Human Touch ht-5020 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

November 22, 2010
REPLACING THE RECLINE ACTUATOR
HT-5020
®
It is imperative that Human Touch products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair SERVICE LEVEL: 3
instructions. Failure to adhere to these instructions voids the product warran

ملخص المحتوى في الصفحة رقم 2

7. Using a Phillips-head screwdriver, remove the two screws from the bracket that secures the actuator shaft (Fig.4). 8. Using a 6-mm Allen wrench, remove the two Allen bolts that secure the white sensor housing to the calf massager deployment mechanism (Fig.5). 9. Using a small flat-head screwdriver, remove the “C” clip from the hinge pin that secures the actuator to the chair frame (Fig.6). 10. Remove the hinge pin, then remove the actuator from the chair (Fig.7). Actuator shaft White senso

ملخص المحتوى في الصفحة رقم 3

INSTALLING THE NEW RECLINE ACTUATOR 1. Place the new actuator into position, then install the hinge pin to hold it in place. 2. Replace the “C” clip to secure the hinge pin. 3. Replace the two Allen bolts to secure the sensor housing to the calf massager deployment mechanism. 4. Place the bracket that secures the actuator shaft into position, with the actuator threaded through it, then secure it using two screws. 5. Connect the actuator connectors to the corresponding connectors on the chair.