Foundations 100-EH دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Model 100-EH
Horizontal Diaper Changing Station
Installation Instructions
WARNING
• Failure to follow these warnings and the installation instructions could result in serious injury
or death.
• Read all instructions before installing diaper changing station. Keep these instructions. DO NOT
discard.
SI253D-Gen

ملخص المحتوى في الصفحة رقم 2

ASSEMBLY INSTRUCTIONS ADULT INSTALLATION REQUIRED. A B TOOLS REQUIRED: Level (A) Measuring tape (B) Power drill with 7/32”, 1/8” and 1/2” masonry bits (C) C D Power screwdriver with bull nose phillips bit (D) • READ ALL INSTRUCTIONS BEFORE ASSEMBLY OF Diaper Changing Station. • Unpack carton and identify all parts. PARTS LIST Parts Description Quantity Hardware for installation: 3” Wood Screws 4 3/4” Finishing Washers 4 3” Machine Screws 2 3/4” Flat Washers 4 Toggle Anchors 2 1-1/4” Caps 6 Door

ملخص المحتوى في الصفحة رقم 3

WARNING • A stud MUST be located and used for at least one side of the diaper changing station. • The diaper changing station is no stronger than the anchors or walls to which they are attached and, therefore, MUST be firmly secured in order to support the weight they are intended to support. Contact an architect or building contractor if any questions. INSTALLATION 1. Locate wood stud where left side of changing station will be mounted to the wall. 2. Measure up 46” (117 cm) from the floor and

ملخص المحتوى في الصفحة رقم 4

RECOMMENDED BLOCKING: Top If the walls do not have studs on center, then additional blocking is necessary (Fig. e). Contact an architect or building contractor to make sure the blocking 8 1/4" (210 mm) is adequate and complies with building codes. For A. D. A. OPERATION: Compliance 46” (117 cm) 32" Rotate base downward. Place infant on top of the changing surface. (813 mm) on center Use restraint system as described below. After child has been changed, remove restraint system and rotate base bac