ملخص المحتوى في الصفحة رقم 1
MVME2400-Series
Single Board Computer
Installation and Use
V2400A/IH1
ملخص المحتوى في الصفحة رقم 2
Notice While reasonable efforts have been made to assure the accuracy of this document, Motorola, Inc. assumes no liability resulting from any omissions in this document, or from the use of the information obtained therein. Motorola reserves the right to revise this document and to make changes from time to time in the content hereof without obligation of Motorola to notify any person of such revision or changes. No part of this material may be reproduced or copied in any tangible medium, or
ملخص المحتوى في الصفحة رقم 3
Preface The MVME2400-Series VME Processor Module Installation and Use manual provides information you will need to install and use your MVME2400-series VME processor module. The MVME2400 VME processor module is based on an MPC750 PowerPC microprocessor, and features dual PCI Mezzanine Card (PMC) slots with front panel and/ or P2 I/O. The MVME2400 is currently available in the following configurations: Model MPC Memory Handles MVME2401-1 MPC750 32MB ECC SDRAM Scanbe Handles @ 233 MHz MVME2401
ملخص المحتوى في الصفحة رقم 4
This manual is intended for anyone who wants to design OEM systems, supply additional capability to an existing compatible system, or work in a lab environment for experimental purposes. A basic knowledge of computers and digital logic is assumed. Document Terminology Throughout this manual, a convention is used which precedes data and address parameters by a character identifying the numeric format as follows: $ Dollar Specifies a hexadecimal character 0x Zero-x % Percent Specifies a binary
ملخص المحتوى في الصفحة رقم 5
Safety Summary Safety Depends On You The following general safety precautions must be observed during all phases of operation, service, and repair of this equipment. Failure to comply with these precautions or with specific warnings elsewhere in this manual violates safety standards of design, manufacture, and intended use of the equipment. Motorola, Inc. assumes no liability for the customer’s failure to comply with these requirements. The safety precautions listed below represent warnings of
ملخص المحتوى في الصفحة رقم 6
This equipment generates, uses, and can radiate electro-magnetic energy. It may cause or be susceptible to electro-magnetic interference (EMI) if not installed ! and used in a cabinet with adequate EMI protection. WARNING If any modifications are made to the product, the modifier assumes responsibility for radio frequency interference issues. Changes or modifications not expressly approved by Motorola Computer Group could void the user’s authority to operate the equipment. European Notice:
ملخص المحتوى في الصفحة رقم 7
All Motorola PWBs (printed wiring boards) are manufactured by UL-recognized manufacturers, with a flammability rating of 94V-0. The computer programs stored in the Read Only Memory of this device contain material copyrighted by Motorola Inc., 1995, and may be used only under a license such as those contained in Motorola’s software licenses. The software described herein and the documentation appearing herein are furnished under a license agreement and may be used and/or disclosed only in acc
ملخص المحتوى في الصفحة رقم 8
ملخص المحتوى في الصفحة رقم 9
Contents CHAPTER 1 Preparing and Installing the MVME2400-Series Module Introduction................................................................................................................1-1 MVME240x Description ...........................................................................................1-1 MVME240x Module...........................................................................................1-2 PMCspan Expansion Mezzanine ...............................................
ملخص المحتوى في الصفحة رقم 10
BFL (DS1)................................................................................................... 2-4 CPU (DS2) .................................................................................................. 2-4 PMC2 (DS3)................................................................................................ 2-4 PMC1 (DS4)................................................................................................ 2-4 10/100 BASET Port...................................
ملخص المحتوى في الصفحة رقم 11
Interrupt Controller (MPIC)..............................................................................3-28 Programmable Timers.......................................................................................3-28 Interval Timers ..........................................................................................3-28 16/32-Bit Timers........................................................................................3-29 CHAPTER 4 Programming the MVME240x Introduction............
ملخص المحتوى في الصفحة رقم 12
APPENDIX A Ordering Related Documentation Motorola Computer Group Documents.................................................................... A-1 Manufacturers’ Documents ...................................................................................... A-2 Related Specifications .............................................................................................. A-5 APPENDIX B Specifications Specifications..........................................................................
ملخص المحتوى في الصفحة رقم 13
List of Figures Figure 1-1. MVME240x Switches, LEDs, Headers, Connectors ..............................1-9 Figure 1-2. General-Purpose Software-Readable Header........................................1-11 Figure 1-3. Typical Single-width PMC Module Placement on MVME240x ..........1-15 Figure 1-4. PMCspan-002 Installation on an MVME240x .....................................1-17 Figure 1-5. PMCspan-010 Installation onto a PMCspan-002/MVME240x ............1-19 Figure 2-1. MVME240x DEBUG Port Configu
ملخص المحتوى في الصفحة رقم 14
xiv
ملخص المحتوى في الصفحة رقم 15
List of Tables Table 1-1. MVME240x Models.................................................................................1-2 Table 1-2. PMCspan Models......................................................................................1-3 Table 1-3. Start-Up Overview ...................................................................................1-4 Table 3-1. MVME240x Features ..............................................................................3-1 Table 3-2. Power Requirements...
ملخص المحتوى في الصفحة رقم 16
xvi
ملخص المحتوى في الصفحة رقم 17
1Preparing and Installing the 1 MVME2400-Series Module Introduction This chapter provides a brief description of the MVME2400-Series VME Processor Module, and instructions for preparing and installing the hardware. In this manual, the name MVME240x refers to all models of the MVME2400-series boards, unless otherwise specified. MVME240x Description The MVME2400-series VME processor module is a PCI Mezzanine Card (PMC) carrier board. It is based on the PowerPC™ 750 microprocessor, MPC750. Tw
ملخص المحتوى في الصفحة رقم 18
Preparing and Installing the MVME2400-Series Module 1 MVME240x Module The MVME240x module is a powerful, low-cost embedded VME controller and intelligent PMC carrier board. The MVME240x is currently available in the configurations shown in Table 1-1. The MVME240x includes support circuitry such as ECC SDRAM, PROM/Flash memory, and bridges to the Industry Standard Architecture (ISA) bus and the VMEbus. The MVME240x’s PMC carrier architecture allows flexible configuration options and easy upg
ملخص المحتوى في الصفحة رقم 19
MVME240x Description 1 Support for two IEEE P1386.1 PCI mezzanine cards is provided via eight 64-pin SMT connectors. Front panel openings are provided on the MVME240x board for the two PMC slots. In addition, there are 64 pins of I/O from PMC slot 1 and 46 pins of I/O from PMC slot 2 that are routed to P2. The two PMC slots may contain two single-wide PMCs or one double-wide PMC. There are also two RJ45 connectors on the front panel: one for the Ethernet 10BaseT/100BaseTX interface, and o
ملخص المحتوى في الصفحة رقم 20
Preparing and Installing the MVME2400-Series Module 1 The MVME240x board supports both front panel I/O and rear panel P2 I/O through either PMC slot 1 or PMC slot 2. 64 pins of I/O from slot 1 and 46 pins of I/O from slot 2 are routed directly to P2. VMEsystem Enclosure Your MVME240x board must be installed in a VMEsystem chassis with both P1 and P2 backplane connections. It requires a single slot, except when PMCspan carrier boards are used. Allow one extra slot for each PMCspan. System Co
