ملخص المحتوى في الصفحة رقم 1
Steam 'n Press
Instructions for Use
REF. 3460984
40V
2
20V
1
ملخص المحتوى في الصفحة رقم 2
IMPORTANT SAFETY INSTRUCTIONS When using your Rowenta Steam 'n Press basic precau- tions should always be followed, including the following: Read all instructions before using the appliance. 1. Use appliance only for its intended use. 2. To protect against a risk of electric shock, do not immerse the appliance in water or other liquids. Do not use the appliance in a wet environment (on a wet floor, near a sink). 3. The appliance should always be turned to Minimum (Min) before plugging or u
ملخص المحتوى في الصفحة رقم 3
SPECIAL INSTRUCTIONS 1. This is a 1000 watt appliance. To avoid a circuit overload, do not operate a high wattage appliance on the same circuit. 2. If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over. 3. Your Rowenta appliance is intended for household use only. 4. IMPORTANT – Do not remove soleplate cover when appliance is hot. Turn thermost
ملخص المحتوى في الصفحة رقم 4
A BC D E 240 V 120 V K J I H G F Description: A Thermostat control dial G Soleplate cover lock B Burst of steam button H Lint pad C Removable water tank I Fabric brush D Cord protector J Ribbed finger grip E Voltage selector (120/240 V) K Soleplate cover F Polished soleplate 4
ملخص المحتوى في الصفحة رقم 5
USING FOR THE FIRST TIME Please read the instructions for use and the Important Safety instructions carefully. It is normal for a small amount of smoke to be produced the first time the appliance is used. This will quickly disappear. When the appliance is plugged in, and thermostat control dial is moved from the minimum setting, the soleplate heats. Do not touch or remove the sole- plate cover without letting the appliance cool down. During use or while unit is heating or cooling, do n
ملخص المحتوى في الصفحة رقم 6
Filling the water tank Remove cap, fill the tank with ordinary tap water and close the cap. Replacing the water tank Put the full water tank back into the unit, by sliding the lower handle back into the top half of the handle until it is firmly in place. Adding water during use Always unplug the appliance and wait for it to cool down before removing the water tank. Handle with care as unit will remain hot for a considerable time. Fill as indicated in water tank filling section.
ملخص المحتوى في الصفحة رقم 7
Removing the soleplate cover The steambrush should be unplugged and completely cool when removing or attaching the soleplate cover. To remove the soleplate cover (K) turn the soleplate cover lock (G) a half turn (180°) to the right. Grip the soleplate cover by the ribbed finger grips (J) on both sides as shown and pull towards the tip of unit to remove. Reference “Ironing Function“ section of instructions for further use information. IRONING FUNCTION The soleplate of the Steam 'n Press
ملخص المحتوى في الصفحة رقم 8
n i m Selecting the temperature Set the thermostat control dial (A) according to the type of fabric you are ironing. Check the fabric label for the appropriate setting. Fabric Temperature regulator synthetics nylon polyester (low temperature) silk wool (medium temperature) cotton linen (high temperature) Start at low temperature and graduate to high temperature . For delicate fabrics we recommend carrying out a test on an unobtrusive part of the garment (inner seam). Steam can only
ملخص المحتوى في الصفحة رقم 9
To avoid damage to clothes from dust or dirt that may collect in the appliance, we recommend that before the first use or after the appliance has been stored for some time you test the burst of steam on an old cloth. Steaming clothes Hang the wrinkled article of clothing on a clothes hanger. Pull the clothing tight with one hand and place the appliance over the creased area beginning at the top of garment. Gently press the fabric brush (I) against the clothing and move the appliance down
ملخص المحتوى في الصفحة رقم 10
CLEANING AND MAINTENANCE If the body and the handle become dirty they should be wiped with a damp cloth when the appliance is cold and unplugged. Do not use abrasive or other chemicals. Cleaning the soleplate In normal use a draggy coating may build up on the soleplate (starch, detergent buildup, burnt synthetic fibers). This can be easily removed by using the Rowenta Soleplate Cleaning Kit or a quality hot iron soleplate cleaner available at most stores. Do not use abrasive household cl
ملخص المحتوى في الصفحة رقم 11
STEAM 'N PRESS TROUBLE SHOOTING Problem Possible Cause Solution Leaking or Distilled water. Never use 100% distilled water. spitting. The Steam 'n Press is designed to use tap water. In very hard water areas we recommend using bottled spring water. Softened water. If you experience spitting or leaking with softened water, change to untreated tap water or bottled spring water. Thermostat set The thermostat needs to be set incorrectly. to the 3 dot setting to produce steam. Overuse of burst Allo
