Southbend SB1313 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Instruction Sheet
Model SB1313
High Precision 6" Lathe Chuck
Four hardened steel jaws Grease fitting for
for durability and complete internal
extreme clamping lubrication
Chucks are heavy! Get assistance when
force and grip
installing or removing the chuck from the
lathe. Wear heavy duty leather boots for
Designed for
foot and toe protection, and keep hands and
up to
fingers away from all pinch points. Ignoring
2000 RPM
this warning can lead to a severe crushing
Universal
injury or fi

ملخص المحتوى في الصفحة رقم 2

6. Remove the back plate from the lathe and 6. While the back plate is still installed in the Operation and Safety place it on a workbench. lathe, scribe a 147mm diameter centerline in • Chuck Key Safety: A chuck key left in the the face of the back plate. This centerline is chuck can become a dangerous projectile 7. Set the chuck on the back plate, and roughly for the chuck mounting bolt holes. when the spindle is started. Always remove align the chuck using the alignment set the chuc

ملخص المحتوى في الصفحة رقم 3

Care & Maintenance 3 5 ! 7 Always disconnect machine from power before 4 performing maintenance or serious personal injury may result. 6 1 For optimum performance from your chuck, Note: Each jaw is marked follow the maintenance schedule below, and 1, 2, 3, or 4 to correspond never hammer on the chuck, jaws, or a workpiece to its marked slot in the 2 clamped in the chuck. Never subject the chuck to chuck abrasives, flame, or water. Figure 2. Chuck sequence of disassembly. Daily: 5. U

ملخص المحتوى في الصفحة رقم 4

Troubleshooting If you need replacement parts, or if you are unsure how to do any of the solutions given here, feel free to call us at (360) 734-1540. Symptom Possible Cause Possible Solution The chuck has 1. Jaw is in wrong position. 1. Reinstall jaws in correct order and position on scroll hard spots or binds gear. completely. 2. Lack of lubrication, rust, burrs, or 2. Disassemble, de-burr, clean, and lubricate chuck. metal shavings inside of chuck. 3. Broken tooth on the pinion or the 3. Di