ملخص المحتوى في الصفحة رقم 1
Raypak Commercial
Swimming Pool Heaters
Part 1: Safety warning
Part 2: Models 538 to 4224
Part 3: Warranty
ملخص المحتوى في الصفحة رقم 2
CONTENTS Part 1: For Your Safety Part 2: Models 538 to 4224 Section 1. Installation Instructions Section 2. Owners Operating Instructions Part 3: Warranty // // Date of Installation: Model No. Serial No. Installed by: Purchased from: This Installation and Operating Instructions Manual is provided with the necessary information for the proper installation, operation and maintenance of your Raypak Heater. Please review and follow these procedures carefully. Keep this manual in a safe and accessibl
ملخص المحتوى في الصفحة رقم 3
PART 1 - FOR YOUR SAFETY For your safety WARNING do not operate this appliance Improper installation, adjustment, alteration, service or maintenance can before reading cause injury or property damage. For assistance or additional information this instruction consult your Raypak distributor, qualified installer, or service agency. booklet. WHAT TO DO IF YOU SMELL GAS? DO NOT try to light any gas appliance DO NOT touch any electrical switch. Turn off the gas supply at the gas meter Immediately,
ملخص المحتوى في الصفحة رقم 4
PART 1 - FOR YOUR SAFETY CAUTION! Ceramic Firetile Refractory is used in Raypak Heaters Possible risks of irreversible effects Harmful by inhalation May be irritating to the skin, eyes and respiratory system. WHEN HANDLING • Minimise airborne dust. • Wear an approved mask or respirator. • Avoid any contact with the skin and eyes. • Wear suitable loose-fitting, long-sleeved clothing. • Wear gloves and eye protection. • Consult Occupational Health and Safety Authority for any further information.
ملخص المحتوى في الصفحة رقم 5
Raypak Commercial Swimming Pool Heaters Part 2: Models 538 to 4224 6
ملخص المحتوى في الصفحة رقم 6
ملخص المحتوى في الصفحة رقم 7
PART 2 - SECTION I - INSTALLATION INSTRUCTIONS Raypak recommends a minimum length of HIGH WIND CONDITIONS Caution: The gas supply must be isolated from vertical flue of three (3) metres to ensure the heater during pressure testing of the gas On rare occasions or in areas where high correct draft. fitting line. winds frequently occur, it may be necessary to locate the heater a minimum of one (1) metre Dissipate test pressure before reconnecting to AGA Approved Cowl from high vertical walls, or in
ملخص المحتوى في الصفحة رقم 8
ملخص المحتوى في الصفحة رقم 9
PART 2 - SECTION I - INSTALLATION INSTRUCTIONS COMMISSIONING 11. Check that the gas supply is isolated and The digital display on the electronic thermostat with the main gas valve isolation switch turned will indicate the pool water temperature. WARNING: COMMISSIONING MUST ONLY BE off, check the boiler gas train and components UNDERTAKEN BY A PROPERLY AUTHORISED 17. Check that the flue is operating correctly for gas escapes. AND IN SOME CASES APPROPRIATELY or if there is evidence of Down draft e
ملخص المحتوى في الصفحة رقم 10
ملخص المحتوى في الصفحة رقم 11
PART 2 - SECTION II - OPERATING INSTRUCTIONS LOCATION OF CONTROLS FLOW SWITCH (ON SOME MODELS ONLY) MODELS 538 TO 2004, 2404, 2804, 3304, 3804 MODELS 2214, 2634, 3164, 3694, 4224 1. Flame Fail Reset (Illuminates on FAIL) 2. Alarm Fail & Mute Button (if fitted) 3. Alarm Siren (if fitted) 4. Temperature Control (Digital Thermostat) 1. FLAME FAILURE RESET: 2. ALARM FAIL & 3. ALARM SIREN: MUTE BUTTON: This is a combination rest button This is used in conjunction wi
ملخص المحتوى في الصفحة رقم 12
PART 2 - SECTION II - OPERATING INSTRUCTIONS LOCATION OF CONTROLS RL1 MTR12 INSTRUCTIONS FOR USE OF To Adjust the differential:- rt1-(RL1 Rest Time) 0 min LAE ELECTRONIC • Turn on the power supply to the heater. - there is no delay in relay operation. THERMOSTATS. • The Digital Display will show the actual water PF1-(Probe Failure) OFF Raypak uses the MTR12T1RES series temperature. - if the Probe (water sensor) fails, the relay will thermostats which is programmed to operate in • Press the "hy
ملخص المحتوى في الصفحة رقم 13
PART 2 - SECTION II - OPERATING INSTRUCTIONS MODELS WHICH ARE WATER TREATMENT technician can replace the faulty parts at the CONNECTED TO A MICROZONE technician’s risk. Raypak will supply the new For your health and the protection of your pool SYSTEM components, the service technician will pay all equipment it is absolutely essential that your charges and then there may be a refund when If the heater(s) are operated by a Microzone pool water is chemically balanced. the parts have been returned t
ملخص المحتوى في الصفحة رقم 14
PART2 - SECTION II - OPERATING INSTRUCTIONS RECOMMENDED SERVICE • Operate Pressure Relief Valve (if Fitted) operation if needed. PROCEDURES manually to check that the drain is clear and • If necessary, remove Burner Tray and service the valve reseals. It is a Raypak requirement that all Raypak as required. (Refer to Annual Service). supplied equipment is serviced at least • Pool Heater: Remove and test Unitherm • Check over the appliance thoroughly and annually. Governor(s), replace if faulty. r
ملخص المحتوى في الصفحة رقم 15
ملخص المحتوى في الصفحة رقم 16
PART 4 - WARRANTY 5. Where the pool heater is installed outside Raypak installation instructions or relevant RAYPAK WARRANTY the boundaries of a metropolitan area as statutory requirements, causing the need for FOR COMMERCIAL defined by Rheem Australia Pty Ltd or further major dismantling or removal of cupboards, SWIMMING POOL than 25 km from a regional Rheem branch doors or walls, or use of special equipment to office or a Rheem Accredited Service Agent, bring the pool heater to floor level, o
ملخص المحتوى في الصفحة رقم 17
NOTES 18
ملخص المحتوى في الصفحة رقم 18
RHEEM SERVICE 131 031 WWW.RHEEM.COM.AU Manufactured by Raypak Australia 7 Geddes St. Mulgrave Vic 3170 Ph. (03) 9535 3333 Quality Endorsed Fax (03) 9560 4974 Company JAN 2003 P/NO 96209131 Quality System
