FMI REPLACEMENT LOG SET BTB18 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

REPLACEMENT LOG SET
INSTALLATION INSTRUCTIONS
FOR BTB18, BTB24, PDG18 AND PDG24 GAS LOG HEATERS
3. Place new log set assembly over chassis and align holes on
WARNING: If log set has been in use, make sure
bracket with holes on chassis (see Figure 2).
control knob is in the OFF position, unit is cold and
4. Replace six screws removed in step 1.
gas has been turned off.
Part No. Description Qty.
111835-01

ملخص المحتوى في الصفحة رقم 2

5. 18'' Models Only: T o assemble nex flex line, insert flex tube into Checking Gas Connections end of compression nut with small opening. Place sleeve over end of flex tube and into compression nut. Repeat for other end. WARNING: Test all gas piping and connections, in- Attach new flexible gas line to valve and burner routed through grate as shown in Figure 3. It is very important that you route ternal and external to unit, for leaks after installing or the