Barracuda Networks ST340824A دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Computer
Motherboard
• Master or single-drive: The drive is shipped configured for a master
or a single-drive with a jumper set on pins 7 and 8.
• Drive is slave: To configure the drive as a slave, or second drive on
®

Barracuda ATA III Family Installation Guide
the cable, remove all the jumpers.
ST340824A, ST330620A, ST320414A, ST315310A, ST310215A
• Master with non-ATA compatible slave: Use this setting if the slave
drive is not recognized. Configure the master drive with a jumper set on
Pub

ملخص المحتوى في الصفحة رقم 2

For more information, see the earlier section on the Ultra ATA/100 Preparing the Drive with Disk Manager or DiscWizard requirements. In addition, some legacy BIOS may cause a hang due Installing a Single Drive to the large drive capacity. Consider using the alternate capacity If you are installing a single drive, we recommend using Disk Manager jumper if it is available on your drive model. to automatically partition and format your drive. Disk Manager software Use the alternate capacity jumper