخص المحتوى في الصفحة رقم 8

Copyright 2001 Carrier Corporation iik582a187 Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations. Book 1 4 PC 101 Catalog No. 534-80021 Printed in U.S.A. Form 48-15SI Pg 8 1-01 Replaces: 48-14SI Tab 1a 1a