ملخص المحتوى في الصفحة رقم 12
Listening To The Radio 1.) Slide the Function selector (RADIO/CD/BUZZ) switch, located on the right side cabinet, to the “RADIO” position. 2.) Slide the Band selector (AM/FM/FM ST.) switch, located on the right side cabinet, to the desired band. 3.) Press the POWER button on the front panel to turn the system ‘ On’ . The Power indicator comes ‘ On ’. 4.) Tune to the desired station by slowly rotating the TUNING control on the right side. PM If you tune to an FM Stereo AL 1 AL 2 station the FM ST
ملخص المحتوى في الصفحة رقم 13
Hints For Better Reception FM – The FM lead wire antenna on the back panel should be extended to its full length. You may also have to vary the direction of this antenna until you find the position that provides the best reception. AM – The AM ferrite bar antenna is inside the cabinet. If the AM reception is unsatisfactory try rotating the entire cabinet slightly until the internal antenna picks up the strongest signal. 12 CKD2300_060305.p65 12 3/6/2005, 11:04
ملخص المحتوى في الصفحة رقم 14
Playing Compact Discs Note: Although this CD player can read CD-R and CD-RW discs, in addition to normal CDs, the playability of CD-R/RW discs may be affected by the type of software that was used to create the discs, as well as the quality and condition of the blank media you are using. 100% playability cannot be guaranteed. This is not an indication of a problem with the player. 1.) Slide the Function (RADIO/CD/BUZZ) selector switch on the right side cabinet to the CD position. 2.) Press the P
ملخص المحتوى في الصفحة رقم 15
5.) The disc will spin for a few seconds as the player reads the disc. Then the disc will stop and the display will show the total number of tracks on the disc. After 5 seconds the display returns to the correct time. PM PM AL 1 AL 1 AL 2 AL 2 6.) Press the PLAY/PAUSE button on the front panel to begin playback on track 01. Track number “01” appears in the display. After 5 seconds the display returns to the correct time. PM PM AL 1 AL 1 AL 2 AL 2 7.) Adjust the VOLUME control to the desired leve
ملخص المحتوى في الصفحة رقم 16
/ Skip/Search Controls During playback press the SKIP/SEARCH FWD or SKIP/SEARCH REV buttons on the front panel repeatedly to skip forward or back to higher or lower numbered tracks. Playback will start at the beginning of the selected track. To search within a track for a specific musical passage depress and hold the SKIP/SEARCH FWD or SKIP/SEARCH REV buttons on the front panel. The player will search rapidly forward or backward as long as the buttons are depressed. When you hear the desir
ملخص المحتوى في الصفحة رقم 17
Special Playback Modes Repeat Playback You can program the player to continuously repeat a single track or the entire disc. The Repeat mode can be selected while the disc is playing or while the disc is stopped. Single Track Repeat Select the track to be repeated and then press the REPEAT button on the front panel once. PM The REPEAT indicator begins ‘ flashing’. AL 1 AL 2 If necessary, press the PLAY/PAUSE button to begin playback. The selected track will be repeated continuously. All Tracks Re
ملخص المحتوى في الصفحة رقم 1
AM/FM Stereo Clock Radio
with Dual Alarms
and Compact Disc Player
OWNER'S MANUAL
CKD2300
Visit our web site at www.emersonradio.com
CKD2300_060305.p65 28 3/6/2005, 11:04
ملخص المحتوى في الصفحة رقم 2
CAUTION TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ! The lightning flash with arrow- WARNING: TO REDUCE THE The exclamation point within head symbol, within an equi- an equilateral triangle is in- RISK OF ELECTRIC SHOCK lateral triangle is inten
ملخص المحتوى في الصفحة رقم 3
Thank you… … … … … … … for purchasing this Emerson Dual Alarm Stereo Clock Radio with CD Player. This compact sized unit has been designed to fit comfortably on any desk or bedside table. The CD Player has a 20-track programmable memory plus one-track/all tracks automatic repeat playback. The clock radio features a bright, easily readable, 0.6” red LED display that is visible from anywhere in the room. The dual alarms can be set and used independently. You can set either or both alarms to wake y
ملخص المحتوى في الصفحة رقم 4
IMPORTANT NOTES • Avoid installing this unit in places • Operate controls and switches as exposed to direct sunlight or close to described in the manual. heat radiating appliances such as • Before turning ‘On’ the power, make electric heaters, on top of other stereo certain that the power cord is properly equipment that radiates too much installed. When moving the set, be heat, places lacking ventilation or sure to first disconnect the power cord. dusty areas, places subject to constant • Store
ملخص المحتوى في الصفحة رقم 5
