Atlas GUARDIAN PLMS دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

TEST
Put ON-TIME switch on the sensor bottom to
TEST and the Dual Light Level (ACCENT)
switch OFF.
ON-TIME
ACCENT
™
GUARDIAN PRO
TEST 1 5 20 Off 3 6 Dusk to Dawn
POST SENTRY
AUTO
Model PLMS
Set ON-TIME switch to
1, 5, or 20 minutes.
TEST 1 5 20 MIN
Features
• Light comes on when motion is detected.
MANUAL MODE
• Automatically controls existing post light.
• Dual Light Level.
Manual mode only works at
• Photocell keeps the light off during day-
night because daylight re-
light hours.
turns the se

ملخص المحتوى في الصفحة رقم 2

INSTALLATION ❒ Turn power off at circuit breaker. ❒ On existing installations, remove the light from the top of the post. Keep the wire connectors to make the connections to the top of the sensor. CAUTION: When handling the sensor be careful not to pinch or distort the lens. Green sensor You may break the seal and cause wind- wire to Green or Red sensor blown rain to enter the sensor. bare fixture wire wire to Black ❒ Remove the three screws around the fixture wire bottom edge of the sensor. Sav

ملخص المحتوى في الصفحة رقم 3

❒ When you have the desired coverage ADJUSTMENTS angle make a pencil mark on the sensor and post to mark the sensor position. ❒ Turn on the circuit breaker and light ❒ If you need to change the sensitivity, switch. temporarily lift the fixture and sensor to 1 NOTE: Sensor has a 1 / minute warm up 2 make the adjustment. It may be neces- period before it will detect motion. When sary to have a friend hold the fixture first turned on or when switching from while adjusting the sensitivity. Too much

ملخص المحتوى في الصفحة رقم 4

TROUBLESHOOTING GUIDE If you experience a problem with your Light Control, first follow this guide. For additional assistance write to: Atlas Lighting Products, Inc. • Customer Service Department • P.O. Box 2348 • Burlington, NC 27216 SYMPTOM POSSIBLE CAUSE SYMPTOM POSSIBLE CAUSE Light will 1. Light switch is turned off. Light stays on 1. The sensor is pointed at nearby not come 2. Bulb is loose or burned out. continuously. objects that cause heat to trigger on. 3. Fuse is blown or circuit brea