Human Touch HT-270 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

06/01/08

REPLACING THE BACKREST COVER
HT-270
®
To ensure that Human Touch products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
SERVICE LEVEL: 2
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
Tools Required: 5/32" " " (4mm) (4mm) (4mm) (4mm) A A A Allen llen llen llen key key key key, , P Phillips-head hillips-head scr screw ewd

ملخص المحتوى في الصفحة رقم 2

INSTALLING THE NEW BACKREST COVER 1. Place the new backrest cover on the floor behind the chair, as shown (Fig.4). 2. Connect the three sets of connectors. 3. Thread the remote control cables from the backrest through the backrest cover, so that they are accessible after the backrest cover is installed. 4. Place the backrest cover into position, aligning the four screw holes. 5. Using the 5/32" " " (4mm) (4mm) Allen key, replace the four backrest screws. NOTE: Be sure to use the two long