Scotts ACCUGREEN 2000 75345 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

E
1
E
-
R
8
F
0
-
L
0
AccuGreen2000 Hang Tag 3/28/01 11:01 AM Page 1
SHUTOFF
Calibration
BAR
Your AccuGreen 2000 Spreader was calibrated at
® TM
the factory. You may check the calibration as follows:
1. Adjust the micrometer setting to 6.
CALIBRATION
2. Squeeze the trigger against the handle.
LINE
3. The front edge of the shutoff bar should be
aligned with the calibration line engraved on the
bottom of the hopper.
4. To adjust alignment, use a small wrench to turn the
black calibration scre

ملخص المحتوى في الصفحة رقم 2

AccuGreen2000 Hang Tag 3/28/01 11:01 AM Page 2 To use your new AccuGreen 2000 spreader: ® TM 5. If the lawn product you purchased does not give the setting for your Set up the stand and handle Scotts AccuGreen spreader, you can test for the proper setting. ® ® 1. Lay the spreader down so that it rests on the front of the hopper. Lift the stand and brace, Empty the number of pounds the manufacturer recommends for then spread the sides of the brace and insert 1,000 square feet into the sprea