ملخص المحتوى في الصفحة رقم 1
Installation Instructions
Warming Drawer
Models: EWD24, EWD27, EWD30, EWD36,
IWD24, IWD27, IWD30, MWDV27,
MWDH27, MWDV30, MWDH30,
MRWD27, MRWD30, PWD27, PWD30
Part No. 102345 Rev. D
ملخص المحتوى في الصفحة رقم 2
® All specifications are subject to change without notice. Dacor assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved.
ملخص المحتوى في الصفحة رقم 3
Table of Contents Before You Begin... ........................................................... 1 Installation Instructions .................................................... 7 Important Safety Instructions .......................................... 1 Remove the Drawer ........................................................ 7 General Safety Precautions ............................................. 2 Installing the Chassis ....................................................... 7 Installati
ملخص المحتوى في الصفحة رقم 4
Important Safety Instructions General Safety Precautions To reduce risk of fire, electric shock, serious injury or death when using your appliance, follow basic precautions, including the following: WARNING WARNING • Read this manual completely before using this • Exercise caution when opening the warming drawer. appliance. Let hot air or steam escape before looking or reaching into the warming drawer. • Use this appliance only for its intended use as • Use only dry pot holders when re
ملخص المحتوى في الصفحة رقم 5
Installation Specifications B Verifying the Package Contents • Use and Care manual • Mounting screws Installation Planning D A qualified technician must complete the installation of this Chassis built-in appliance. Proper installation is your responsibility. Carefully check the location where the drawer is to be installed. The drawer should be placed for convenient access. Make certain that electrical power can be provided in the selected location. Plan the installation so that all minimu
ملخص المحتوى في الصفحة رقم 6
Installation Specifications “A” Drawer Face “B” Chassis Face “C” Chassis Width Model Width Width EWD24 24” (610 mm) 23 5/8” (600 mm) 22 1/8” (562 mm) 10 1/8" (257 mm) EWD27 MWDH27 MWDV27 27” (686 mm) 26 5/8” (676mm) 25 1/8” (638 mm) MRWD27 PWD27 A EWD30 MWDH30 MWDV30 30” (762 mm) 29 5/8” (752 mm) 28 1/8” (714 mm) EW EWO PWO MWO PW MW MRWD30 Drawer Face Dimensions 3 5/16" 2 3/16" 1 5/16" 3 7/16" 3 1/4" 2 1/4" (84mm) (56mm) (33mm) (MW Series Shown) PWD30 (87mm) (83mm) (57mm) EWD36 36” (914 mm) 3
ملخص المحتوى في الصفحة رقم 7
Installation Specifications 3/4" Min.* (19 mm) Warming Drawer C 36" Typ. D 120 Vac (914 mm) 27"/30"/36" electrical Warming Drawer C Dacor receptacle single oven 5/8" Min.* D (16 mm) Warming Drawer C 120 Vac A Elect. B D 1 1/2" (38 mm) Cooktop Typical counter top Warming Drawer 120 Vac C Elect. 3/4” Min.* (19 mm) Warming Drawer C Toe Kick 5/8" Min.* A (16 mm) 36" Typ. 120 Vac (914 mm) electrical A receptacle B “B” Min. “D” Min. Width to “A” Cutout “C” Cutout Vertical Gap Model Adjacent Wid
ملخص المحتوى في الصفحة رقم 8
Installation Specifications Install a Support Platform in the Electrical Power Supply Cabinet Requirements • The warming drawer is supplied with a power cord Provide a platform (100 lb. load capacity) within the cabinet terminated by a three-prong plug. Plug it directly into a upon which the warming drawer will be supported. The dedicated, grounded, three prong, electrical outlet. Do platform must be installed level and straight. The top edge not use an extension cord. of the platform mu
ملخص المحتوى في الصفحة رقم 9
Installation Instructions WARNING Installing the Chassis • To avoid personal injury caused by the appliance 1. Grasp the warming drawer chassis on opposite falling forward when the drawer is opened, secure sides and slide it partially into the cabinet opening. the chassis to the cabinet and support platform as Temporarily support the chassis in place so that it will instructed. not tilt or fall. • Be certain that the power plug is disconnected from 2. From an adjoining cabinet, reach i
ملخص المحتوى في الصفحة رقم 10
Installation Instructions Verifying the Warming Drawer Re-installing the Drawer 1. Pull the drawer slides all the way out of the drawer Operation opening. 1. Connect power plug to the electrical outlet. 2. Gently lower the drawer between the extended slides 2. Operate the warming drawer as outlined in the use and until it is suspended by them. care manual that accompanied this product. 3. Slide the back of the drawer mounting brackets under the drawer mounting clips on the slides. Installat
ملخص المحتوى في الصفحة رقم 11
ملخص المحتوى في الصفحة رقم 12
Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com