PREPARATION FOR USE Unpacking and Set Up • Carefully remove the unit from the display carton. Remove all the packing material from the unit and remove any small strips of tape that may have been used to prevent the CD door from opening in transit. • Unwind the AC power cord and extend it to its full length. • Unwind the FM antenna wire and extend it to its full length. • This unit was shipped with a dummy CD transit card in the CD player. This dummy CD prevents the laser pick up from moving
ملخص المحتوى في الصفحة رقم 18
Random Playback The Random playback feature allows you to play all the tracks on a disc in random order. 1.) Load your disc in the player as usual and wait until the total tracks appear on the display. PM AL 1 2.) Press the RANDOM button on the front panel. AL 2 The RANDOM indicator comes ‘ On ’. 3.) Press the PLAY/PAUSE button to begin Random playback. The player will select one of the tracks at Random and begin playback on that track. After all tracks have been played in random order the playe
ملخص المحتوى في الصفحة رقم 19
Programmed Playback Use the Programmed Playback feature to play up to 20 tracks on a disc in any desired order. You may also program a particular track to play several times within a programmed sequence if desired. Note: You cannot program a disc while it is playing. Press the STOP button to stop playback and then follow the programming steps below. PM 1.) Load your disc as usual and wait until the display shows the total number of tracks on the disc. AL 1 AL 2 2.) Press the PROGRAM button on th
ملخص المحتوى في الصفحة رقم 20
5.) When you have completed programming the desired tracks press the PLAY/ PAUSE button to begin programmed playback. The PROGRAM indicator stops flashing and remains ‘ On ’. PM PM AL 1 AL 1 AL 2 AL 2 Playback will begin on the first track you programmed and will continue until the last programmed track has played. 6.) When the program is completed the player stops, however the program sequence remains in the memory. To repeat the program sequence, press the PLAY/PAUSE button again. To cancel th
ملخص المحتوى في الصفحة رقم 6
2.) Connect a fresh 9-Volt alkaline battery to the battery terminal in the battery compartment. It can only be connected one way. 3.) Replace the battery door. If the power is interrupted the display will go ‘ Off’ and the radio will not work. However the battery will maintain the clock and alarm settings in memory. When the power is restored the display will come on again and the clock and alarm settings will be correct. The life of the back up battery will depend on the frequency and length of
ملخص المحتوى في الصفحة رقم 7
Power Source This radio is designed to operate on 120V 60Hz AC only. Attempting to operate this radio on any other power source could cause damage to the unit and such damage is not covered by your warranty. Make sure the radio is connected to an AC outlet that is always “live”. Do not connect the radio to an outlet that is controlled by a wall switch. Note: The system has polarized AC plug with one wide blade and one narrow blade. The plug will only fit into matching polarized AC outlets. This
ملخص المحتوى في الصفحة رقم 8
LOCATION OF CONTROLS AND INDICATORS Front Panel 11 10 9 12 8 7 13 21 22 23 24 25 26 14 6 5 15 4 16 3 17 18 2 19 1 1 20 1.) Speakers. 14.) SLEEP Button. 2.) POWER ‘ On/Off’ Button. 15.) CD DISPLAY Button. 3.) STOP Button. 16.) PROGRAM Button. 4.) PLAY/PAUSE Button. 17.) CLOCK SET Button. 5.) REPEAT Button. 18.) SKIP/SEARCH-HOUR Button. 6.) RANDOM Button. 19.) SKIP/SEARCH-MIN. Button. 7.) AL 1 ‘ On’ Indicator. 20.) Tuning Dial pointer. 8.) PM Indicator. 21.) SLEEP Indicator. 9.)
ملخص المحتوى في الصفحة رقم 9
Left Side Panel Right Side Panel 30 29 31 28 32 27 35 33 34 27.) VOL. (Volume) Control. 28.) ALARM 2 (SET-ON-OFF) Selector Switch. 29.) ALARM 1 (SET-ON-OFF) Selector Switch. 30.) BUZZ-CD-RADIO Selector Switch. 31.) FM ST.-FM-AM Selector Switch. 32.) TUNING Control. 33.) AC Power Cord. 34.) Back Up Battery Compartment (Bottom Cabinet). 35.) FM Wire Antenna. 8 CKD2300_060305.p65 8 3/6/2005, 11:04
ملخص المحتوى في الصفحة رقم 10
OPERATING INSTRUCTIONS •Make sure you have installed the back-up battery in the battery compartment. •Make sure you have extended the AC power cord and the FM antenna wire to their full lengths. •Connect the AC power cord plug to a 120V 60Hz AC outlet. Setting The Clock When the radio is connected to the AC outlet for the first time “12:00” (AM) will flash in the display. PM AL 1 AL 2 1.) First depress and hold the CLOCK SET button and then press the SKIP/ SEARCH / HOUR button to set the
ملخص المحتوى في الصفحة رقم 11
Setting The Wake-Up Times The procedure for setting the Alarm 1 and Alarm 2 wake up times is the same. 1.) Slide the ALARM 1 switch, located on the left side of the cabinet to the “SET” position. ALARM 1 The display changes from the correct time to PM the Alarm 1 wake-up time. The first time you AL 1 AL 2 set the Alarm 1 or Alarm 2 wake-up time the display will flash “12:00” (AM). 2.) Press the SKIP/ SEARCH / HOUR button to set the display to the desired Alarm 1 wake-up hour, AM or PM. If the P
