ملخص المحتوى في الصفحة رقم 1
NOTE: The E100/E125/E150/E175 must be traveling up to 3 mph before motor will
engage. Kick start up to 3 mph while applying the throttle to engage motor.
OWNER’S MANUAL
Read and understand this entire manual before riding!
DO NOT RETURN TO STORE!
NOTE: Manual illustrations are for demonstration purposes only. Illustrations
may not reflect exact appearance of actual product. Specifications subject to
change without notice.
Please have your 19 digit product I.D. code ready before contac
ملخص المحتوى في الصفحة رقم 2
CONTENTS Safety Warnings ............................................................ 1 Repair and Maintenance ............................................. 5-6 Before You Begin ........................................................... 2 Troubleshooting Guide ................................................... 7 Assembly and Set-Up/Charging Battery ........................ 3 Electric Scooter Parts .................................................... 8 Pre-Ride Checklist/Usage ...............
ملخص المحتوى في الصفحة رقم 3
BEFORE YOU BEGIN Remove contents from box. Remove the foam separators that protect the components from damage during WARNING: shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have DO NOT USE NON- occurred during shipping. Because the scooter was 95 percent assembled and packed at the factory, there RAZOR PARTS WITH should not be any problems, even if the box has a few scars or dents. YOUR RAZOR ELECTRIC SCOOTER. MAKE SURE POWE
ملخص المحتوى في الصفحة رقم 4
CHARGING BATTERY WARNING: q Charging the Battery Rechargeable batteries are Charge the battery prior to use. only to be charged under adult supervision. Always disconnect • Initial charge time: 12 hours • To ensure long battery life, never store the product your scooter from the charger in freezing or below freezing temperatures! • Recharge time: up to 12 hours, even if the light before cleaning with damp cloth. Freezing will permanently damage the battery. turns green. R
ملخص المحتوى في الصفحة رقم 5
PRE-RIDE CHECKLIST Brake Hardware Check the brakes for proper function. When you squeeze the lever, Check all parts such as nuts, bolts, cables, fasteners, etc. q q the brake should provide positive braking action. Make sure that to ensure they are secure and assembled correctly. If the brakes are not rubbing. unit is damaged do not ride. Reference “Safety Warnings” on page 1 of this manual. Frame, Fork and Handlebars Check for cracks or broken connections. Although broken frames Laws and
ملخص المحتوى في الصفحة رقم 6
REPAIR AND MAINTENANCE Turn power switch “OFF” before conducting any maintenance procedures. q Adjusting the Brakes Tools required: 10 mm open wrench 1 To adjust brake cable play, 2 If brake is too tight or has too 3 Inspect the brake pads (A) thread the brake lever adjuster in or much slack, use a 10 mm open for proper alignment against out 1/4 to 1/2 turn until the desired wrench to loosen the brake cable the wheel or excess wear. To brake adjustment is attained. Most and adjust according
ملخص المحتوى في الصفحة رقم 7
REPAIR AND MAINTENANCE Note: Rear wheel hardware sequence 18-1 18-7 18-2 18-3 18-4 18-8 4 Remove wheel and install 5 Push the chain tensioner 6 With two 13 mm open 18-4 replacement wheel. down to install the chain on wrenches, re-tighten the (Note the sequence of the both sprockets. locknuts. 18-3 18-2 hardware) 18-7 18-1 Left Side (Brake) 18-1 13 mm Locknut 18-7 Spring Washer 18-2 Washer Frame 18-3 Washer (Plate Cut) 18-4 Spacer (Long) 7 Re-attach the chain guard. Middle 18-8 Rear Axle B
ملخص المحتوى في الصفحة رقم 8
*Unit(s) should be turned off and fully charged prior to doing any Troubleshooting NOTE: All troubleshooting steps should be performed by an adult only TROUBLESHOOTING GUIDE Problem Possible Cause Solution Does Not Work Out Of The Box Unit must be traveling up to 3 mph before Kickstart to 3 mph while applying the throttle to motor will engage engage motor Loose connection(s) Check for loose connections/wires underneath the deck plate No Longer Works Loose connection(s) Check for loose connec
ملخص المحتوى في الصفحة رقم 9
E100/E125/E150/E175 PARTS Maintain your scooter with genuine Razor parts. Visit our website or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 01 Handlebar grip (right/left) 10 Front wheel complete 18 Rear wheel complete (See pg. 5 for hardware sequence) (See pg. 6 for hardware sequence) 02 Single speed twist grip throttle 02-1 Sleeve 11 Battery tray 19 Chain Tensioner 03 Handlebar stem 12 Control module 20 Chain 04 Brake lever
ملخص المحتوى في الصفحة رقم 10
SB 1918 (CALIFORNIA) DECLARA TION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT. 9
ملخص المحتوى في الصفحة رقم 11
WARRANTY The manufacturer is not liable for incidental or consequential loss or damage Razor Limited Warranty due directly or indirectly to the use of this product. The manufacturer warranties this product to be free of manufacturing defects for a period of 90 days from date of purchase. This Limited Warranty does not Razor does not offer an extended warranty. If you have purchased an cover normal wear and tear, tires, tubes or cables, or any damage, failure or extended warranty, it must
