Grizzly G0509G دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSPECTION RECORD
of Model G0509G
Precision Lathe
TJ9037

ملخص المحتوى في الصفحة رقم 2

Typical Typical Diagram of Measuring No. Allowed Tolerances Measured Measured Method Value (mm) Value (inch) G1 a. Alignment of longitudinal bed slide 0.018mm 0.0007" ways in vertical plane: 0.04mm (0.0015") b. Parallelism of transverse direction: 0.03mm 0.0012" 0.04mm (0.0015") in 1000mm (39.370") G2 Parallelism of tailstock to longitudinal motion carriage: a. In vertical plane 0.02mm in 500 mm 0.01mm 0.0004" b. In horizontal plane 0.02mm (

ملخص المحتوى في الصفحة رقم 3

Typical Typical Diagram of Measuring No. Allowed Tolerances Measured Measured Method Value (mm) Value (inch) G8 Parallelism of center line of tailstock spindle to longitudinal motion of carriage: a. In vertical plane: 0.02mm (0.0007") in 0.007mm 0.00027" 100mm (3.937") b. In horizontal plane: 0.015mm (0.0006") 0.005mm 0.0002" in 100mm G9 Parallelism of center line of tailstock spindle hole to longitudinal motion of carriage: a. In vertical plane: 0.03mm (0.001") in 0

ملخص المحتوى في الصفحة رقم 4

Typical Typical Diagram of Measuring No. Allowed Tolerances Measured Measured Method Value (mm) Value (inch) G15 Lead screw cam action 0.01mm 0.0003" 0.015mm (0.0006") P1 Accuracy of outside round cutting: a. Roundness: 0.005mm 0.003mm 0.0001" b. Cylindricity: 0.02mm (0.0007") in 0.01mm 0.0003" 200mm (7.874") P2 Flatness of face for finishing cutting: 0.015mm 0.0005" 0.025mm (0.001") on the diameter of 300mm (11.811") P3 Accuracy of pitch of leadscre