Snapper 1687099 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Clean-Out Tool Kit
Installation
Part No. 1687099
319 / 520 / 551 Single Stage, 5-13 HP
Instructions
Intermediate or Large Frame Snowthrowers
3
Kit Contents:
Ref. Part No. Qty. Description
1 1733209 1 CLEAN-OUT TOOL
5
2 1726727 1 BRACKET, Lower
4
3 1726728 1 CLIP
11
4 1726995 1 SPACER, 1-1/4” Long
1
5 1678392 1 SPACER, 11/32” Long
6 1960727 1 SCREW, Slotted, 10-24 x 2-1/2
10 7
6 7 1960589 1 SCREW, Phillips Head, 10-24 x 3/4
9
8 1933896 1 NUT, Nylock, 10-24
9 1960729 1 CAPSCREW, 5/16-18 x 1
10 196

ملخص المحتوى في الصفحة رقم 2

Installation Instructions Clean-Out Tool Kit C A C B A A B Figure 3. Mounting Lower Bracket (Channel Handle) Figure 2. A. Existing Hardware C. Handle, LH A. Existing Danger Decal C. New Danger Decal B. Lower Bracket B. Discharge Chute INSTALLATION B Decal Installation F 1. Clean and dry existing danger decal (A, Figure 2) and surrounding area. 2. Apply new decal (C) by removing the backing from decal and placing directly over existing decal (A) C aligning top edges of both decals. D E 16-3/8”

ملخص المحتوى في الصفحة رقم 3

Clean-Out Tool Kit Installation Instructions (TUBE HANDLE MODELS) 1. Remove existing hardware (A, Figure 5) from upper hole on left side handle (C) as shown. Discard cap- C screw (D). 2. Using square hole install lower bracket (B) into upper A hole on left side handle (C) as shown. Secure with new 5/16-18 x 2 capscrew (D) and nut (A). Note: In some cases the upper hole in the left side han- dle is crimped flat. If so use 5/16-18 x 1 capscrew (D). D 3. Measure 16-3/8” from top of bracket (A, Fi

ملخص المحتوى في الصفحة رقم 4

Installation Instructions Clean-Out Tool Kit D B F A B E C C D E H Figure 7. Mounting Lower Bracket (520) 15-3/8” A. Wing Lock Knob D. Handle, LH B. Lower Bracket E. Carriage Bolt, C. Screw, Curved Head 5/16-18 x 1-3/4 G (520 MODELS) 1. Remove wing lock knob (A, Figure 7) and carriage bolt (E) or screw (C) from hole on left side handle (D) as shown. Discard screw (C) if it was used originally. A 2. Using square hole install lower bracket (B) into hole on left side handle (D) as shown. Secure