Clarion VMA633 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

VMA633


VMA633
6.5 INCH WIDE LCD MONITOR



6.5” WIDE ACTIVE MARTIX TFT
COLOUR LCD MONITOR



OWNER’S MANUAL

INSTALLATION GUIDE

ملخص المحتوى في الصفحة رقم 2

OWNER’S MANUAL WARNING! THE CLARION VMA633 LCD MONITOR IS DESIGNED FOR NAVIGATION PURPOSE AND REAR SEAT PASSENGER VIEWING ONLY. THIS PRODUCT IS NOT INTENDED FOR VIEWING MOVIES BY THE DRIVER WHILE THE VEHICLE IS IN MOTION. SUCH USE MAY DISTRACT THE DRIVER OR INTERFERE WITH THE DRIVER’S SAFE OPERATION OF THE VEHICLE AND MAY RESULT IN SERIOUS INJURY OR DEATH. SUCH USE MAY ALSO VIOLATE STATE LAW. CLARION DISCLAIMS ANY LIABILITY FOR ANY BODILY INJURY, INCLUDING FATALITIES, OR PR

ملخص المحتوى في الصفحة رقم 3

DESCRIPTION BUTTONS VMA633 6.5” TFT LCD Monitor PRECAUTIONS: This monitor is intended for use in DC 12V, negative ground vehicles. Do not operate the monitor in ways other than described in this guide, doing so may cause damage and void the warranty. Be careful not to run down the car’s battery while using a multimedia system with the engine stopped. Doing so may damage the vehicle’s battery or the multimedia system. Do not disassemble or modify monitor. Doing so may damag

ملخص المحتوى في الصفحة رقم 4

OWNER’S MANUAL DESCRIPTION OF PICTURE ADJUSTMENT: Press the PICTURE SELECT button several times, the screen will display the picture control Bar in the following order sequentially. (BLANK)àBRIGHTNESSàCONTRASTàCOLOURàTINTàDIMMERàMEM RESET Before the display disappears, use the PICTURE SELECT UP (VOLUME UP) button or PICTURE SELECT DOWN (VOLUME DOWN) button, to adjust the picture quality. COLOUR DOWN

ملخص المحتوى في الصفحة رقم 5

NSTALLATION I *CCE-001 VMA633 6.5” TFT LCD Monitor 1. Look over the vehicle for a monitor location. Each vehicle is different and locations will vary. Make sure the monitor will not interfere with the driver’s safe operation of vehicle. 2. Once a location has been determined, run the 3.5 mm IR extension, Video Composite and power Molex connector into the monitor’s mounting location. 3. Plug main cable into the monitor. 4. Run the IR extension, video, and power cables to their r

ملخص المحتوى في الصفحة رقم 6

OWNER’S MANUAL TROUBLESHOOTING: Symptom Cause Solution System does not Fuse is blown. Replace external fuse with the same work value. Power wires are not Check the wire connections and connected. Connect it properly. The screen dark. The brightness is adjusted Check that the brightness is proper- too low. ly adjusted, if not adjust it properly. Usage conditions are poor. This may happen if th